129 research outputs found
The Development of German Army Airplanes During the War
The author, who was a captain of the Reserves in the Technical Department of the Aviation Division (Board of Airplane Experts) during the war, shows what means were taken for the creation of new airplane types and what tests were employed for trying out their flying properties, capacities and structural reliability. The principal representative types of each of the classes of airplanes are described and the characteristics of the important structural parts are discussed. Data regarding the number of airplanes at the front and the flying efficiency of the various classes of airplanes are given
Lecture on the Rhon soaring flight competition, 1921
This article presents a recounting of the Rhon soaring competition with emphasis on new designs, results, and prizes awarded. A round-robin discussion is also included at the end of the report
Soaring flight and the Rhon contests
Explanation of soaring flight. Static and dynamic soaring flight. Results of the Rhon contest. Description of the most important gliders. Notes on Soaring Flight Contests in France and England
Computative examination of bending strength of girders originally curved and subjected to longitudinal compression
This report examines the stipulation contained in the 1918 BLV, that a girder subjected to longitudinal compression under the influence of half of the specified breaking load, along with Euler bending safety with an initial deflection of 1/200 of the length of the girder can, at most, be subjected to half the stipulated breaking strength
Contribution to the ideal efficiency of screw propellers
The stipulation of best thrust distribution is applied to the annular elements of the screw propeller with infinitely many blades in frictionless, incompressible flow and an ideal jet propulsion system derived possessing hyperbolic angular velocity distribution along the blade radius and combining the advantage of uniform thrust distribution over the section with minimum slipstream and rotation losses. This system is then compared with a propeller possessing the same angular velocity at all blade elements and the best possible thrust distribution secured by means of an induced efficiency varying uniformly over the radius. Lastly, the case of the lightly loaded propeller also is discussed
Analysis of Stresses in German Airplanes
This report contains an account of the origin of the views and fundamental principles underlying the construction of German airplanes during the war. The report contains a detailed discussion of the aerodynamic principles and their use in determining the strength of airplanes, the analysis of the strength qualities of materials and in the construction, the calculated strength of air flows and a description of tests made in determining the strength of airplanes
Aerosol growth in CO2 absorption with MEA, modelling and comparison with experimental results
A new and improved aerosol model has been developed and tested against experimental data. An e-NRTL equilibrium model for MEA was extended to cover sulphuric acid containing droplets and validated against new eboulliometer data in this work. The droplet model predicts emissions without demister installed in the absorber, within ± 20% and with demister, 30-80% of the measured emissions. The model predicts well the change in emissions from NG-based to coal-based exhaust. Under conditions reported in this work, the droplet number concentration was found to have a small effect on predicted emissions because of more MEA gas-phase depletion with high droplet concentrations and slower growth. The effects counteract each other. With significant MEA depletion in the gas phase, the emissions are largely determined by the mass transfer rate from the bulk liquid. The initial droplet sulphuric acid concentration had a minor effect on the outlet droplet size distribution. The effect on MEA emissions was significant: the emissions went up with increased initial sulphuric acid concentration. The effect of sulphuric acid was stronger for low inlet gas CO2 concentration (NG) than for coal-based exhaust. The increase in emissions is believed to be caused by the increase in overall driving force for MEA between bulk liquid phase and droplets. The log-normal model does not catch small inlet droplet sizes in the range below 20-30nm. These droplet sizes hardly grow in the absorber and water wash and in the total emissions, these droplets have a negligible impact on emissions.publishedVersio
Amplification efficiency: linking baseline and bias in the analysis of quantitative PCR data
Despite the central role of quantitative PCR (qPCR) in the quantification of mRNA transcripts, most analyses of qPCR data are still delegated to the software that comes with the qPCR apparatus. This is especially true for the handling of the fluorescence baseline. This article shows that baseline estimation errors are directly reflected in the observed PCR efficiency values and are thus propagated exponentially in the estimated starting concentrations as well as ‘fold-difference’ results. Because of the unknown origin and kinetics of the baseline fluorescence, the fluorescence values monitored in the initial cycles of the PCR reaction cannot be used to estimate a useful baseline value. An algorithm that estimates the baseline by reconstructing the log-linear phase downward from the early plateau phase of the PCR reaction was developed and shown to lead to very reproducible PCR efficiency values. PCR efficiency values were determined per sample by fitting a regression line to a subset of data points in the log-linear phase. The variability, as well as the bias, in qPCR results was significantly reduced when the mean of these PCR efficiencies per amplicon was used in the calculation of an estimate of the starting concentration per sample
- …