Wind-tunnel tests of wide-chord teetering rotors with and without outboard flapping hinges

Wind tunnel tests of aeroelastically designed helicopter rotor models were conducted to obtain rotor aerodynamic performance and dynamic response data pertaining to two-bladed teetering rotors with a wider chord and lower hover tip speed than currently employed on production helicopters. The effects of a flapping hinge at 62 percent radius were also studied. Finally, the effects of changing tip mass on operating characteristics of the rotor with the outboard flapping hinge were examined. The models were tested at several shaft angles of attack for five advance ratios, 0.15, 0.25, 0.35, 0.40, and 0.45. For each combination of shaft angle and advance ratio, the rotor lift was varied over a wide range to include simulated maneuver conditions. At each test condition, rotor aerodynamic performance and dynamic response data were obtained. From these tests, it was found that wide-chord rotors may be subject to large control forces. An outboard flapping hinge may be used to reduce beamwise bending moments over a significant part of the blade radius without significantly affecting the chordwise bending moments

An improved computational procedure for determining helicopter rotor blade natural modes

An existing computer program, used for predicting the natural frequencies and mode shapes of helicopter rotor blades, was refined to improve program accuracy and versatility. The program is based on the Holzer-Myklestad approach adapted for rotating beams. Coupled vertical (out-of-plane), horizontal (in-plane), and torsional mode characteristics were determined for a variety of hub and blade configurations. The resulting program is documented by presenting the recursion equations and techniques for determining natural frequencies and mode shapes, input data requirements, and descriptions of various program outputs. The accuracy of the program is demonstrated by comparing computed results with exact solutions to classical problems and experimental data

Correlating measured and predicted inplane stability characteristics for an advanced bearingless rotor

The experimental data were obtained from hover tests for a scaled model of an advanced bearingless main rotor. Both isolated rotor and ground resonance conditions were tested. Test parameters included blade built-in cone and sweep angles, rotor inplane structural damping, pitch link location and fuselage structural damping. Analytical results for the conditions tested were obtained using current Bell Helicopter analyses. In addition, variations in the analytical models were made to assess their impact on the correlation between computed and measured results. Results are presented in tabular and graphical form

Experimental investigation of effects of blade tip geometry on loads and performance for an articulated rotor system

Wind-tunnel tests of an aeroelastically designed helicopter rotor model were carried out to determine the effects on dynamic response and aerodynamic performance of varying the design of the outboard 8 percent of the blade lengths. Four different blade tip geometries or shapes having different amounts of planform sweep, thickness and chordwise taper, and anhedral angle were studied. Each configuration was tested at several shaft angles of attack for advance ratios of 0.20, 0.30, 0.35, and 0.40. For each combination of shaft angle and advance ratio, rotor lift was varied over a wide range to include high lift conditions

Comparison of aerodynamic data measured in air and Freon-12 wind-tunnel test mediums

An experimental investigation was carried out to measure two dimensional static aerodynamic characteristics of a 65 sub l-213 airfoil in air and Freon-12 (dichlorodifluoromethane) test mediums at corresponding test conditions. The purpose of the tests was to compare measurements in the two test mediums and to evaluate reported methods of converting Freon-12 data to equivalent air values. The test article was a two dimensional wing instrumented to measure chordwise surface pressure distributions. The parameters considered were Mach numbers from 0.6 to 1.0, angles of attack of zero deg and 1 deg, and Reynolds numbers based on model chord from 2,000,000 to 21,000,000. The agreement between data measured in the two test mediums is further improved by application of the transonic or area ratio similarity laws. Where flow conditions are characterized by surface shocks or stall, the effects of flow separation may not be identically reflected in the Freon-12 data, even when converted in accordance with existing similarity laws

Correlation and evaluation of inplane stability characteristics for an advanced bearingless main rotor

A program of experimental and analytical research was performed to demonstrate the degree of correlation achieved between measured and computed rotor inplane stability characteristics. The experimental data were obtained from hover and wind tunnel tests of a scaled bearingless main rotor model. Both isolated rotor and free-hub conditions were tested. Test parameters included blade built-in cone and sweep angles; rotor inplane structural stiffness and damping; pitch link stiffness and location; and fuselage damping, inertia, and natural frequency. Analytical results for many test conditions were obtained. In addition, the analytical and experimental results were examined to ascertain the effects of the test parameters on rotor ground and air resonance stability. The results from this program are presented herein in tabular and graphical form

Solvent effects on the magnetic-field-dependent reaction yields of photogenerated radical ion pairs.

A pronounced solvent viscosity and polarity dependence of the magnetic field effect was found for polymethylene-linked radical ion pairs generated by photoinduced intramolecular electron transfer in compounds of the type pyrene-(CH2)n-N,N-dimethylaniline, with n = 7–16. This is interpreted in terms of the general radical pair mechanism, i.e. the nuclear hyperfine interaction mechanism including a spin-exchange interaction, modulated by the stochastic folding motion of the linking CH2 chain which leads to a “motional deformation” of the reaction yield spectra

Pattern of skin disease in Ethiopian HIV‐infected patients on combination antiretroviral therapy: A cross‐sectional study in a dermatology referral hospital

Abstract Background More than 90% of human immunodeficiency virus (HIV)‐infected patients will develop at least one type of skin disorder during the course of the disease. The prevalence and severity of skin disease commonly seen in HIV‐infected patients has decreased in the era of combination antiretroviral therapy (cART). Few studies in Ethiopia have shown the magnitude of skin problems among adult patients on cART. The aim of this study is to describe the pattern of skin disease among adult patients who are on cART. Methods Cross‐sectional observational study at ALERT Hospital from April 2018 to November 2018. Patterns of clinically diagnosed skin diseases were summarized descriptively. Result A total of 572 patients were evaluated. In total, 412 (72%) were female and the mean age of study participants was 40 (SD = 10.4). The median CD4 count at the time of diagnosis and start of cART were 178 (R 5‐2000) and 168 cells/μl (R 5‐1327), respectively. The mean duration of cART was 8 (SD = 3) years. 89.3% of patients were on first line and 7% on second line of cART regimen. Noninfectious inflammatory skin disorders (40.9%) were the most common concomitant diagnosis followed by infectious diseases (34.9%), infestation (7.7%), pigmentary disorders (6.3%) and cutaneous drug eruption (0.7%), respectively. Among the inflammatory skin disorders, 56.5% presented with eczema. One patient had Kaposi sarcoma. Conclusion Noninfectious inflammatory skin disorders are the most common concomitant skin disease in HIV‐infected patients, with eczema being most prevalent. Infectious skin diseases were also common presentations. In our study, AIDS‐defining skin conditions were rare

Deuteron Compton Scattering in Effective Field Theory: Spin-Dependent Cross Sections and Asymmetries

Polarized Compton scattering on the deuteron is studied in nuclear effective field theory. A set of tensor structures is introduced to define 12 independent Compton amplitudes. The scalar and vector amplitudes are calculated up to ${\cal O}((Q/\Lambda)^2)$ in low-energy power counting. Significant contribution to the vector amplitudes is found to come from the spin-orbit type of relativistic corrections. A double-helicity dependent cross section $\Delta_1 \sigma = (\sigma_{+1-1}-\sigma_{+1+1})/2$ is calculated to the same order, and the effect of the nucleon isoscalar spin-dependent polarizabilities is found to be smaller than the effect of isoscalar spin-independent ones. Contributions of spin-independent polarizabilities are investigated in various asymmetries, one of which has as large as 12 (26) percent effect at the center-of-mass photon energy 30 (50) MeV.Comment: 22 pages, 8 figures included, replaced with the version submitted to PR