Pre-emphasis determination for an S-band constant bandwidth FM/FM station

Telemetry bands are being reassigned to UHF at 1500 and 2200 MHz. Conversion primarily requires changes in equipment used in RF link, while many of same subcarrier oscillators, mixer amplifiers, and frequency discriminators can be used

Investigation of new radar-data-reduction techniques used to determine drag characteristics of a free-flight vehicle

An investigation was conducted of new techniques used to determine the complete transonic drag characteristics of a series of free-flight drop-test models using principally radar tracking data. The full capabilities of the radar tracking and meteorological measurement systems were utilized. In addition, preflight trajectory design, exact kinematic equations, and visual-analytical filtering procedures were employed. The results of this study were compared with the results obtained from analysis of the onboard, accelerometer and pressure sensor data of the only drop-test model that was instrumented. The accelerometer-pressure drag curve was approximated by the radar-data drag curve. However, a small amplitude oscillation on the latter curve precluded a precise definition of its drag rise

Post-flight analyses of the crystals from the M0003-14 quartz crystal microbalance experiment

Quartz Crystal Microbalances constructed by QCM Research were flown on the leading and trailing edges of LDEF as one of the sub-experiments of M0003. Response of the crystals coated with 150 A of In2O3 was recorded during the first 424 days of the mission. A second QCM with crystals coated with 150 A of ZnS was also flown but not monitored. After the flight, the QCM's were disassembled and analyzed in The Aerospace Corporation laboratories. The samples included the crystals from the leading and trailing edge samples of both types of coatings along with the reference crystals, which were inside the QCM housing. Analyses were performed by scanning electron microscopy, energy dispersive x-ray analyses, x-ray photoelectron spectroscopy, ion microprobe mass analysis, and reflectance spectroscopy in the infrared and UV/visible regions. The crystals are contaminated predominantly with silicone compounds. The contamination is higher on the leading edge than on the trailing edge and higher on the exposed crystals than on the reference crystals

Duties of Members, Directors, and Managers of Cooperative Associations

Exact date of bulletin unknown.PDF pages: 1

Pseudo-noise test set for communication system evaluation

A test set for communications systems is described which includes a pseudo noise sequence generator providing a test signal that is fed to a pair of signal channels. The first channel includes a spectrum shaping filter and a conditioning amplifier. The second channel includes a variable delay circuit, a spectrum shaping filter matched to the first filter, and an amplifier. The output of the first channel was applied to the system under test. The output of the system and the output of the second channel are compared to determine the degree of distortion suffered by the test signal due to the communications system

Method of and means for testing a tape record/playback system

A tape record/playback system was tested by first deriving an analog test signal and a band-limited digital reference signal from a pseudo-noise sequence generator driven by a clock signal. It recorded the signals on respective tracks of the system during operation in a record mode. During the playback mode of operation of the system, a delayed analog reference signal without time base variations was reconstructed from the played back reference signal. It was compared with the played back test signal in order to obtain an error signal that was a measure of the performance of the system

Adiabatic and Non-Adiabatic Contributions to the Free Energy from the Electron-Phonon Interaction for Na, K, Al, and Pb

We calculate the adiabatic contributions to the free energy due to the electron--phonon interaction at intermediate temperatures, $0 \leqslant k_{B} T < \epsilon_{F}$ for the elemental metals Na, K, Al, and Pb. Using our previously published results for the nonadiabatic contributions we show that the adiabatic contribution, which is proportional to $T^{2}$ at low temperatures and goes as $T^{3}$ at high temperatures, dominates the nonadiabatic contribution for temperatures above a cross--over temperature, $T_{c}$, which is between 0.5 and 0.8 $T_{m}$, where $T_{m}$ is the melting temperature of the metal. The nonadiabatic contribution falls as $T^{-1}$ for temperatures roughly above the average phonon frequency.Comment: Updated versio

A first direct measurement of the intergalactic medium temperature around a quasar at z=6

The thermal state of the intergalactic medium (IGM) provides an indirect probe of both the HI and HeII reionisation epochs. Current constraints on the IGM temperature from the Lya forest are restricted to the redshift range 2<z<4.5, limiting the ability to probe the thermal memory of HI reionisation toward higher redshift. In this work, we present the first direct measurement of the IGM temperature around a z=6 quasar by analysing the Doppler widths of Lya absorption lines in the proximity zone of SDSS J0818+1722. We use a high resolution (R= 40000) Keck/HIRES spectrum in combination with detailed numerical modelling to obtain the temperature at mean density, T_0=23600\pm^5000_6900K (\pm^9200_9300K) at 68 (95) per cent confidence assuming a prior probability 13500K<T_0<38500 K following HI and HeII reionisation. This enables us to place an upper limit on the redshift of HI reionisation, z_H, within 33 comoving Mpc of SDSS J0818+1722. If the quasar reionises the HeII in its vicinity, then in the limit of instantaneous reionisation we infer z_H<9.0 (11.0) at 68 (95) per cent confidence assuming photoheating is the dominant heat source and that HI reionisation is driven by ionising sources with soft spectra, typical of population II stars. If the HI and HeII in the IGM around SDSS J0818+1722 are instead reionised simultaneously by a population of massive metal-free stars, characterised by very hard ionising spectra, we obtain a tighter upper limit of z_H<8.4 (9.4). Initiating reionisation at higher redshifts produces temperatures which are too low with respect to our constraint unless the HI ionising sources or the quasar itself have spectra significantly harder than typically assumed.Comment: 15 pages, 9 figures, accepted to MNRA

End-to-end RMS error testing on a constant bandwidth FM/FM system

End-to-end root-mean-square (rms) tests performed on a constant bandwidth FM/FM system with various settings of system parameters are reported. The testing technique employed is that of sampling, digitizing, delaying, and comparing the analog input against the sampled and digitized corresponding output. Total system error is determined by fully loading all channels with band-limited noise and conducting end-to-end rms error tests on one channel. Tests are also conducted with and without a transmission link and plots of rms errors versus receiver signal-to-noise (S/N) values are obtained. The combined effects of intermodulation, adjacent channel crosstalk, and residual system noise are determined as well as the single channel distortion of the system