Improved transient simulation of salient-pole synchronous generators with internal and ground faults in the stator winding

An improved model for simulating the transient behavior of salient-pole synchronous generators with internal and ground faults in the stator winding is established using the multi-loop circuit method. The model caters for faults under different ground conditions for the neutral, and accounts for the distributed capacitances of the windings to ground. Predictions from the model are validated by experiments, and it is shown that the model accurately predicts the voltage and current waveforms under fault conditions. Hence, it can be used to analyze important features of faults and to design appropriate protection schemes

Botanical composition, production and nutrient status of an originally Lolium perenne-dominant cut grass sward receiving long-term manure applications

Effects of long-term applications (50, 100 and 200 m(3) ha(-1)y(-1)) of pig and cow slurries on yield, botanical composition and nutrient content of herbage of an original perennial ryegrass sward were assessed in a three-cut silage system and compared with unamended and fertilized controls in the 36th year of the experiment. Cow slurry at 50 m(3) ha(-1) produced similar annual herbage DM yield to 200 kg ha(-1) fertilizer N in 2006, whereas about 100 m(3) ha(-1) pig slurry were required to produce a similar amount of DM. The highest slurry application rate significantly influenced sward botanical composition without depressing DM yield. The principal invading species were creeping bent and meadow grasses (similar to findings at a previous assessment in 1981) except in the unamended control (which were common bent and Yorkshire fog). Perennial ryegrass remained a main species in plots receiving fertilizer (31 % annual DM yield) and low slurry rates (38 %) but declined to 3 % annual DM yield at the highest slurry rate where the ability of ryegrass to utilize slurry N and P may have been affected by chemically or physically induced deficiencies of other nutrients (e.g. Ca) or direct physical effects such as smothering

Trombe walls with nanoporous aerogel insulation applied to UK housing refurbishments

There is an opportunity to improve the efficiency of passive Trombe walls and active solar air collectors by replacing their conventional glass covers with lightweight polycarbonate panels filled with nanoporous aerogel insulation. This study investigates the thermal performance, energy savings, and financial payback period of passive Aerogel Trombe walls applied to the existing UK housing stock. Using parametric modeling, a series of design guidance tables have been generated, providing estimates of the energy savings and overheating risk associated with applying areas of Trombe wall to four different house types across the UK built to six notional construction standards. Calculated energy savings range from 183 kWh/m2/year for an 8 m2 system retrofitted to a solid walled detached house to 62 kWh/m2/year for a 32 m2 system retrofitted to a super insulated flat. Predicted energy savings from Trombe walls up to 24 m2 are found to exceed the energy savings from external insulation across all house types and constructions. Small areas of Trombe wall can provide a useful energy contribution without creating a significant overheating risk. If larger areas are to be installed, then detailed calculations would be recommended to assess and mitigate potential overheating issues.The EPSRC, Brunel University, and Buro Happold Lt

Low-impulse blast behaviour of fibre-metal laminates

This paper presents three dimensional (3D) finite element (FE) models of the low-impulse localised blast loading response of fibre-metal laminates (FMLs) based on an 2024-O aluminium alloy and a woven glass-fibre/polypropylene composite (GFPP). A vectorized user material subroutine (VUMAT) is developed to define the mechanical constitutive behaviour and Hashin’s 3D failure criteria incorporating strain-rate effects in the GFPP. In order to apply localised blast loading, a user subroutine VDLOAD is used to model the pressure distribution over the exposed area of the plate. These subroutines are implemented into the commercial finite element code ABAQUS/Explicit to model the deformation and failure mechanisms in FMLs. The FE models consider FMLs based on various stacking configurations. Both the transient and permanent displacements of the laminates are investigated. Good correlation is obtained between the measured experimental and numerical displacements, the panel deformations and failure modes. By using the validated models, parametric studies can be carried out to optimise the blast resistance of FMLs based on a range of stacking sequences and layer thicknesses

Supersymmetric Electroweak Corrections to Charged Higgs Boson Production in Association with a Top Quark at Hadron Colliders

We calculate the $O(\alpha_{ew}m_{t(b)}^{2}/m_{W}^{2})$ and $O(\alpha_{ew} m_{t(b)}^4/m_W^4)$ supersymmetric electroweak corrections to the cross section for the charged Higgs boson production in association with a top quark at the Tevatron and the LHC. These corrections arise from the quantum effects which are induced by potentially large Yukawa couplings from the Higgs sector and the chargino-top(bottom)-sbottom(stop) couplings, neutralino-top(bottom)-stop(sbottom) couplings and charged Higgs-stop-sbottom couplings. They can decrease or increase the cross section depending on $\tan\beta$ but are not very sensitive to the mass of the charged Higgs boson for high $\tan\beta$. At low $\tan\beta(=2)$ the corrections decrease the total cross sections significantly, which exceed -12% for $m_{H^{\pm}}$ below $300GeV$ at both the Tevatron and the LHC, but for $m_{H^{\pm}}>300GeV$ the corrections can become very small at the LHC. For high $\tan\beta(=10,30)$ these corrections can decrease or increase the total cross sections, and the magnitude of the corrections are at most a few percent at both the Tevatron and the LHC.Comment: 28 pages including 4 eps figure

Effect of stress level on the high temperature deformation and fracture mechanisms of Ti-45Al-2Nb-2Mn-0.8 vol. pct TiB²: an 'In Situ' experimental study

The effect of the applied stress on the deformation and crack nucleation and propagation mechanisms of a gamma-TiAl intermetallic alloy (Ti-45Al-2Nb-2Mn (at. pct)-0.8 vol. pct TiB2) was examined by means of in situ tensile (constant strain rate) and tensile-creep (constant load) experiments performed at 973 K (700 °C) using a scanning electron microscope. Colony boundary cracking developed during the secondary stage in creep tests at 300 and 400 MPa and during the tertiary stage of the creep tests performed at higher stresses. Colony boundary cracking was also observed in the constant strain rate tensile test. Interlamellar ledges were only found during the tensile-creep tests at high stresses (sigma > 400 MPa) and during the constant strain rate tensile test. Quantitative measurements of the nature of the crack propagation path along secondary cracks and along the primary crack indicated that colony boundaries were preferential sites for crack propagation under all the conditions investigated. The frequency of interlamellar cracking increased with stress, but this fracture mechanism was always of secondary importance. Translamellar cracking was only observed along the primary crack.Funding from the Spanish Ministry of Science and Innovation through projects (MAT2009-14547-C02-01 and MAT2009-14547-C02-02) is acknowledged. The Madrid Regional Government partially supported this project through the ESTRUMAT grant (P2009/MAT-1585). CJB acknowledges the support from the Spanish Ministry of Education for his sabbatical stay in Madrid (SAB2009-0045).Publicad

Weak Boson Production Amplitude Zeros; Equalities of the Helicity Amplitudes

We investigate the radiation amplitude zeros exhibited by many Standard Model amplitudes for triple weak gauge boson production processes. We show that $WZ\gamma$ production amplitudes have especially rich structure in terms of zeros, these amplitudes have zeros originating from several different sources. It is also shown that TYPE I current null zone is the special case of the equality of the specific helicity amplitudes.Comment: 27 pages, 12 figures, 2 table

Observational constraint on dynamical evolution of dark energy

We use the Constitution supernova, the baryon acoustic oscillation, the cosmic microwave background, and the Hubble parameter data to analyze the evolution property of dark energy. We obtain different results when we fit different baryon acoustic oscillation data combined with the Constitution supernova data to the Chevallier-Polarski-Linder model. We find that the difference stems from the different values of $\Omega_{m0}$. We also fit the observational data to the model independent piecewise constant parametrization. Four redshift bins with boundaries at $z=0.22$, 0.53, 0.85 and 1.8 were chosen for the piecewise constant parametrization of the equation of state parameter $w(z)$ of dark energy. We find no significant evidence for evolving $w(z)$. With the addition of the Hubble parameter, the constraint on the equation of state parameter at high redshift isimproved by 70%. The marginalization of the nuisance parameter connected to the supernova distance modulus is discussed.Comment: revtex, 16 pages, 5 figures, V2: published versio

Biomarker-guided sequential targeted therapies to overcome therapy resistance in rapidly evolving highly aggressive mammary tumors

Combinatorial targeted therapies are more effective in treating cancer by blocking by-pass mechanisms or inducing synthetic lethality. However, their clinical application is hampered by resistance and toxicity. To meet this important challenge, we developed and tested a novel concept of biomarker-guided sequential applications of various targeted therapies using ErbB2-overexpressing/PTEN-low, highly aggressive breast cancer as our model. Strikingly, sustained activation of ErbB2 and downstream pathways drives trastuzumab resistance in both PTEN-low/trastuzumab-resistant breast cancers from patients and mammary tumors with intratumoral heterogeneity from genetically-engineered mice. Although lapatinib initially inhibited trastuzumab-resistant mouse tumors, tumors by-passed the inhibition by activating the PI3K/mTOR signaling network as shown by the quantitative protein arrays. Interestingly, activation of the mTOR pathway was also observed in neoadjuvant lapatinib-treated patients manifesting lapatinib resistance. Trastuzumab + lapatinib resistance was effectively overcome by sequential application of a PI3K/mTOR dual kinase inhibitor (BEZ235) with no significant toxicity. However, our p-RTK array analysis demonstrated that BEZ235 treatment led to increased ErbB2 expression and phosphorylation in genetically-engineered mouse tumors and in 3-D, but not 2-D, culture, leading to BEZ235 resistance. Mechanistically, we identified ErbB2 protein stabilization and activation as a novel mechanism of BEZ235 resistance, which was reversed by subsequent treatment with lapatinib + BEZ235 combination. Remarkably, this sequential application of targeted therapies guided by biomarker changes in the tumors rapidly evolving resistance doubled the life-span of mice bearing exceedingly aggressive tumors. This fundamentally novel approach of using targeted therapies in a sequential order can effectively target and reprogram the signaling networks in cancers evolving resistance during treatment. © 2014 IBCB, SIBS, CAS All rights reserved