A Polynomial Description of the Rijndael Advanced Encryption Standard

The paper gives a polynomial description of the Rijndael Advanced Encryption Standard recently adopted by the National Institute of Standards and Technology. Special attention is given to the structure of the S-Box.Comment: 12 pages, LaTe

Hypogeous fungi at tree line in the Australian Alps

The tree line of the continental Australian Alps yielded eighteen species of hypogeous fungi, all probably forming ectomycorrhizae with Eucalyptus niphophila, the tree species characteristic of that habitat. Six of the species were undescribed. These collections represented six families and twelve genera: Boletaceae (with Chamonixia), Gallaceaceae (Gallacea), Hysterangiaceae (Hysterangium), Cortinariaceae (Cortinarius, Dermocybe, Descomyces, Protoglossum, Setchelliogaster), Russulaceae (Cystangium, Gymnomyces, Zelleromyces) and Tricholomataceae (Hydnangium). A key to hypogeous fungi so far found at the Australian Alps tree line is presented

Effects of Elevated H\u3csup\u3e+\u3c/sup\u3e And P\u3csub\u3ei\u3c/sub\u3e on The Contractile Mechanics of Skeletal Muscle Fibres From Young and Old Men: Implications for Muscle Fatigue in Humans

The present study aimed to identify the mechanisms responsible for the loss in muscle power and increased fatigability with ageing by integrating measures of whole‐muscle function with single fibre contractile mechanics. After adjusting for the 22% smaller muscle mass in old (73–89 years, n = 6) compared to young men (20–29 years, n = 6), isometric torque and power output of the knee extensors were, respectively, 38% and 53% lower with age. Fatigability was ∼2.7‐fold greater with age and strongly associated with reductions in the electrically‐evoked contractile properties. To test whether cross‐bridge mechanisms could explain age‐related decrements in knee extensor function, we exposed myofibres (n = 254) from the vastus lateralis to conditions mimicking quiescent muscle and fatiguing levels of acidosis (H+) (pH 6.2) and inorganic phosphate (Pi) (30 mm). The fatigue‐mimicking condition caused marked reductions in force, shortening velocity and power and inhibited the low‐ to high‐force state of the cross‐bridge cycle, confirming findings from non‐human studies that these ions act synergistically to impair cross‐bridge function. Other than severe age‐related atrophy of fast fibres (−55%), contractile function and the depressive effects of the fatigue‐mimicking condition did not differ in fibres from young and old men. The selective loss of fast myosin heavy chain II muscle was strongly associated with the age‐related decrease in isometric torque (r = 0.785) and power (r = 0.861). These data suggest that the age‐related loss in muscle strength and power are primarily determined by the atrophy of fast fibres, but the age‐related increased fatigability cannot be explained by an increased sensitivity of the cross‐bridge to H+ and Pi

Investigation of qq-dependent dynamical heterogeneity in a colloidal gel by x-ray photon correlation spectroscopy

We use time-resolved X-Photon Correlation Spectroscopy to investigate the slow dynamics of colloidal gels made of moderately attractive carbon black particles. We show that the slow dynamics is temporally heterogeneous and quantify its fluctuations by measuring the variance $\chi$ of the instantaneous intensity correlation function. The amplitude of dynamical fluctuations has a non-monotonic dependence on scattering vector $q$, in stark contrast with recent experiments on strongly attractive colloidal gels [Duri and Cipelletti, \textit{Europhys. Lett.} \textbf{76}, 972 (2006)]. We propose a simple scaling argument for the $q$-dependence of fluctuations in glassy systems that rationalizes these findings.Comment: Final version published in PR

Shearing a Glassy Material: Numerical Tests of Nonequilibrium Mode-Coupling Approaches and Experimental Proposals

The predictions of a nonequilibrium schematic mode-coupling theory developed to describe the nonlinear rheology of soft glassy materials have been numerically challenged in a sheared binary Lennard-Jones mixture. The theory gives an excellent description of the stress/temperature `jamming phase diagram' of the system. In the present paper, we focus on the issue of an effective temperature Teff for the slow modes of the fluid, as defined from a generalized fluctuation-dissipation theorem. As predicted theoretically, many different observables are found to lead to the same value of Teff, suggesting several experimental procedures to measure Teff. New, simple experimental protocols to access Teff from a generalized equipartition theorem are also proposed, and one such experiment is numerically performed. These results give strong support to the thermodynamic interpretation of Teff and make it experimentally accessible in a very direct way.Comment: Version accepted for publication - Physical Review Letter

Effect of 17 Days of Bed Rest on Peak Isometric Force and Unloaded Shortening Velocity of Human Soleus Fibers

The purpose of this study was to examine the effect of prolonged bed rest (BR) on the peak isometric force (Po) and unloaded shortening velocity (Vo) of single Ca2+-activated muscle fibers. Soleus muscle biopsies were obtained from eight adult males before and after 17 days of 6° head-down BR. Chemically permeabilized single fiber segments were mounted between a force transducer and position motor, activated with saturating levels of Ca2+, and subjected to slack length steps. Vo was determined by plotting the time for force redevelopment vs. the slack step distance. Gel electrophoresis revealed that 96% of the pre- and 87% of the post-BR fibers studied expressed only the slow type I myosin heavy chain isoform. Fibers with diameter \u3e100 μm made up only 14% of this post-BR type I population compared with 33% of the pre-BR type I population. Consequently, the post-BR type I fibers (n = 147) were, on average, 5% smaller in diameter than the pre-BR type I fibers (n = 218) and produced 13% less absolute Po. BR had no overall effect on Po per fiber cross-sectional area (Po/CSA), even though half of the subjects displayed a decline of 9–12% in Po/CSA after BR. Type I fiber Vo increased by an average of 34% with BR. Although the ratio of myosin light chain 3 to myosin light chain 2 also rose with BR, there was no correlation between this ratio and Vo for either the pre- or post-BR fibers. In separate fibers obtained from the original biopsies, quantitative electron microscopy revealed a 20–24% decrease in thin filament density, with no change in thick filament density. These results raise the possibility that alterations in the geometric relationships between thin and thick filaments may be at least partially responsible for the elevated Vo of the post-BR type I fibers

Privacy Mining from IoT-based Smart Homes

Recently, a wide range of smart devices are deployed in a variety of environments to improve the quality of human life. One of the important IoT-based applications is smart homes for healthcare, especially for elders. IoT-based smart homes enable elders' health to be properly monitored and taken care of. However, elders' privacy might be disclosed from smart homes due to non-fully protected network communication or other reasons. To demonstrate how serious this issue is, we introduce in this paper a Privacy Mining Approach (PMA) to mine privacy from smart homes by conducting a series of deductions and analyses on sensor datasets generated by smart homes. The experimental results demonstrate that PMA is able to deduce a global sensor topology for a smart home and disclose elders' privacy in terms of their house layouts.Comment: This paper, which has 11 pages and 7 figures, has been accepted BWCCA 2018 on 13th August 201

Quasi-optical multiplexing using reflection phase gratings

Heterodyne array receiver systems for both ground based and satellite telescope facilities are now becoming feasible for imaging in the submillimetre/terahertz regions of the EM spectrum. Phase gratings can be usefully employed as high efficiency passive multiplexing devices in the local oscillator (LO) injection chain of such receivers, ensuring that each element of the array is adequately biased and that the reflected LO power level at the array is minimised. For the wavelengths of interest both transmission and reflection gratings can be manufactured by milling an appropriate pattern of slots into the surface(s) of a suitable material. Thus, the required phase modulation is produced by the resulting pattern of varying optical path lengths suffered by the incident wave-front. We report on work we are undertaking to develop all reflection quasi-optical multiplexing systems so as to reduce reflection losses at the grating and minimise the number of surfaces that can contribute to standing wave effects in the optical system. As part of this endeavour we have also developed a quasi-optical technique for analysing the inevitable degradation due to multiple reflections on transmission grating design. This analysis is based on the Gaussian beam mode technique, and a further application of this technique allows one to assess tolerance limitations on the grating

Quasi-optical multiplexing using reflection phase gratings

Heterodyne array receiver systems for both ground based and satellite telescope facilities are now becoming feasible for imaging in the submillimetre/terahertz regions of the EM spectrum. Phase gratings can be usefully employed as high efficiency passive multiplexing devices in the local oscillator (LO) injection chain of such receivers, ensuring that each element of the array is adequately biased and that the reflected LO power level at the array is minimised. For the wavelengths of interest both transmission and reflection gratings can be manufactured by milling an appropriate pattern of slots into the surface(s) of a suitable material. Thus, the required phase modulation is produced by the resulting pattern of varying optical path lengths suffered by the incident wave-front. We report on work we are undertaking to develop all reflection quasi-optical multiplexing systems so as to reduce reflection losses at the grating and minimise the number of surfaces that can contribute to standing wave effects in the optical system. As part of this endeavour we have also developed a quasi-optical technique for analysing the inevitable degradation due to multiple reflections on transmission grating design. This analysis is based on the Gaussian beam mode technique, and a further application of this technique allows one to assess tolerance limitations on the grating