285 research outputs found
A possible solution of the grain boundary problem for applications of high-Tc superconductors
It is shown that the critical current density of high-Tc wires can be greatly
enhanced by using a threefold approach, which consists of grain alignment,
doping, and optimization of the grain architecture. According to model
calculations, current densities of 4x10^6 A/cm2 can be achieved for an average
grain alignment of 10 degree at 77K. Based on this approach, a road to
competitive high-Tc cables is proposed.Comment: 3 pages, 5 figure
Simultaneous current-, force- and work function measurement with atomic resolution
The local work function of a surface determines the spatial decay of the
charge density at the Fermi level normal to the surface. Here, we present a
method that enables simultaneous measurements of local work function and
tip-sample forces. A combined dynamic scanning tunneling microscope and atomic
force microscope is used to measure the tunneling current between an
oscillating tip and the sample in real time as a function of the cantilever's
deflection. Atomically resolved work function measurements on a silicon
(111)-() surface are presented and related to concurrently recorded
tunneling current- and force- measurements.Comment: 8 pages, 4 figures, submitted to Applied Physics Letter
Spatial homogeneity and doping dependence of quasiparticle tunneling spectra in cuprate superconductors
Scanning tunneling spectroscopy (STS) studies reveal long-range (similar to 100 nm) spatial homogeneity in optimally and underdoped superconducting YBa2Cu3O7-delta (YBCO) single crystals and thin films, and macroscopic spatial modulations in overdoped (Y0.7Ca0.3)BaCu3O7-delta (Ca-YBCO) epitaxial films. In contrast, STS on an optimally doped YBa2(Cu0.9934Zn0.0026Mg0.004)(3)O-6.9 single crystal exhibits strong spatial modulations and suppression of superconductivity over a microscopic scale near the Zn or Mg impurity sites, and the global pairing potential is also reduced relative to that of optimally doped YBCO, suggesting strong pair-breaking effects of the non-magnetic impurities. The spectral characteristics are consistent with d(x2-y2) pairing symmetry for the optimally and underdoped YBCO, and with (d(x2-y2) + s) for the overdoped Ca-YBCO. The doping-dependent pairing symmetry suggests interesting changes in the superconducting ground state, and is consistent with the presence of nodal quasiparticles for all doping levels. The maximum energy gap Delta (d) is non-monotonic with the doping level, while the (2 Delta (d)/k(B)T(c)) ratio increases with decreasing doping. The similarities and contrasts between the spectra of YBCO and of Bi2Sr2CaCu2O8+x are discussed
Dynamical response and confinement of the electrons at the LaAlO3/SrTiO3 interface
With infrared ellipsometry and transport measurements we investigated the
electrons at the interface between LaAlO3 and SrTiO3. We obtained a sheet
carrier density of Ns~5-9x 10E13 cm^-2, an effective mass of m*~3m_e, and a
strongly frequency dependent mobility. The latter are similar as in bulk
SrTi1-xNbxO3 and therefore suggestive of polaronic correlations of the confined
carriers. We also determined the vertical density profile which has a strongly
asymmetric shape with a rapid initial decay over the first 2 nm and a
pronounced tail that extends to about 11 nm.Comment: 4 pages, 3 figures, 1 EPAPS file (3 figures
Evolution of the interfacial structure of LaAlO3 on SrTiO3
The evolution of the atomic structure of LaAlO3 grown on SrTiO3 was
investigated using surface x-ray diffraction in conjunction with
model-independent, phase-retrieval algorithms between two and five monolayers
film thickness. A depolarizing buckling is observed between cation and oxygen
positions in response to the electric field of polar LaAlO3, which decreases
with increasing film thickness. We explain this in terms of competition between
elastic strain energy, electrostatic energy, and electronic reconstructions.
The findings are qualitatively reproduced by density-functional theory
calculations. Significant cationic intermixing across the interface extends
approximately three monolayers for all film thicknesses. The interfaces of
films thinner than four monolayers therefore extend to the surface, which might
affect conductivity
Electric-field-induced pyroelectric order and localization of the confined electrons in LaAlO3/SrTiO3 heterostructures
With infrared ellipsometry, x-ray diffraction, and electric transport
measurements we investigated the electric-field-effect on the confined
electrons at the LaAlO3/SrTiO3 interface. We obtained evidence that the
localization of the electrons at low temperature and negative gate voltage is
induced, or at least strongly enhanced, by a pyroelectric phase transition in
SrTiO3 which strongly reduces the lattice polarizability and the subsequent
Coulomb screening. In particular, we show that the charge localisation and the
polar order of SrTiO3 both develop below about 50 K and exhibit similar,
unipolar hysteresis loops as a function of the gate voltage. Our findings
suggest that the pyroelectric order also plays an important role in the quantum
phase transition at very low temperatures where superconductivity is suppressed
by an electric field.Comment: 5 pages, 4 figures, supplementary materia
Profiling the interface electron gas of LaAlO3/SrTiO3 heterostructures by hard X-ray photoelectron spectroscopy
The conducting interface of LaAlO/SrTiO heterostructures has been
studied by hard X-ray photoelectron spectroscopy. From the Ti~2 signal and
its angle-dependence we derive that the thickness of the electron gas is much
smaller than the probing depth of 4 nm and that the carrier densities vary with
increasing number of LaAlO overlayers. Our results point to an electronic
reconstruction in the LaAlO overlayer as the driving mechanism for the
conducting interface and corroborate the recent interpretation of the
superconducting ground state as being of the Berezinskii-Kosterlitz-Thouless
type.Comment: 4 pages, 4 figure
History effect in inhomogeneous superconductors
A model was proposed to account for a new kind of history effect in the
transport measurement of a sample with inhomogeneous flux pinning coupled with
flux creep. The inhomogeneity of flux pinning was described in terms of
alternating weak pinning (lower jc) and strong pinning region (higher jc). The
flux creep was characterized by logarithmic barrier. Based on this model, we
numerically observed the same clockwise V-I loops as reported in references.
Moreover, we predicted behaviors of the V-I loop at different sweeping rates of
applied current dI/dt or magnetic fields Ba, etc. Electric transport
measurement was performed in Ag-sheathed Bi2-xPbxSr2Ca2Cu3Oy tapes immersed in
liquid nitrogen with and without magnetic fields. V-I loop at certain dI/dt and
Ba was observed. It is found that the area of the loop is more sensitive to
dI/dt than to Ba, which is in agreement well with our numerical results.Comment: To appear in Phys Rev B, October 1 Issu
- …