Efficient readout of micromechanical resonator arrays in ambient conditions

We present a method for efficient spectral readout of mechanical resonator arrays in dissipative environments. Magnetomotive drive and detection is used to drive double clamped resonators in the nonlinear regime. Resonators with almost identical resonance frequencies can be tracked individually by sweeping the drive power. Measurements are performed at room temperature and atmospheric pressure. These conditions enable application in high throughput resonant sensor arrays.Comment: 4 pages, 4 figure

Strongly coupled modes in a weakly driven micromechanical resonator

We demonstrate strong coupling between the flexural vibration modes of a clamped-clamped micromechanical resonator vibrating at low amplitudes. This coupling enables the direct measurement of the frequency response via amplitude- and phase modulation schemes using the fundamental mode as a mechanical detector. In the linear regime, a frequency shift of $\mathrm{0.8\,Hz}$ is observed for a mode with a line width of $\mathrm{5.8\,Hz}$ in vacuum. The measured response is well-described by the analytical model based on the Euler-Bernoulli beam including tension. Calculations predict an upper limit for the room-temperature Q-factor of $\mathrm{4.5\times10^5}$ for our top-down fabricated micromechanical beam resonators.Comment: 9 pages, 2 figure

Surface Phason-Polaritons in Charge Density Wave Films

The coupled non-radiative excitations of the electromagnetic field and phasons in films with a quasi one-dimensional charge density wave (CDW) are evaluated for P--polarization and CDW conducting axis inside the film. The prominent features are two surface phason-polariton branches extending from the CDW pinning frequency to the frequency of the longitudinal optical phason. These surface phason-polariton states are confined to a finite band of longitudinal wave numbers. Besides surface polaritons, infinite series of guided wave modes are found which extend to large wave numbers. These differences to usual phonon-polaritons are caused by the extreme anisotropy of the electric CDW reponse. This new class of surface polaritons is expected to be found in the submillimeter frequency range.Comment: Latex2e, 18 pages, to be published in J. Phys. Chem. Solid

Nonlinear Viscous Vortex Motion in Two-Dimensional Josephson-Junction Arrays

When a vortex in a two-dimensional Josephson junction array is driven by a constant external current it may move as a particle in a viscous medium. Here we study the nature of this viscous motion. We model the junctions in a square array as resistively and capacitively shunted Josephson junctions and carry out numerical calculations of the current-voltage characteristics. We find that the current-voltage characteristics in the damped regime are well described by a model with a {\bf nonlinear} viscous force of the form $F_D=\eta(\dot y)\dot y={{A}\over {1+B\dot y}}\dot y$, where $\dot y$ is the vortex velocity, $\eta(\dot y)$ is the velocity dependent viscosity and $A$ and $B$ are constants for a fixed value of the Stewart-McCumber parameter. This result is found to apply also for triangular lattices in the overdamped regime. Further qualitative understanding of the nature of the nonlinear friction on the vortex motion is obtained from a graphic analysis of the microscopic vortex dynamics in the array. The consequences of having this type of nonlinear friction law are discussed and compared to previous theoretical and experimental studies.Comment: 14 pages RevTex, 9 Postscript figure

Magnetomotive drive and detection of clamped-clamped mechanical resonators in water

We demonstrate magnetomotive drive and detection of doubly clamped string resonators in water. A compact 1.9 T permanent magnet is used to detect the fundamental and higher flexural modes of $\mathrm{200 \mu m}$ long resonators. Good agreement is found between the magnetomotive measurements and optical measurements performed on the same resonator. The magnetomotive detection scheme can be used to simultaneously drive and detect multiple sensors or scanning probes in viscous fluids without alignment of detector beams.Comment: 4 pages, 3 figure

Vortex reflection at boundaries of Josephson-junction arrays

We study the propagation properties of a single vortex in square Josephson-junction arrays (JJA) with free boundaries and subject to an applied dc current. We model the dynamics of the JJA by the resistively and capacitively shunted junction (RCSJ) equations. For zero Stewart-McCumber parameter $\beta_c$ we find that the vortex always escapes from the array when it gets to the boundary. For $\beta_c\geq 2.5$ and for low currents we find that the vortex escapes, while for larger currents the vortex is reflected as an antivortex at one edge and the antivortex as a vortex at the other, leading to a stationary oscillatory state and to a non-zero time-averaged voltage. The escape and the reflection of a vortex at the array edges are qualitatively explained in terms of a coarse-grained model of a vortex interacting logarithmically with its image. We also discuss the case when the free boundaries are at $45$ degrees with respect to the direction of the vortex motion. Finally, we discuss the effect of self-induced magnetic fields by taking into account the full-range inductance matrix of the array, and find qualitatively equivalent results.Comment: 14 pages RevTex, 9 Postscript figure