Definition study for photovoltaic residential prototype system

A site evaluation was performed to assess the relative merits of different regions of the country in terms of the suitability for experimental photovoltaic powered residences. Eight sites were selected based on evaluation criteria which included population, photovoltaic systems performance and the cost of electrical energy. A parametric sensitivity analysis was performed for four selected site locations. Analytical models were developed for four different power system implementation approaches. Using the model which represents a direct (or float) charge system implementation the performance sensitivity to the following parameter variations is reported: (1) solar roof slope angle; (2) ratio of the number of series cells in the solar array to the number of series cells in the lead-acid battery; and (3) battery size. For a Cleveland site location, a system with no on site energy storage and with a maximum power tracking inverter which feeds back excess power to the utility was shown to have 19 percent greater net system output than the second place system. The experiment test plan is described. The load control and data acquisition system and the data display panel for the residence are discussed

Application of Hapke photometric model to three geologic surfaces using PARABOLA bidirectional reflection data

The Geologic Remote Sensing Field Experiment (GRSFE) was conducted in July and September of 1989 to collect data with both ground and airborne instrumentation. A major objective of GRSFE was to collect data which could be used to test radiative transfer models for the extraction of composition and textural surface properties from remotely acquired data. Reported here are the initial results from an application of the Hapke photometric model, using data from the Portable Apparatus for Remote Acquisition of Bidirectional Observations of Land and Atmosphere (PARABOLA), a ground based radiometer with three spectral channels. PARABOLA data was collected in the Lunar Crater Volcanic Field in Nevada, specifically from the region of Lunar Lake, a playa. The Hapke model was found to be inadequate for three relatively common geologic surfaces (a clay-rich, hard packed surface with decimeter sized mudcracks; a cobble site, similar to a playa site, but strewn with basaltic cobbles and pebbles; and a surface mantled basalt lava flow). The model is not at fault; rather, the complexity of most geologic surfaces is not accounted for in the initial assumptions

Documentation of the current fault detection, isolation and reconfiguration software of the AIPS fault-tolerant processor

Documentation is presented of the December 1986 version of the ADA code for the fault detection, isolation, and reconfiguration (FDIR) functions of the Advanced Information processing System (AIPS) Fault-Tolerant Processor (FTP). Because the FTP is still under development and the software is constantly undergoing changes, this should not be considered final documentation of the FDIR software of the FTP

Heavy-Ion Beam Acceleration of Two-Charge States from an Ecr Ion Source

This paper describes a design for the front end of a superconducting (SC) ion linac which can accept and simultaneously accelerate two charge states of uranium from an ECR ion source. This mode of operation increases the beam current available for the heaviest ions by a factor of two. We discuss the 12 MeV/u prestripper section of the Rare Isotope Accelerator (RIA) driver linac including the LEBT, RFQ, MEBT and SC sections, with a total voltage of 112 MV. The LEBT consists of two bunchers and electrostatic quadrupoles. The fundamental frequency of both bunchers is half of the RFQ frequency. The first buncher is a multiharmonic buncher, designed to accept more than 80% of each charge state and to form bunches of extremely low longitudinal emittance (rms emittance is lower than 0.2 keV/u nsec) at the output of the RFQ. The second buncher is located directly in front of the RFQ and matches the velocity of each charge-state bunch to the design input velocity of the RFQ. We present full 3D simulations of a two-charge-state uranium beam including space charge forces in the LEBT and RFQ, realistic distributions of all electric and magnetic fields along the whole prestripper linac, and the effects of errors, evaluated for several design options for the prestripper linac. The results indicate that it is possible to accelerate two charge states while keeping emittance growth within tolerable limits.Comment: LINAC2000, MOD0

Use of the Classroom Management Link System (CMLS) Across Multiple Classrooms

This manuscript was originally presented in a poster session at the 121st annual convention of the American Psychological Association, Honolulu, Hawaii.The purpose of this study was to determine the effect of the Classroom Management Link System (CMLS) across classrooms using a multiple baseline design. CMLS is a preventive system that uses rule development, self-monitoring, goal setting and increased positive teacher feedback to prevent disruptive classroom behavior and increase academic engaged time. Baseline data on off-task and disruptive behavior was taken in each classroom until CMLS was implemented. CMLS was implemented after three weeks of collecting baseline data in Classroom One and six weeks of collecting baseline data in Classroom Two. Each teacher completed surveys on non-academic factors impacting their classroom and their own classroom management skills. These surveys were completed at the time CMLS was implemented in each classroom as well as at the end of the study. An additional survey was administered at the end of the study to measure the acceptability of the intervention. The results suggest that the intervention had a large effect on off-task behavior and a small to moderate effect on disruptive behavior. Mixed results were found for each of the surveys. Results on the acceptability of the intervention were also mixed

Multiple Charge State Beam Acceleration at Atlas

A test of the acceleration of multiple charge-state uranium beams was performed at the ATLAS accelerator. A 238U+26 beam was accelerated in the ATLAS PII linac to 286 MeV (~1.2 MeV/u) and stripped in a carbon foil located 0.5 m from the entrance of the ATLAS Booster section. A 58Ni9+ 'guide' beam from the tandem injector was used to tune the Booster for 238U+38. All charge states from the stripping were injected into the booster and accelerated. Up to 94% of the beam was accelerated through the Booster linac, with losses mostly in the lower charge states. The measured beam properties of each charge state and a comparison to numerical simulations are reported in this paper.Comment: LINAC2000, MOD0