127 research outputs found
Status of the Micromegas semi-DHCAL
The activities towards the fabrication and test of a 1 m3 semi-digital
hadronic calorime- ter are reviewed. The prototype sampling planes would
consist of 1 m2 Micromegas chambers with 1 cm2 granularity and embedded 2 bits
readout suitable for PFA calorime- try at an ILC detector. The design of the 1
m2 chamber is presented first, followed by an overview of the basic performance
of small prototypes. The basic units composing the 1 m2 chamber are 32 \times
48 cm2 boards with integrated electronics and a micro-mesh. Results of
character- ization tests of such boards are shown. Micromegas as a proportional
detector is well suited for semi-digital hadronic calorimetry. In order to
quantify the gain in perfor- mance when using one or more thresholds,
simulation studies are being carried out, some of which will be reported in
this contribution
Test in a beam of large-area Micromegas chambers for sampling calorimetry
Application of Micromegas for sampling calorimetry puts specific constraints
on the design and performance of this gaseous detector. In particular, uniform
and linear response, low noise and stability against high ionisation density
deposits are prerequisites to achieving good energy resolution. A
Micromegas-based hadronic calorimeter was proposed for an application at a
future linear collider experiment and three technologically advanced prototypes
of 11 m were constructed. Their merits relative to the
above-mentioned criteria are discussed on the basis of measurements performed
at the CERN SPS test-beam facility
DIRAC v2: a DIgital Readout Asic for hadronic Calorimeter
International audienceThis mixed-signal circuit is a 64 channels readout R&D ASIC for Micro-Pattern Gaseous Detectors (Micromegas, Gas Electron Multiplier) or Resistive Plate Chambers. These detectors are foreseen as the active part of a digital hadronic calorimeter for a high energy physics experiment at the International Linear Collider. Physics requirements lead to a highly granular hadronic calorimeter with up to fifty millions channels with probably only hit information (digital calorimeter). Each channel of the chip is made of a 4 gains charge preamplifier, a DC-servo loop, 3 switched comparators and a digital memory, thus providing additional energy information for a hit. For detector characterization, a multiplexed analog readout has been implemented. Configuration and readout are fully digital, indeed six 8-bit DACs are embedded to set comparators thresholds. Power-down circuitry has been included, decreasing the power consumption to 10 ÎĽW per channel. To achieve a low cost electronics, a cheap full CMOS 0.35 ÎĽm foundry process has been chosen and the floorplan has been designed to reduce Printed Circuit Board costs. The SPS beam tests of the DIRAC first version embedded in a bulk Micromegas will be presented. The second version has just been received and preliminary results will be detailed. Large area detectors equipped with these chips are planned to be put in the PS beam this year
Resistive micromegas for sampling calorimetry
MicromegasInternational audienceMicromegas is an attractive option for a gaseous sampling calorimeter. It delivers proportional and fast signals, achieves high efficiency to minimum ionising particles with a compact design and shows well-uniform performance over meter-square areas. The current R&D focuses on large- size spark-protected Micromegas with integrated front-end electronics. It targets an application at future linear colliders (LC) and possible upgrades of LHC experiments for the running at high luminosity. In the later case, occasional sparking should be suppressed to avoid dead-time and technical solutions using resistive coatings are investigated. Small prototypes of resistive and non-resistive Micromegas were constructed and tested in a beam at DESY. Results are reported with emphasis on the impact of the resistive layer on the detector performance
Large Area Micromegas Chambers with Embedded Front-end Electronics for Hadron Calorimetry
AbstractMicromegas (Micro-mesh gaseous structure) is an attractive technology for applications in particle physics experiments (TPC, calorimeters, muon systems, etc.). The most important results of an extensive R&D program aiming to develop a new generation of a fine-grained hadron calorimeter with low power consumption digital readout using Micromegas chambers as an active element are presented. In 2010, the first large scale prototype of Micromegas chamber with almost 8000 readout channels has been built and tested with high energy particle beams at CERN. The fundamental results, such as detection effciency, hit multiplicity, gain stability, response uniformity and effect of power pulsing of the detector front-end electronics are reported. Eventually, the development and test of the second generation of the large scale prototype with new readout electronics and some important improvements of its mechanical design is described and the prospective towards the construction of a technological prototype of a 4.5 λ deep digital calorimeter for a future linear collider is also given
MICROMEGAS chambers for hadronic calorimetry at a future linear collider
Prototypes of MICROMEGAS chambers, using bulk technology and analog readout,
with 1x1cm2 readout segmentation have been built and tested. Measurements in
Ar/iC4H10 (95/5) and Ar/CO2 (80/20) are reported. The dependency of the
prototypes gas gain versus pressure, gas temperature and amplification gap
thickness variations has been measured with an 55Fe source and a method for
temperature and pressure correction of data is presented. A stack of four
chambers has been tested in 200GeV/c and 7GeV/c muon and pion beams
respectively. Measurements of response uniformity, detection efficiency and hit
multiplicity are reported. A bulk MICROMEGAS prototype with embedded digital
readout electronics has been assembled and tested. The chamber layout and first
results are presented
Construction and test of a 1Ă—1 m2 Micromegas chamber for sampling hadron calorimetry at future lepton colliders
Equipe MicromegasSampling calorimeters can be finely segmented and used to detect showers with high spatial resolution. This imaging power can be exploited at future linear collider experiments where the measurement of jet energy by a Particle flow method requires optimal use of tracking and calorimeter information. Gaseous detectors can achieve high granularity and a hadron sampling calorimeter using Micromegas chambers as active elements is considered in this paper. Compared to traditional detectors using wires or resistive plates, Micromegas is free of space charge effects and could therefore show superior calorimetric performance. To test this concept, a prototype of 1Ă—1 m2 equipped with 9216 readout pads of 1Ă—1 cm2 has been built. Its technical and basic operational characteristics are reported
Recent results of Micromegas sDHCAL with a new readout chip
Calorimetry at future linear colliders could be based on a particle flow
approach where granularity is the key to high jet energy resolution. Among
different technologies, Micromegas chambers with 1 cm2 pad segmentation are
studied for the active medium of a hadronic calorimeter. A chamber of 1 m2 with
9216 channels read out by a low noise front-end ASIC called MICROROC has
recently been constructed and tested. Chamber design, ASIC circuitry and
preliminary test beam results are reported
Construction and commissioning of a technological prototype of a high-granularity semi-digital hadronic calorimeter
A large prototype of 1.3m3 was designed and built as a demonstrator of the
semi-digital hadronic calorimeter (SDHCAL) concept proposed for the future ILC
experiments. The prototype is a sampling hadronic calorimeter of 48 units. Each
unit is built of an active layer made of 1m2 Glass Resistive Plate
Chamber(GRPC) detector placed inside a cassette whose walls are made of
stainless steel. The cassette contains also the electronics used to read out
the GRPC detector. The lateral granularity of the active layer is provided by
the electronics pick-up pads of 1cm2 each. The cassettes are inserted into a
self-supporting mechanical structure built also of stainless steel plates
which, with the cassettes walls, play the role of the absorber. The prototype
was designed to be very compact and important efforts were made to minimize the
number of services cables to optimize the efficiency of the Particle Flow
Algorithm techniques to be used in the future ILC experiments. The different
components of the SDHCAL prototype were studied individually and strict
criteria were applied for the final selection of these components. Basic
calibration procedures were performed after the prototype assembling. The
prototype is the first of a series of new-generation detectors equipped with a
power-pulsing mode intended to reduce the power consumption of this highly
granular detector. A dedicated acquisition system was developed to deal with
the output of more than 440000 electronics channels in both trigger and
triggerless modes. After its completion in 2011, the prototype was commissioned
using cosmic rays and particles beams at CERN.Comment: 49 pages, 41 figure
Micromegas for imaging hadronic calorimetry
The recent progress in R&D of the Micromegas detectors for hadronic
calorimetry including new engineering-technical solutions, electronics
development, and accompanying simulation studies with emphasis on the
comparison of the physics performance of the analog and digital readout is
described. The developed prototypes are with 2 bit digital readout to exploit
the Micromegas proportional mode and thus improve the calorimeter linearity. In
addition, measurements of detection efficiency, hit multiplicity, and energy
shower profiles obtained during the exposure of small size prototypes to
radioactive source quanta, cosmic particles and accelerator beams are reported.
Eventually, the status of a large scale chamber (1{\times}1 m2) are also
presented with prospective towards the construction of a 1 m3 digital
calorimeter consisting of 40 such chambers.Comment: 6 pages, 9 figures, CALOR2010 conferenc
- …