ARGG-HDL: A High Level Python Based Object-Oriented HDL Framework

We present a High-Level Python-based Hardware Description Language (ARGG-HDL), It uses Python as its source language and converts it to standard VHDL. Compared to other approaches of building converters from a high-level programming language into a hardware description language, this new approach aims to maintain an object-oriented paradigm throughout the entire process. Instead of removing all the high-level features from Python to make it into an HDL, this approach goes the opposite way. It tries to show how certain features from a high-level language can be implemented in an HDL, providing the corresponding benefits of high-level programming for the user

Magnetic states of linear defects in graphene monolayers: effects of strain and interaction

The combined effects of defect-defect interaction and of uniaxial or biaxial strains of up to 10\% on the development of magnetic states on the defect-core-localized quasi-one-dimensional electronic states generated by the so-called 558 linear extended defect in graphene monolayers are investigated by means of {\it ab initio} calculations. Results are analyzed on the basis of the heuristics of the Stoner criterion. We find that conditions for the emergence of magnetic states on the 558 defect can be tuned by uniaxial tensile parallel strains (along the defect direction) at both limits of isolated and interacting 558 defects. Parallel strains are shown to lead to two cooperative effects that favor the emergence of itinerant magnetism: enhancement of the DOS of the resonant defect states in the region of the Fermi level and tuning of the Fermi level to the maximum of the related DOS peak. A perpendicular strain is likewise shown to enhance the DOS of the defect states, but it also effects a detunig of the Fermi level that shifts away from the maximum of the DOS of the defect states, which inhibts the emergence of magnetic states. As a result, under biaxial strains the stabilization of a magnetic state depends on the relative magnitudes of the two components of strain.Comment: 9 pages 8 figure

Dynamics of methane ebullition from a peat monolith revealed from a dynamic flux chamber system

Methane (CH4) ebullition in northern peatlands is poorly quantified in part due to its high spatiotemporal variability. In this study, a dynamic flux chamber (DFC) system was used to continuously measure CH4 fluxes from a monolith of near‐surface Sphagnum peat at the laboratory scale to understand the complex behavior of CH4 ebullition. Coincident transmission ground penetrating radar measurements of gas content were also acquired at three depths within the monolith. A graphical method was developed to separate diffusion, steady ebullition, and episodic ebullition fluxes from the total CH4 flux recorded and to identify the timing and CH4 content of individual ebullition events. The results show that the application of the DFC had minimal disturbance on air‐peat CH4 exchange and estimated ebullition fluxes were not sensitive to the uncertainties associated with the graphical model. Steady and episodic ebullition fluxes were estimated to be averagely 36 ± 24% and 38 ± 24% of the total fluxes over the study period, respectively. The coupling between episodic CH4 ebullition and gas content within the three layers supports the existence of a threshold gas content regulating CH4 ebullition. However, the threshold at which active ebullition commenced varied between peat layers with a larger threshold (0.14 m3 m−3) observed in the deeper layers, suggesting that the peat physical structure controls gas bubble dynamics in peat. Temperature variation (23°C to 27°C) was likely only responsible for small episodic ebullition events from the upper peat layer, while large ebullition events from the deeper layers were most likely triggered by drops in atmospheric pressure

Large perturbation flow field analysis and simulation for supersonic inlets

An analysis technique for simulation of supersonic mixed compression inlets with large flow field perturbations is presented. The approach is based upon a quasi-one-dimensional inviscid unsteady formulation which includes engineering models of unstart/restart, bleed, bypass, and geometry effects. Numerical solution of the governing time dependent equations of motion is accomplished through a shock capturing finite difference algorithm, of which five separate approaches are evaluated. Comparison with experimental supersonic wind tunnel data is presented to verify the present approach for a wide range of transient inlet flow conditions

Controls on Carbon Gas Fluxes From a Temperate Forest Soil

Forest soils consume atmospheric methane (CH4), serving as a major global CH4 sink that uptake an estimated 22 ± 12 Tg of CH4 per year. Temperature and soil moisture have been identified as key controls of the microbial consumption of CH4 in forest soils. Climate-driven warming and changing moisture regimes may impact forest soils’ role in the carbon cycle, and recent works suggests that forests could become weaker CH₄ sinks. Long-term monitoring sites can capture these changes, leading to better predictions of CH4 exchange between the atmosphere and soils under climate change. This study utilizes a long-term trace gas dataset from College Woods in Durham, NH, USA to track both CH4 and carbon dioxide (CO2) fluxes between 1989 and 2021. Between 1989 and 2001 gas fluxes were measured approximately biweekly. In June 2021 the site was re-established, and we collected weekly flux measurements at three collars on a hillslope and three collars in a hollow. Flux measurements collected June-October 2021 in College Woods indicated that average CH4 uptake in these soils was 3.27 ± 1.16 mg m-² d-1. This is consistent with the 3.35 ± 1.68 mg m-² d-1 average uptake rate observed June-October 1989-2001. Average CO₂ emissions from June -August 2021 were 2.86 ± 0.91 µmol m2s-1, also consistent with the 3.96 ± 2.36 µmol m2s-1 average for 1989-2001. We did not observe a significant change in carbon fluxes across the study period, in contrast with the recent studies suggesting the global forest soil CH4 sink is decreasing

Experimentally induced root mortality increased nitrous oxide emission from tropical forest soils

We conducted an experiment on sand and clay tropical forest soils to test the short‐term effect of root mortality on the soil‐atmosphere flux of nitrous oxide, nitric oxide, methane, and carbon dioxide. We induced root mortality by isolating blocks of land to 1 m using trenching and root exclusion screening. Gas fluxes were measured weekly for ten weeks following the trenching treatment. For nitrous oxide there was a highly significant increase in soil‐atmosphere flux over the ten weeks following treatment for trenched plots compared to control plots. N2O flux averaged 37.5 and 18.5 ng N cm−2 h−1 from clay trenched and control plots and 4.7 and 1.5 ng N cm−2 h−1 from sand trenched and control plots. In contrast, there was no effect for soil‐atmosphere flux of nitric oxide, carbon dioxide, or methane

Bromoform and dibromomethane measurements in the seacoast region of New Hampshire, 2002–2004

Atmospheric measurements of bromoform (CHBr3) and dibromomethane (CH2Br2) were conducted at two sites, Thompson Farm (TF) in Durham, New Hampshire (summer 2002–2004), and Appledore Island (AI), Maine (summer 2004). Elevated mixing ratios of CHBr3 were frequently observed at both sites, with maxima of 37.9 parts per trillion by volume (pptv) and 47.4 pptv for TF and AI, respectively. Average mixing ratios of CHBr3 and CH2Br2 at TF for all three summers ranged from 5.3–6.3 and 1.3–2.3 pptv, respectively. The average mixing ratios of both gases were higher at AI during 2004, consistent with AI\u27s proximity to sources of these bromocarbons. Strong negative vertical gradients in the atmosphere corroborated local sources of these gases at the surface. At AI, CHBr3 and CH2Br2 mixing ratios increased with wind speed via sea‐to‐air transfer from supersaturated coastal waters. Large enhancements of CHBr3 and CH2Br2 were observed at both sites from 10 to 14 August 2004, coinciding with the passage of Tropical Storm Bonnie. During this period, fluxes of CHBr3 and CH2Br2 were 52.4 ± 21.0 and 9.1 ± 3.1 nmol m−2 h−1, respectively. The average fluxes of CHBr3 and CH2Br2 during nonevent periods were 18.9 ± 12.3 and 2.6 ± 1.9 nmol m−2 h−1, respectively. Additionally, CHBr3 and CH2Br2 were used as marine tracers in case studies to (1) evaluate the impact of tropical storms on emissions and distributions of marine‐derived gases in the coastal region and (2) characterize the transport of air masses during pollution episodes in the northeastern United States

Picosecond timing of Microwave Cherenkov Impulses from High-Energy Particle Showers Using Dielectric-loaded Waveguides

We report on the first measurements of coherent microwave impulses from high-energy particle-induced electromagnetic showers generated via the Askaryan effect in a dielectric-loaded waveguide. Bunches of 12.16 GeV electrons with total bunch energy of $\sim 10^3-10^4$ GeV were pre-showered in tungsten, and then measured with WR-51 rectangular (12.6 mm by 6.3 mm) waveguide elements loaded with solid alumina ($Al_2 O_3$) bars. In the 5-8 GHz $TE_{10}$ single-mode band determined by the presence of the dielectric in the waveguide, we observed band-limited microwave impulses with amplitude proportional to bunch energy. Signals in different waveguide elements measuring the same shower were used to estimate relative time differences with 2.3 picosecond precision. These measurements establish a basis for using arrays of alumina-loaded waveguide elements, with exceptional radiation hardness, as very high precision timing planes for high-energy physics detectors.Comment: 16 pages, 15 figure

Elastic scattering and breakup of 17^F at 10 MeV/nucleon

Angular distributions of fluorine and oxygen produced from 170 MeV 17^F incident on 208^Pb were measured. The elastic scattering data are in good agreement with optical model calculations using a double-folding potential and parameters similar to those obtained from 16^O+208^Pb. A large yield of oxygen was observed near \theta_lab=36 deg. It is reproduced fairly well by a calculation of the (17^F,16^O) breakup, which is dominated by one-proton stripping reactions. The discrepancy between our previous coincidence measurement and theoretical predictions was resolved by including core absorption in the present calculation.Comment: 9 pages, 5 figure

Studies of MCP-PMTs in the miniTimeCube neutrino detector

This report highlights two different types of cross-talk in the photodetectors of the miniTimeCube neutrino experiment. The miniTimeCube detector has 24 $8 \times 8$-anode Photonis MCP-PMTs Planacon XP85012, totalling 1536 individual pixels viewing the 2-liter cube of plastic scintillator