237 research outputs found

    Nanogranular MgB2 thin films on SiC buffered Si substrates prepared by in-situ method

    Full text link
    MgB2 thin films were deposited on SiC buffered Si substrates by sequential electron beam evaporation of B-Mg bilayer followed by in-situ annealing. The application of a SiC buffer layer enables the maximum annealing temperature of 830 C. The Transmission Electron Microscopy analysis confirms the growth of a nanogranular MgB2 film and the presence of a Mg2Si compound at the surface of the film. The 150-200 nm thick films show a maximum zero resistance critical temperature TC0 above 37 K and a critical current density JC ~ 106 A/cm2 at 11K.Comment: 7 pages, 6 figures, submitted to Applied Physics Letter

    Dual stage resistive transition of MgB2 evidenced by noise analysis

    Get PDF
    The resistive transition of polycrystalline superconducting MgB2 films is studied by means of an extensive set of stationary noise measurements, going from the very beginning of the transition to its final point, where the normal state is reached, either with and without magnetic field. The experimental results, taken at low current density and close to the critical temperature Tc, show very clearly the existence of two different dissipative processes at the different stages of the transition. An extended analysis proves that, at the beginning of the transition, when the resistance is below ten percent of normal value, the specimen is in a mixed state and dissipation is produced by fluxoid creation and motion. At higher temperature the specimen is in an intermediate state, constituted by a structure of interleaved superconducting and resistive domains. Such a situation occurs in type II superconductor when the transition temperature is very near to Tc and the critical field Hc for fluxoid penetration tends to zero. It is found that in the intermediate state, the power spectrum of the relative resistance fluctuations, is independent of the average resistance value and is unaffected by the magnetic field. As shown in the paper, this means that the noise is generated by density fluctuation of the normal electron gas in the resistive domains, while the contribution of the superconducting ones is negligible. The reduced noise amplitude does not depend on the steepness of the transition curve, thus adding further evidence to the above interpretation. The noise is thus related to the film impurities and can be investigated when the specimen is in the normal state, even at room temperature. The occurrence of a different dissipative process at low resistance is clearly evidenced by the experimental results, which show that the amplitude of the reduced power spectrum of the noise depends on magnetic field and resistance. These results are consistent with the assumption of fluxoid noise as shown by the model for the calculation of the noise developed in the manuscrip

    Point-Contact Spectroscopy in MgB_2: from Fundamental Physics to Thin-Film Characterization

    Full text link
    In this paper we highlight the advantages of using point-contact spectroscopy (PCS) in multigap superconductors like MgB_2, both as a fundamental research tool and as a non-destructive diagnostic technique for the optimization of thin-film characteristics. We first present some results of crucial fundamental interest obtained by directional PCS in MgB_2 single crystals, for example the temperature dependence of the gaps and of the critical fields and the effect of a magnetic field on the gap amplitudes. Then, we show how PCS can provide useful information about the surface properties of MgB_2 thin films (e.g. Tc, gap amplitude(s), clean or dirty-limit conditions) in view of their optimization for the fabrication of tunnel and Josephson junctions for applications in superconducting electronics.Comment: 11 pages, 7 figures; Proceedings of 6th EUCAS Conference (14-18 September 2003, Sorrento - Italy

    Magnetoplasmonic design rules for active magneto-optics

    Full text link
    Light polarization rotators and non-reciprocal optical isolators are essential building blocks in photonics technology. These macroscopic passive devices are commonly based on magneto-optical Faraday and Kerr polarization rotation. Magnetoplasmonics - the combination of magnetism and plasmonics - is a promising route to bring these devices to the nanoscale. We introduce design rules for highly tunable active magnetoplasmonic elements in which we can tailor the amplitude and sign of the Kerr response over a broad spectral range

    Health related quality of life in adolescents with idiopathic scoliosis: a cross-cultural comparison between two methods of treatment

    Get PDF
    he present study aims at evaluating the effects produced on HRQOL by two different methods of physiotherapy in adolescent population with Idiopathic Scoliosis (IS): SEAS, used in Milan (Italia) in ISICO center, and Barcelona Scoliosis Physical Therapy School, in E. Salvá Institut (Spain)
    • …
    corecore