Morphology, Mineralogy, and Chemistry of Atmospheric Aerosols Nearby an Active Mining Area: Aljustrel Mine (SW Portugal)

Mining activities increase contaminant levels in the environment, so it is crucial to study the particulate matter in these areas to understand the impacts on nearby urban areas and populations. This work was conducted close to the active mine of Aljustrel (Portugal), where black dust deposition is evident. PM10 samples were collected in two periods: 10–17 July and 1–10 November of 2018. Two different techniques were used: SEM-EDX for the individual characterization of the aerosols and ICP-MS to quantify the elemental concentration of 11 elements (Ca, Na, Fe, Mn, As, Cd, Cu, Sb, Pb, and Zn). In this region, the observed PM10 mass concentration was 20 to 47 g m 3 (July) and 4 to 23 g m3 (November), which is lower than the limit of 50 g m3 established in the European Directive. The individual characterization of 2006 particles by SEM-EDX shows oxides (17%) and sulfides (10%), while Na, Si, Fe, S, Al, and Cu are the elements with the most representativeness in all the analyzed particles. The ICP-MS results indicate that the daily elemental concentration in the samples collected in July is higher than November, and only As exceeds the limit established for European legislation.info:eu-repo/semantics/publishedVersio

Trophodynamics and functional feeding groups of North Sea fauna: a combined stable isotope and fatty acid approach

The trophodynamics of pelagic and benthic animals of the North Sea, North Atlantic shelf, were assessed using stable isotope analysis (SIA) of natural abundance carbon and nitrogen isotopes, lipid fingerprinting and compound-specific SIA (CSIA) of phospholipid-derived fatty acids (PLFAs). Zooplankton (z), epi- and supra-benthic macrofauna were collected in the Southern Bight, at the Oyster Grounds and at North Dogger, 111 km north of the Dogger Bank. The study included 22 taxonomic groups with particular reference to Mollusca (Bivalvia and Gastropoda) and Crustacea. Primary consumers (Bivalvia) were overall most 15N enriched in the southern North Sea (6.1‰) and more depleted in the Oyster Grounds (5.5‰) and at North Dogger (2.8‰) demonstrating differences in isotopic baselines for bivalve fauna between the study sites. Higher trophic levels also followed this trend. Over an annual cycle, consumers tended to exhibit 15N depletion during spring followed by 15N enriched signatures in autumn and winter. The observed seasonal changes of ? 15N were more pronounced for suspension feeders and deposit feeders (dfs) than for filter feeders (ffs). The position of animals in plots of ? 13C and ? 15N largely concurred with the expected position according to literature-based functional feeding groups. PLFA fingerprints of groups such as z were distinct from benthic groups, e.g. benthic ffs and dfs, and predatory macrobenthos. ? 13CPLFA signatures indicated similarities in 13C moiety sources that constituted ? 13CPLFA. Although functional groups of pelagic zooplankton and (supra-) benthic animals represented phylogenetically distinct consumer groups, ? 13CPLFA demonstrated that both groups were supported by pelagic primary production and relied on the same macronutrients such as PLFAs. Errors related to the static categorization of small invertebrates into fixed trophic positions defined by phylogenetic groupings rather than by functional feeding groups, and information on seasonal trophodynamic variability, may have implications for the reliability of numerical marine ecosystem models

Manufacture and mechanical-tribological assessment of diamond-reinforced Cu-based coatings for cutting/grinding tools

This work proposes the design of laser-textured patterns for the development of surfaces with high anchor densities capable of promoting solid mechanical bonding of highly abrasive sintered diamond/carbide-reinforced. Cu-based composite coatings with excellent wear resistance. The results show the development of dense and well-adhered coatings onto the patterns and how the higher nucleation of TiC/Fe3C on the diamond surfaces favours its greater bonding within the matrix, preventing its graphitization, and detachment. Reductions above 40% and 60% in the CoF were observed, under dry conditions, for coatings reinforced with 10 & 30 wt% of diamonds, respectively. Depending on the percentage of diamond used, the best glass/coating and alumina/coating wear volume ratios were around 20 and 6. These values would indicate that these composite coatings show high performance and therefore could be used to make tools for grinding and/or cutting glass and ceramic materials

Gypsy endogenous retrovirus maintains potential infectivity in several species of Drosophilids

<p>Abstract</p> <p>Background</p> <p>Sequences homologous to the <it>gypsy </it>retroelement from <it>Drosophila melanogaster </it>are widely distributed among drosophilids. The structure of <it>gypsy </it>includes an open reading frame resembling the retroviral gene <it>env</it>, which is responsible for the infectious properties of retroviruses.</p> <p>Results</p> <p>In this study we report molecular and phylogeny analysis of the complete <it>env </it>gene from ten species of the <it>obscura </it>group of the genus <it>Drosophila </it>and one species from the genus <it>Scaptomyza</it>.</p> <p>Conclusion</p> <p>The results indicate that in most cases <it>env </it>sequences could produce a functional Env protein and therefore maintain the infectious capability of <it>gypsy </it>in these species.</p

Measurements and estimation of the columnar optical depth of tropospheric aerosols in the UV spectral region

International audienceWe report values of the columnar tropospheric aerosol optical depth at UV wavelengths based on experimental measurements of the direct spectral irradiances carried out by a commercial spectroradiometer (Li1800 of Licor company) covering the range from 300?1100 nm at two stations with different climate characteristics in Spain. The first station is located in a rural site in north central Spain with continental climate. The data extend from March to the end of October of 1995. The other station is a coastal site in the Gulf of Cádiz (southwest Spain) of maritime climate type. This study is mainly focused on the capability of estimating aerosol optical depth values in the UV region based on the extracted information in the visible and near infrared ranges. A first method has been used based on the Ångström turbidity parameters. However, since this method requires detailed spectral information, a second method has also been used, based on the correlation between wavelengths. A correlation has been established between the experimental aerosol optical depth values at 350 nm and 500 nm wavelengths. Although the type of aerosol seems to be the key factor that determines the quality of these estimations, the evaluation of the associated error is necessary to know the behaviour of these estimations in each area of study

Comparison of UV irradiances from Aura/Ozone Monitoring Instrument (OMI) with Brewer measurements at El Arenosillo (Spain) – Part 2: Analysis of site aerosol influence

Several validation studies have shown a notable overestimation of the clear sky ultraviolet (UV) irradiance at the Earth's surface derived from satellite sensors such as the Total Ozone Mapping Spectrometer (TOMS) and the Ozone Monitoring Instrument (OMI) with respect to ground-based UV data at many locations. Most of this positive bias is attributed to boundary layer aerosol absorption that is not accounted for in the TOMS/OMI operational UV algorithm. Therefore, the main objective of this study is to analyse the aerosol effect on the bias between OMI erythemal UV irradiance (UVER) and spectral UV (305 nm, 310 nm and 324 nm) surface irradiances and ground-based Brewer spectroradiometer measurements from October 2004 to December 2008 at El Arenosillo station (37.1° N, 6.7° W, 20 m a.s.l.), with meteorological conditions representative of the South-West of Spain. <br><br> The effects of other factors as clouds, ozone and the solar elevation over this intercomparison were analysed in detail in a companion paper (Antón et al., 2010). In that paper the aerosol effects were studied making only a rough evaluation based on aerosol optical depth (AOD) information at 440 nm wavelength (visible range) without applying any correction. We have used the precise information given by single scattering albedo (SSA) from AERONET for the determination of absorbing aerosols which has allowed the correction of the OMI UV data. <br><br> An aerosol correction expression was applied to the OMI operational UV data using two approaches to estimate the UV absorption aerosol optical depth, AAOD. The first approach was based on an assumption of constant SSA value of 0.91. This approach reduces the OMI UVER bias against the reference Brewer data from 13.4% to 8.4%. Second approach uses daily AERONET SSA values reducing the bias only to 11.6%. Therefore we have obtained a 37% and 12% of improvement respectively. For the spectral irradiance at 324 nm, the OMI bias is reduced from 10.5% to 6.98% for constant SSA and to 9.03% for variable SSA. Similar results were obtained for spectral irradiances at 305 nm, and 310 nm. <br><br> Contrary to what was expected, the constant SSA approach has a greater bias reduction than variable SSA, but this is a reasonable result according to the discussion about the reliability of SSA values. Our results reflect the level of accuracy that may be reached at the present time in this type of comparison, which may be considered as satisfactory taking into account the remaining dependence on other factors. Nevertheless, improvements must be accomplished to determine reliable absorbing aerosol properties, which appear as a limiting factor for improving OMI retrievals

Cloud cover detection combining high dymanics range sky images and ceilometer measurements

This paper presents a new algorithm for cloud detection based on high dynamic range images from a sky camera and ceilometer measurements. The algorithm is also able to detect the obstruction of the sun. This algorithm, called CPC (Camera Plus Ceilometer), is based on the assumption that under cloud-free conditions the sky field must show symmetry. The symmetry criteria are applied depending on ceilometer measurements of the cloud base height. CPC algorithm is applied in two Spanish locations (Granada and Valladolid). The performance of CPC retrieving the sun conditions (obstructed or unobstructed) is analyzed in detail using as reference pyranometer measurements at Granada. CPC retrievals are in agreement with those derived from the reference pyranometer in 85% of the cases (it seems that this agreement does not depend on aerosol size or optical depth). The agreement percentage goes down to only 48% when another algorithm, based on Red-Blue Ratio (RBR), is applied to the sky camera images. The retrieved cloud cover at Granada and Valladolid is compared with that registered by trained meteorological observers. CPC cloud cover is in agreement with the reference showing a slight overestimation and a mean absolute error around 1 okta. A major advantage of the CPC algorithm with respect to the RBR method is that the determined cloud cover is independent of aerosol properties. The RBR algorithm overestimates cloud cover for coarse aerosols and high loads. Cloud cover obtained only from ceilometer shows similar results than CPC algorithm; but the horizontal distribution cannot be obtained. In addition, it has been observed that under quick and strong changes on cloud cover ceilometers retrieve a cloud cover fitting worse with the real cloud cover.This work was supported by the Andalusia Regional Government (project P12-RNM-2409) and by the Consejería de Educación, Junta de Castilla y León (project VA100U14).Spanish Ministry of Economy and Competitiveness (CGL2013-45410-R, CMT2015-66742-R, CGL2016-81092-R, and FJCI-2014-22052).FEDER funds under the projects CGL2013-45410-R, CMT2015-66742-R, CGL2016-81092-R.“Juan de la Cierva-Formación” (FJCI-2014-22052) program.European Union H2020-INFRAIA-2014-2015 project ACTRIS-2 (grant agreement No. 654109

An Exactly Conservative Integrator for the n-Body Problem

The two-dimensional n-body problem of classical mechanics is a non-integrable Hamiltonian system for n > 2. Traditional numerical integration algorithms, which are polynomials in the time step, typically lead to systematic drifts in the computed value of the total energy and angular momentum. Even symplectic integration schemes exactly conserve only an approximate Hamiltonian. We present an algorithm that conserves the true Hamiltonian and the total angular momentum to machine precision. It is derived by applying conventional discretizations in a new space obtained by transformation of the dependent variables. We develop the method first for the restricted circular three-body problem, then for the general two-dimensional three-body problem, and finally for the planar n-body problem. Jacobi coordinates are used to reduce the two-dimensional n-body problem to an (n-1)-body problem that incorporates the constant linear momentum and center of mass constraints. For a four-body choreography, we find that a larger time step can be used with our conservative algorithm than with symplectic and conventional integrators.Comment: 17 pages, 3 figures; to appear in J. Phys. A.: Math. Ge