A new approach to crystal growth of Hg1−xCdxTe by the travelling heater method (THM)

Crystal growth by the travelling heater method (THM) is reported using a source material preparation process that is different from all methods used before. Non-stoichiometric (Hg, Cd)Te melts were homogenized and quenched to prevent macroscopic segregation effects. Inclusions of excess Te were removed during a first THM pass, resulting in stoichiometric solid alloys with a shift of the mole fraction towards higher CdTe contents. The amount of the shift, dependent on the Te excess and on the equilibrium temperature of the first THM run, was calculated and taken into account in the preparation of x=0.22 and x=0.30 Hg1-xCdxTe single crystals. Source material ingots, as well as THM single crystals, were characterized with special emphasis of the compositional homogeneity. Radial as well as axial homogeneity are comparable with the best results on THM crystals reported so far. The described method can be used in growing all materials for which THM is possible. However, quantitative calculation requires the exact knowledge of the particular ternary phase diagram

Axially linear slopes of composition for “delta” crystals

“Delta” crystals are solid solutions of miscible materials with large lattice parameter differences which contain high concentration gradients in one direction (parallel to a lattice plane strongly diffracting X-rays). The system GaSb-InSb has been chosen as suitable for study. By means of a “gradient projection method”, the growth of nearly linear composition profiles with relatively steep slopes of the lattice parameter (up to (Δa/ ) / Δz = 8.3% cm-1), adjustable by the temperature gradient, have been performed. However, the grown ingots were not monocrystalline due to the use of too high a growth rate

Growth of Hg1−xCdxTe single crystals by travelling heater method under accelerated crucible rotation conditions

The accelerated crucible rotation technique (ACRT) has been applied to the THM growth of Hg1−xCdxTe crystals to grow the crystals at a higher rate. These higher growth rates, which should be achieved by extending the regions of conventional stirring towards the interfaces, have been used in an attempt to explain the results in terms of simple constitutional supercooling arguments. Some different ACRT cycles which fulfil simple hydrodynamic and geometric criteria have been studied. The grown crystals were investigated with respect to their metallurgical homogeneity and their structural perfection. These properties have not been degraded by increasing the growth rate from 1.5 to 8.5 mm per day

Consequences of the introduction of cereal - grain legume intercrops in the supply chain. Analysis from the perspective of farmers and cooperatives

Intercropping (the simultaneous growth of 2 or more species in the same field) is one way to solve some difficulties that organic supply chain has to face. The aim of this article is to assess the consequences and the compatibility with intercrops at 2 levels: i) cropping systems of 18 farmers from north of France and ii) the logistics ofagricultural cooperatives which collect durum wheat in Midi-Pyrenees altogether with two cooperatives that already had experimented intercrops (Terrena and AgriBioUnion).The conclusions of our work is that intercrops seem a priori compatible with farmers’ cropping systems and with the presentlogistic organization of cooperatives but the main difficulty remains the feasibility and the cost in sorting out grains. Constraints and benefits of intercrops must then be analyzed more precisely at each level of the supply chain in order to collectively develop solutions

Horizontal travelling heater method growth of Hg1−xCdxTe with crucible rotation

A horizontal travelling heater method (THM) for growing cylindrical cyrstals from a partially filled solution zone has been investigated for the first time. By applying ampoule rotation, the whole cross section of the crystal is successively brought into contact with the liquid solution, which is effectively stirred by forced convection. This approach was used to grow single-crystalline Hg1−xCdxTe ingots from a Te-rich solution zone. The structural perfection and metallurgical homogeneity are equivalent to vertically-grown THM material

Label-free isolation of prostate circulating tumor cells using Vortex microfluidic technology.

There has been increased interest in utilizing non-invasive "liquid biopsies" to identify biomarkers for cancer prognosis and monitoring, and to isolate genetic material that can predict response to targeted therapies. Circulating tumor cells (CTCs) have emerged as such a biomarker providing both genetic and phenotypic information about tumor evolution, potentially from both primary and metastatic sites. Currently, available CTC isolation approaches, including immunoaffinity and size-based filtration, have focused on high capture efficiency but with lower purity and often long and manual sample preparation, which limits the use of captured CTCs for downstream analyses. Here, we describe the use of the microfluidic Vortex Chip for size-based isolation of CTCs from 22 patients with advanced prostate cancer and, from an enumeration study on 18 of these patients, find that we can capture CTCs with high purity (from 1.74 to 37.59%) and efficiency (from 1.88 to 93.75 CTCs/7.5 mL) in less than 1 h. Interestingly, more atypical large circulating cells were identified in five age-matched healthy donors (46-77 years old; 1.25-2.50 CTCs/7.5 mL) than in five healthy donors <30 years old (21-27 years old; 0.00 CTC/7.5 mL). Using a threshold calculated from the five age-matched healthy donors (3.37 CTCs/mL), we identified CTCs in 80% of the prostate cancer patients. We also found that a fraction of the cells collected (11.5%) did not express epithelial prostate markers (cytokeratin and/or prostate-specific antigen) and that some instead expressed markers of epithelial-mesenchymal transition, i.e., vimentin and N-cadherin. We also show that the purity and DNA yield of isolated cells is amenable to targeted amplification and next-generation sequencing, without whole genome amplification, identifying unique mutations in 10 of 15 samples and 0 of 4 healthy samples

Early and long-term morbidity after total laryngopharyngectomy

To determine the early and long-term morbidity of patients treated with a total laryngopharyngectomy and reconstruction using a jejunum interposition or gastric pull-up procedure. It is a retrospective study; and it is conducted in tertiairy referral center. Sixty-three patients were included in whom 70 reconstructions were performed (51 jejunum interpositions and 19 gastric pull-up procedures) between 1990 and 2007. The studied parameters were success rate of the reconstruction, early and long-term complication rate, and functional outcome including quality of life. Subjective quality of life analysis was determined by two questionnaires: the EORTC Quality of Life Questionnaire (QLQ)-C30 Dutch version 3.0, and the EORTC-Head and Neck (H & N 35). The success rates were 84 and 74%, respectively. The procedures were associated with a high complication rate (63% after jejunum interposition and 89% after gastric pull-up), and a lengthy rehabilitation. Surviving patients were found to have a good long-term quality of life. Complete oral intake was achieved in 97%, and speech rehabilitation in 95%. These procedures are associated with significant morbidity, high complication rates, lengthy rehabilitation, but a good long-term quality of life