Atomic layer deposited HfO2 based metal insulator semiconductor GaN ultraviolet photodetectors

Cataloged from PDF version of article.A report on GaN based metal insulator semiconductor (MIS) ultraviolet (UV) photodetectors (PDs) with atomic layer deposited (ALD) 5-nm-thick HfO2 insulating layer is presented. Very low dark current of 2.24 x 10(-11) A and increased photo to dark current contrast ratio was achieved at 10 V. It was found that the dark current was drastically reduced by seven orders of magnitude at 10 V compared to samples without HfO2 insulating layer. The observed decrease in dark current is attributed to the large barrier height which is due to introduction of HfO2 insulating layer and the calculated barrier height was obtained as 0.95 eV. The peak responsivity of HfO2 inserted device was 0.44 mA/W at bias voltage of 15 V. (C) 2014 Elsevier B.V. All rights reserved

UV/VIS range photodetectors based on thin film ALD grown ZnO/Si heterojunction diodes

Cataloged from PDF version of article.We present ultraviolet-visible (UV/vis) range photodetectors (PDs) based on thin film ZnO (n)/Si (p) heterojunction diodes. ZnO films are grown by the atomic layer deposition (ALD) technique at growth temperatures of 80, 150, 200 and 250 degrees C. The fabricated ZnO (n)/Si (p) photodetectors (ZnO-Si-PDs) show good electrical rectification characteristics with ON/OFF ratios reaching up to 10(3). Under UV (350 nm wavelength) and visible (475 nm wavelength) light illumination, the ZnO-Si-PDs give photoresponsivity values of 30-37 mA W-1 and 74-80 mA W-1 at 0.5 V reverse bias, respectively. Photoluminescence (PL) spectra of ALD grown ZnO thin films are used to support the results

A Near-Infrared Range Photodetector Based on Indium Nitride Nanocrystals Obtained Through Laser Ablation

Cataloged from PDF version of article.We present a proof-of-concept photodetector that is sensitive in the near-infrared (NIR) range based on InN nanocrystals. Indium nitride nanocrystals (InN-NCs) are obtained through laser ablation of a high pressure chemical vapor deposition grown indium nitride thin film and are used as optically active absorption region. InN-NCs are sandwiched between thin insulating films to reduce the electrical leakage current. Under -1 V applied bias, the recorded photoresponsivity values within 600-1100-nm wavelength range are as high as 3.05 x 10(-2) mA/W. An ultrathin layer of nanocrystalline InN thin film is, therefore, a promising candidate for NIR detection in large area schemes. © 2014 IEEE

Atomic layer deposited HfO2 based metal insulator semiconductor GaN ultraviolet photodetectors

A report on GaN based metal insulator semiconductor (MIS) ultraviolet (UV) photodetectors (PDs) with atomic layer deposited (ALD) 5-nm-thick HfO2 insulating layer is presented. Very low dark current of 2.24 × 10-11 A and increased photo to dark current contrast ratio was achieved at 10 V. It was found that the dark current was drastically reduced by seven orders of magnitude at 10 V compared to samples without HfO2 insulating layer. The observed decrease in dark current is attributed to the large barrier height which is due to introduction of HfO2 insulating layer and the calculated barrier height was obtained as 0.95 eV. The peak responsivity of HfO2 inserted device was 0.44 mA/W at bias voltage of 15 V. © 2014 Published by Elsevier B.V

Performance enhancement of GaN metal-semiconductor-metal ultraviolet photodetectors by insertion of ultrathin interfacial HfO2 layer

The authors demonstrate improved device performance of GaN metal-semiconductor-metal ultraviolet (UV) photodetectors (PDs) by ultrathin HfO2 (UT-HfO2) layer on GaN. The UT-HfO2 interfacial layer is grown by atomic layer deposition. The dark current of the PDs with UT-HfO2 is significantly reduced by more than two orders of magnitude compared to those without HfO2 insertion. The photoresponsivity at 360 nm is as high as 1.42 A/W biased at 5 V. An excellent improvement in the performance of the devices is ascribed to allowed electron injection through UT-HfO2 on GaN interface under UV illumination, resulting in the photocurrent gain with fast response time. © 2015 American Vacuum Society

Using nanogap in label-free impedance based electrical biosensors to overcome electrical double layer effect

Point-of-care biosensor applications require low-cost and low-power solutions. They offer being easily accessible at home site. They are usable without any complex sample handling or any kind of special expertise. Impedance spectroscopy has been utilized for point-of-care biosensor applications; however, electrical double layer formed due to ions in the solution of interest has been a challenge, due to shielding of the electric field used for sensing the target molecules. Here in this study, we demonstrate a nanogap based biosensor structure with a relatively low frequency (1–100 kHz) measurement technique, which not only eliminates the undesired shielding effect of electrical double layer but also helps in minimizing the measurement volume and enabling low concentration (µ molar level) detection of target molecules (streptavidin). Repeatability and sensitivity tests proved stable and reliable operation of the sensors. These biosensors might offer attributes such as low-cost label-free detection, fast measurement and monolithic chip integrability. © 2015, Springer-Verlag Berlin Heidelberg