A first update on mapping the human genetic architecture of COVID-19

peer reviewe

Tailoring the pseudocapacitive behavior of electrochemically deposited manganese-nickel oxide films

Manganese-nickel mixed oxide thin films were deposited by anodic electrodeposition on stainless steel substrate from an acetate solution using a potentiodynamic technique, at scan rate of 100 mV s-1 and room temperature. The effect of electrolyte pH, varied in the range from 4 to 7, on composition, morphology and capacitance behavior of oxide thin films was investigated. The nickel content in the oxide increased with increasing deposition pH, allowing to investigate the effect of the oxide composition on the capacitive behavior of as-grown manganese-nickel mixed oxides. Oxide films deposited from the electrolyte at pH 6, having a composition close to Ni0.10Mn0.90Ox showed the highest specific capacitance and the lowest charge transfer resistance. After annealing, the oxide had a complex structure of composite nature, consisting of intermixed amorphous and nanocrystalline phases. A birnessite type oxide with turbostratic disorder was identified as the major phase, in the presence of nickel hydroxide as a finely dispersed second phase. Annealing caused a drastic reduction of the charge transfer resistance and a limited increase of the specific capacitance, probably as the result of diverging effects on oxide properties, i.e. enhanced conductivity and porosity sintering. Cycle life testing of this material revealed a 25% increase of the specific capacitance over 5,000 cycles to a final value of 225 F g-1 (1 M Na2SO4, 50 mV s-1, 0.11 mg cm-2 mass loading)

Nanosized Mn-Ni oxide thin films via anodic electrodeposition: A study of the correlations between morphology, structure and capacitive behaviour

The present study addresses the synthesis of manganese-nickel oxide thin films via potentiodynamic anodic electrodeposition as supercapacitor electrodes. We study in particular the effect of the deposition scan rate and of the Ni(II) to Mn(II) molar ratio in the deposition bath on the capacitive behaviour of mixed oxide electrodes. The increase of the nickel content in oxide thin films of composition NixMn1-xOy (with x in the range from 0 to 0.17) results in the increase of specific capacitance up to a maximum for about 10 at% Ni. The deposition scan rate affects the capacitive behaviour of mixed oxide electrodes through its effects on layer morphology and surface structure. In particular, thin film electrodes at about 10 at% Ni show a maximum in the specific capacitance for deposition scan rate of 600 mV s-1, which is shown to be related to the attendant modifications in surface morphology and topography. After annealing at 200 °C, 6 h, partial crystallization of the amorphous structure of the as-grown mixed oxide takes place with formation of dispersed nanocrystalline domains. The annealed electrode at 10 at% Ni, with mass loading of 0.30 mg cm-2, show the highest specific capacitance (250 F g-1, at 0.1 A g-1), and specific energy and power as high as 34.5 Wh kg-1 (at 50 W kg-1), and 4.3 kW kg-1 (at 15.7 Wh kg-1). Mixed oxide of the same composition and mass loading reveal a 122% capacitance retention after 10,000 cycles in 1 M Na2SO4 at 20 A g-1