1,037 research outputs found
6.4 GHz Acoustic Sensor for In-situ Monitoring of AFM Tip Wear
This paper demonstrates an acoustic sensor that can resolve atomic force microscopy (AFM) tip blunting with a frequency sensitivity of 0.007%. The AFM tip is fabricated on a thin film piezoelectric aluminum nitride (AlN) membrane that is excited as a film bulk acoustic resonator (FBAR). We demonstrate that cutting 0.98 μm off of the tip apex results in a resonance frequency change of 0.4MHz at 6.387GHz. This work demonstrates the potential for in-situ monitoring of AFM tip wear
Nano-electromechanical Zero-dimensional Freestanding Nanogap Actuator
Micromachined free standing nanogap with metal electrodes is presented. The gap size is as small as 17 nm, and can be reduced further with electrostatic or piezoelectric actuation. The nanoscale gap is fabricated by industrial standard optical lithography and anisotropic wet chemical Si etching. Electron transport between the metal electrodes with optical stimulus enhancing photon-electron coupling (plasmon) is presented
Extragalactic Sources for Ultra High Energy Cosmic Ray Nuclei
In this article we examine the hypothesis that the highest energy cosmic rays
are complex nuclei from extragalactic sources. Under reasonable physical
assumptions, we show that the nearby metally rich starburst galaxies (M82 and
NGC 253) can produce all the events observed above the ankle. This requires
diffusion of particles below eV in extragalactic magnetic fields nG. Above eV, the model predicts the presence of
significant fluxes of medium mass and heavy nuclei with small rate of change of
composition. Notwithstanding, the most salient feature of the
starburst-hypothesis is a slight anisotropy induced by iron debris just before
the spectrum-cutoff.Comment: To appear in Phys. Rev. D, reference adde
Non-Gaussianity from Inflation
Correlated adiabatic and isocurvature perturbation modes are produced during
inflation through an oscillation mechanism when extra scalar degrees of freedom
other than the inflaton field are present. We show that this correlation
generically leads to sizeable non-Gaussian features both in the adiabatic and
isocurvature perturbations. The non-Gaussianity is first generated by large
non-linearities in some scalar sector and then efficiently transferred to the
inflaton sector by the oscillation process. We compute the cosmic microwave
background angular bispectrum, providing a characteristic feature of such
inflationary non-Gaussianity,which might be detected by upcoming satellite
experiments.Comment: Revised version accepted for publication in Phys. Rev. D. 19 pages,
LaTeX fil
Behaviour of a blast-driven ball bearing embedded in rear detonated cylindrical explosive
This paper presents insights into the flight characteristics of a ball bearing embedded in a rear detonated cylindrical charge, which represents an idealised piece of shrapnel from an improvised explosive device. A novel experimental technique was developed to quantify the loading from a blast-driven ball bearing. The impulse contributions from the blast pressure and the ball bearing impact were separately identifiable in the experimental data. Computational simulations, validated using experimental data, were used to elucidate additional detail about the momentum transfer and damage in the ball bearings during the blast event. The results show the critical influence of charge mass and aspect ratio on the development of the detonation pressure profile, its interaction with the embedded bearing, and the flight characteristics of the bearing. Length-to-diameter ratios below a critical value were more efficient in transferring momentum to the embedded bearings. These findings provide unique and detailed insights that will prove valuable to blast protection engineers considering the effects of embedded projectiles in improvised explosive devices
Influence of ball bearing size on the flight and damage characteristics of blast-driven ball bearings
This paper presents insights into the influence of ball size on the flight characteristics and damage of a ball bearing embedded in a rear detonated cylindrical charge. It includes results from a post-test damage analysis of ball bearings from previously reported experiments. Computational simulations using Ansys Autodyn were used to provide extra information about the velocity variation during flight and the damage sustained by the ball bearings during the blast event. The influence of bearing size (diameter and mass) was investigated using the validated simulation models to extend the dataset beyond the initial experimental work. The peak bearing velocity is influenced by the charge mass to ball bearing mass ratio and the aspect ratio of the charge. Larger ball bearings require extra momentum to accelerate them to higher velocities, but their higher surface area means a greater portion of the explosive charge is involved in transferring kinetic energy to the projectile. Tensile spalling was to be the major damage mechanism within the ball bearings. The charge aspect ratio also influenced the hydrostatic pressure propagation within the ball bearing itself, affecting the location and degree of internal cracking within the bearings. These findings will prove valuable to blast protection engineers considering the effects of embedded projectiles in improvised explosive devices
The trans-activation domain of the sporulation response regulator Spo0A revealed by X-ray crystallography
Sporulation in Bacillus involves the induction of scores of genes in a temporally and spatially co-ordinated programme of cell development. Its initiation is under the control of an expanded two-component signal transduction system termed a phosphorelay. The master control element in the decision to sporulate is the response regulator, Spo0A, which comprises a receiver or phosphoacceptor domain and an effector or transcription activation domain. The receiver domain of Spo0A shares sequence similarity with numerous response regulators, and its structure has been determined in phosphorylated and unphosphorylated forms. However, the effector domain (C-Spo0A) has no detectable sequence similarity to any other protein, and this lack of structural information is an obstacle to understanding how DNA binding and transcription activation are controlled by phosphorylation in Spo0A. Here, we report the crystal structure of C-Spo0A from Bacillus stearothermophilus revealing a single alpha -helical domain comprising six alpha -helices in an unprecedented fold. The structure contains a helix-turn-helix as part of a three alpha -helical bundle reminiscent of the catabolite gene activator protein (CAP), suggesting a mechanism for DNA binding. The residues implicated in forming the sigma (A)-activating region clearly cluster in a flexible segment of the polypeptide on the opposite side of the structure from that predicted to interact with DNA. The structural results are discussed in the context of the rich array of existing mutational data
Orientational pinning and transverse voltage: Simulations and experiments in square Josephson junction arrays
We study the dependence of the transport properties of square Josephson
Junctions arrays with the direction of the applied dc current, both
experimentally and numerically. We present computational simulations of
current-voltage curves at finite temperatures for a single vortex in the array
(), and experimental measurements in
arrays under a low magnetic field corresponding to . We find that
the transverse voltage vanishes only in the directions of maximum symmetry of
the square lattice: the [10] and [01] direction (parallel bias) and the [11]
direction (diagonal bias). For orientations different than the symmetry
directions, we find a finite transverse voltage which depends strongly on the
angle of the current. We find that vortex motion is pinned in the [10]
direction (), meaning that the voltage response is insensitive to small
changes in the orientation of the current near . We call this
phenomenon orientational pinning. This leads to a finite transverse critical
current for a bias at and to a transverse voltage for a bias at
. On the other hand, for diagonal bias in the [11] direction the
behavior is highly unstable against small variations of , leading to a
rapid change from zero transverse voltage to a large transverse voltage within
a few degrees. This last behavior is in good agreement with our measurements in
arrays with a quasi-diagonal current drive.Comment: 9 pages, 9 figure
Ultra-High Energy Neutrino Fluxes and Their Constraints
Applying our recently developed propagation code we review extragalactic
neutrino fluxes above 10^{14} eV in various scenarios and how they are
constrained by current data. We specifically identify scenarios in which the
cosmogenic neutrino flux, produced by pion production of ultra high energy
cosmic rays outside their sources, is considerably higher than the
"Waxman-Bahcall bound". This is easy to achieve for sources with hard injection
spectra and luminosities that were higher in the past. Such fluxes would
significantly increase the chances to detect ultra-high energy neutrinos with
experiments currently under construction or in the proposal stage.Comment: 11 pages, 15 figures, version published in Phys.Rev.
Modulation control and spectral shaping of optical fiber supercontinuum generation in the picosecond regime
Numerical simulations are used to study how fiber supercontinuum generation
seeded by picosecond pulses can be actively controlled through the use of input
pulse modulation. By carrying out multiple simulations in the presence of
noise, we show how tailored supercontinuum Spectra with increased bandwidth and
improved stability can be generated using an input envelope modulation of
appropriate frequency and depth. The results are discussed in terms of the
non-linear propagation dynamics and pump depletion.Comment: Aspects of this work were presented in Paper ThJ2 at OECC/ACOFT 2008,
Sydney Australia 7-10 July (2008). Journal paper submitted for publication 30
July 200
- …