Analytical studies of corrosion and wear resistant CrN/NbN superlattice PVD coatings.

CrN/NbN nano-scale multilayered coatings have found use in a number of commercial applications where both wear and corrosion resistance are important factors that are required. CrN/NbN nano-scale multilayered coatings have been successfully deposited at temperatures as low as 250°C on 304 stainless steel substrates. This has been achieved by the combined cathodic arc/unbalanced magnetron PVD technique (Arc Bond Sputter) with a coating thickness of 3.0 pm at bias voltages Ubeta of -75 and -95 Volts. The coatings exhibited a preferred {111} texture, good adhesion properties and plastic hardness of 38 to 69 GPa. The microstructural and surface morphology properties of these coatings in the as deposited and corroded conditions have been investigated. The corrosion resistance of the coatings was determined using potentiodynamic polarisation measurement in a 3%NaCl solution open to air at room temperature. The low temperature CrN/NbN coatings deposited onto stainless steel exhibited superior corrosion resistance properties than that for stainless steel. Both crevice and pitting corrosion had occurred at selective growth defect sites, beneath which, an under-dense (porous) coating microstructure was present. These under-dense coating regions provide solution pathways through the coating to the substrate. Wherever feasible comparisons were made with CrN/NbN superlattice coatings deposited at higher temperatures (400°C)

Defect growth in multilayer chromium nitride/niobium nitride coatings produced by combined high power impulse magnetron sputtering and unbalance magnetron sputtering technique

In recent years, high power impulse magnetron sputtering (HIPIMS) has caught the attention of users due to its ability to produce dense coatings. However, microscopic studies have shown that HIPIMS deposited coatings can suffer from some surface imperfections even though the overall number of defects can be significantly lower compared to, for example, arc deposited coatings of similar thicknesses. Defects can degrade the coating performance thus any kind of defect is undesirable. To better understand the nature of these imperfections and the science of their formation, a series of Chromium Nitride/Niobium Nitride (CrN/NbN) coatings were deposited using HIPIMS technique combined with unbalanced magnetron sputtering (UBM) by varying deposition times (t = 15 to 120 minutes). All other deposition parameters were kept constant in order to deposit these coatings with a consistent deposition rate and stoichiometry. In addition, coatings were deposited using pure UBM technique to compare the defects generated by these two different physical vapour deposition approaches. High-resolution scanning electron microscopy images revealed that HIPIMS/UBM and pure UBM CrN/NbN coatings have similar types of defects which could be categorised as: nodular, open void, cone-like and pinhole. Interestingly, there was no evidence of droplet formation in HIPIMS/UBM deposited coatings. The defect density calculation indicated that the defect density of HIPIMS/UBM coatings increased (from 0.48 to 3.18%) with the coating thickness. A coating produced in a relatively clean chamber had a lower defect density. Potentiodynamic polarisation experiments showed that the fluctuation in corrosion currents in HIPIMS/UBM coatings reduced with the coating thickness. This indicated that though visible on the surface, most of these defects did not penetrate thorough the whole thickness of the coating

The sperm factor: paternal impact beyond genes

The fact that sperm carry more than the paternal DNA has only been discovered just over a decade ago. With this discovery, the idea that the paternal condition may have direct implications for the fitness of the offspring had to be revisited. While this idea is still highly debated, empirical evidence for paternal effects is accumulating. Male condition not only affects male fertility but also offspring early development and performance later in life. Several factors have been identified as possible carriers of non-genetic information, but we still know little about their origin and function and even less about their causation. I consider four possible non-mutually exclusive adaptive and non-adaptive explanations for the existence of paternal effects in an evolutionary context. In addition, I provide a brief overview of the main non-genetic components found in sperm including DNA methylation, chromatin modifications, RNAs and proteins. I discuss their putative functions and present currently available examples for their role in transferring non-genetic information from the father to the offspring. Finally, I identify some of the most important open questions and present possible future research avenues

Structural and functional studies of the enteropathogenic Escherichia coli type III needle complex protein EscJ.

The type III secretion system (TTSS) is a macromolecular structure that spans the cell wall of Gram-negative bacterial pathogens, enabling delivery of virulence effector proteins directly to the membranes and cytosol of host eukaryotic cells. TTSS consists of a conserved needle complex (NC) that is composed of sets of inner and outer membranes rings connected by a periplasmic rod. Enteropathogenic Escherichia coli (EPEC) is an extracellular diarrhoeagenic pathogen that uses TTSS to induce actin polymerization and colonizes the intestinal epithelium. In EPEC, EscJ is predicted to be targeted to the periplasm, in a sec-dependent manner, and to bridge the TTSS membrane-associated rings. In this study we determined the global fold of EscJ using Nuclear Magnetic Resonance spectroscopy. We show that EscJ comprises two subdomains (D1 - amino acid residues 1-55 in the mature protein, and D2 - amino acid residues 90-170), each comprising a three-stranded beta-sheet flanked by two alpha-helices. A flexible region (residues 60-85) couples the structured regions D1 and D2. Periplasmic overexpression of EscJ(D1) and EscJ(D2) in a single escJ mutant bacterium failed to restore protein secretion activity, suggesting that the flexible linker is essential for the rod function. In contrast, periplasmic overexpression of EscJ(D1) and EscJ(D2) in the same wild-type bacterium had a dominant-negative phenotype suggesting defective assembly of the TTSS and protein translocation