Effect of heating rate on gas emissions and properties of fired clay bricks and fired clay bricks incorporated with cigarette butts

In general, the firing process of clay bricks generates a range of gas emissions into the atmosphere. At high concentrations, these volatile emissions can be a serious source of environmental pollutions. The main purpose of this study was to evaluate the effect of different heating rates on gas emissions and properties during the firing of clay bricks and clay bricks incorporated with cigarette butts (CBs). In this investigation, four different heating rates were used: 0.7 °C min−1−1, 2 °C min−1, 5 °C min−1 and 10 °C min. The samples were fired in solid form from room temperature to 1050 °C. During the firing cycles, carbon monoxide, carbon dioxide, nitrogen oxides,hydrogen cyanide and chlorine emissions were measured at different heating rates. All bricks were also tested for their physical and mechanical properties including dry density, compressive strength, tensile strength, water absorption and initial rate of absorption. Results show that gas emissions were reduced significantly with higher heating rates (10 °C min) followed by 5 °C min−1−1 and 2 °C min for both types of brick samples. Higher heating rates also decrease the compressive strength and tensile strength value but demonstrate an insignificant effect on the water absorption properties respectively. In conclusion, a higher heating rate is preferable in terms of decreasing gas emissions and it is also able to produce adequate physical and mechanical properties especially for the CB brick

Iodine status in pre-school children prior to mandatory iodine fortification in Australia

The iodine status of children between the ages of 5 and 15 years has been routinely assessed in many countries, but few studies have examined iodine status in pre-school children. We conducted a cross-sectional study of pre-school children living in Adelaide, South Australia, between 2005 and 2007. Children 1–5 years old were identified using a unique sampling strategy to ensure that the study population was representative. A 3-day weighed diet record, a blood sample and a urine sample were obtained from each child. The median urinary iodine concentration (UIC) of the children (n = 279) was 129 µg L⁻¹, indicating iodine sufficiency (normal range: 100–199 µg L⁻¹), but 35% of the children had a UIC < 100 µg L−1. The median thyroglobulin concentration of children (n = 217) was 24 µg L⁻¹ and thyroglobulin concentration declined with increasing age (P = 0.024). The mean daily iodine intake was 76 µg. The intake of iodine was lower than expected and highlights difficulties in accurately assessing iodine intakes. Further studies are needed to monitor dietary changes and iodine status in this age group since the implementation of mandatory fortification of bread with iodised salt in Australia in 2009.Sheila Skeaff, Ying Zhao, Robert Gibson, Maria Makrides, Shao Jia Zho

Evalutaion of the implementation of the folate-neural tube defect health claim and its impact on the availability of folate-fortified food in Australia

Objective: To evaluate the implementation of the folate-neural tube defect (NTD) health claim and its impact on the availability of folate-fortifed food in Australia.Methods: During late 2005, a survey was conducted in 16 supermarkets across all Australian capital cities to identify the use of the folate-NTD health claim on the labels of the 128 food products listed in food standard 1.1A.2: \u27Transitional standard - Health claims\u27 and the number of products fortifed with folic acid.Results: Seventy-nine per cent of existing listed food products were found and two of these were implementing the folate-NTD health claim. Forty-four per cent of these listed products, previously fortifed with folic acid, were no longer fortifed. One hundred and seventeen generally available food products were fortifed with folic acid, predominantly breakfast cereals (73%). Twenty-seven per cent of these folate-fortifed products were listed in the transitional standard.Conclusions: The health claim was not used widely to inform women of child-bearing age of the importance of periconceptional folate intake. The increased availability of folate-fortifed products generally has occurred independently of the health claim. Defciencies in the verifcation system of the tested regulatory framework are identifed. The voluntary regulatory provisions for both folate fortifcation and the use of the health claim diminished the States\u27 infuence over their implementation of public health tools.<br /

Bridging the gap between academia and standard setters

Purpose This commissioned paper reviews literature outlining reasons for a perceived gap between academics and standard setters as policy makers. The aim of this paper is to emphasise how academics and standard setters can collaborate on accounting and audit research and assist standard setters to act in the public interest. Design/methodology/approach The approach is primarily a literature and document review of relevant issues, summarising New Zealand’s standard setting arrangements, providing examples of successful policy-changing research, and making recommendations on future research topics. Findings Despite the long-held views of a gap between academic researchers and standard setters, increasingly standard setters utilise research and request input from academics in their deliberations. Standard setters can increase the likelihood of relevant research by promoting critical issues for research and connecting their practitioner networks with academics. Academics can bridge the gap by selecting topics..

An evaluation of UV protection imparted by cotton fabrics dyed with natural colorants

BACKGROUND: The ultraviolet properties of textiles dyed with synthetic dyes have been widely reported in literature. However, no study has investigated the ultraviolet properties of natural fabrics dyed with natural colorants. This study reports the Ultraviolet Protection Factor (UPF) of cotton fabrics dyed with colorants of plant and insect origins. METHODS: Three cotton fabrics were dyed with three natural colorants. Fabrics were characterized with respect to fabric construction, weight, thickness and thread count. Influence of fabric characteristics on Ultraviolet Protection Factor was studied. Role of colorant concentration on the ultraviolet protection factor was examined via color strength analysis. RESULTS: A positive correlation was observed between the weight of the fabric and their UPF values. Similarly, thicker fabrics offered more protection from ultraviolet rays. Thread count appears to negatively correlate with UPF. Dyeing with natural colorants dramatically increased the protective abilities of all three fabric constructions. Additionally, within the same fabric type UPF values increased with higher depths of shade. CONCLUSION: Dyeing cotton fabrics with natural colorants increases the ultraviolet protective abilities of the fabrics and can be considered as an effective protection against ultraviolet rays. The UPF is further enhanced with colorant of dark hues and with high concentration of the colorant in the fabric

Ladies in waiting: the timeliness of first trimester services in New Zealand

<p>Abstract</p> <p>Background</p> <p>Termination of pregnancy (TOP) services are a core service in New Zealand. However, compared to other developed countries, TOP services are accessed significantly later in the first trimester, increasing the risk for complications. The aim of this study is to examine the timeliness of access to first trimester TOP services and establish the length of delay between different points in the care pathway for these services.</p> <p>Methodology</p> <p>Data were collected from all patients attending nine TOP clinics around the country between February and May 2009 (N = 2950). Patient records were audited to determine the timeline between the first point of entry to the health system to the date of termination. In addition, women were invited to fill out a questionnaire to identify personal level factors affecting access to services (N = 1086, response rate = 36.8%).</p> <p>Results</p> <p>Women waited an average of almost 25 days between the date of the first visit with the referring doctor and the date of their termination procedure. There was a delay of 10 days between the first visit with the referring doctor and the date that the appointment for the procedure was booked, and a further 10 days delay between the date the appointment was booked and the first appointment date. Over half of the women in this study had their pregnancy terminated at ten weeks or above.</p> <p>Conclusion</p> <p>Women in New Zealand are subject to a lengthy delay while seeking TOP services. Efforts should be made by TOP clinics as well as referring doctors to reduce the waiting times for this service.</p

Are non-slip socks really 'non-slip'? An analysis of slip resistance

Background. Non-slip socks have been suggested as a means of preventing accidental falls due to slips. This study compared the relative slip resistance of commercially available non-slip socks with other foot conditions, namely bare feet, compression stockings and conventional socks, in order to determine any traction benefit. Methods. Phase one involved slip resistance testing of two commercially available non-slip socks and one compression-stocking sample through an independent blinded materials testing laboratory using a Wet Pendulum Test. Phase two of the study involved in-situ testing among healthy adult subjects (n = 3). Subjects stood unsupported on a variable angle, inclined platform topped with hospital grade vinyl, in a range of foot conditions (bare feet, non-slip socks, conventional socks and compression stockings). Inclination was increased incrementally for each condition until slippage of any magnitude was detected. The platform angle was monitored using a spatial orientation tracking sensor and slippage point was recorded on video. Results. Phase one results generated through Wet Pendulum Test suggested that non-slip socks did not offer better traction than compression stockings. However, in phase two, slippage in compression stockings was detected at the lowest angles across all participants. Amongst the foot conditions tested, barefoot conditions produced the highest slip angles for all participants indicating that this foot condition provided the highest slip resistance. Conclusion. It is evident that bare feet provide better slip resistance than non-slip socks and therefore might represent a safer foot condition. This study did not explore whether traction provided by bare feet was comparable to 'optimal' footwear such as shoes. However, previous studies have associated barefoot mobilisation with increased falls. Therefore, it is suggested that all patients continue to be encouraged to mobilise in appropriate, well-fitting shoes whilst in hospital. Limitations of this study in relation to the testing method, participant group and sample size are discussed

Enhancing off-site manufacturing through early contractor involvement (ECI) in New Zealand

Procurement strategies that enable early contractor involvement (ECI) in design may enhance off-site manufacturing (OSM) by overcoming previously identified barriers to its uptake. Involving constructors during the design stage can reduce the risk of design buildability issues, and standardising traditionally bespoke ECI processes may help overcome cultural resistance to unfamiliar OSM technology. Following literature review and using case studies, document analysis and legal doctrine, a two-stage ECI conceptual process model for New Zealand is proposed. This was tested and refined following feedback at a conference. The model comprises a first-stage pre-construction contract and a second-stage standard-form construction contract. Key process variables are considered with solutions to provide collaboration and transparency while maintaining competitive fixed pricing across the supply chain. Legal doctrine analysis is used to distinguish between design buildability obligations and design codes compliance. The model contributes towards the development of a standard form for pre-construction contracts

Design development post contract signing in New Zealand:Client's or contractor's cost?

By offering fixed-price contracts for designs supplied by clients, contractors legally warrant that they can build what has been designed and do so within their fixed price. Yet detailed drawings are often issued during construction in response to contractors' requests for information on the basis that they cannot otherwise build what has been designed. Claim-entitlement decisions are often made by construction professionals (architects, engineers and quantity surveyors) without legal training in contractual interpretation, potentially varying who pays for design development after contract signing, contractors or clients. Prior studies have addressed buildability obligations relating to ground conditions and foundations. This study applies key principles of contract law to consider who should pay for instructed drawing details post contract signing under the New Zealand standard NZS 3910:2013, 'Conditions of contract for building and civil engineering construction', in terms of (a) when a variation claim may be accepted; (b) the effect of contractor involvement on design development; and (c) the effect if claimed from a building subcontractor to a consultant manager (no head contractor). A claim-entitlement flow chart and a table comparing the head contractor's and consultant construction manager's obligations provide practical guides for contract administrators. Identifying terms prone to interpretation informs contract drafters towards reducing ambiguity for contract users and therefore the potential for dispute