66 research outputs found
OT FE-Box Test Procedures
The OT FE readout requirements is the precise (~0.5 ns) and efficient drift time measurement at an occupancy of ~4% to ensure single hit resolution. The acquired achievement of such performance on an assembled FE-Box is verify through a final test performed using a special FE-Tester. In this note the test procedures are described
The LHCb Outer Tracker Front End Electronics
This note provides an overview of the front-end electronics used to readout the drift-times of the LHCb Outer Tracker straw tube chambers. The main functional components of the readout are the ASDBLR ASIC for amplification and signal digitization, the OTIS ASIC for the time measurement and for the L0 buffering, and the GOL ASIC to serialize the digital data for the optical data transmission. The L1 buffer board used to receive the data which is sent via the optical link is a common LHCb development and is not described here. This note supersedes an earlier document [1]
Measurement of mechanical vibrations excited in aluminium resonators by 0.6 GeV electrons
We present measurements of mechanical vibrations induced by 0.6 GeV electrons
impinging on cylindrical and spherical aluminium resonators. To monitor the
amplitude of the resonator's vibrational modes we used piezoelectric ceramic
sensors, calibrated by standard accelerometers. Calculations using the
thermo-acoustic conversion model, agree well with the experimental data, as
demonstrated by the specific variation of the excitation strengths with the
absorbed energy, and with the traversing particles' track positions. For the
first longitudinal mode of the cylindrical resonator we measured a conversion
factor of 7.4 +- 1.4 nm/J, confirming the model value of 10 nm/J. Also, for the
spherical resonator, we found the model values for the L=2 and L=1 mode
amplitudes to be consistent with our measurement. We thus have confirmed the
applicability of the model, and we note that calculations based on the model
have shown that next generation resonant mass gravitational wave detectors can
only be expected to reach their intended ultra high sensitivity if they will be
shielded by an appreciable amount of rock, where a veto detector can reduce the
background of remaining impinging cosmic rays effectively.Comment: Tex-Article with epsfile, 34 pages including 13 figures and 5 tables.
To be published in Rev. Scient. Instr., May 200
Performance of the LHCb outer tracker
The LHCb Outer Tracker is a gaseous detector covering an area of 5 × 6 m2 with 12 double layers of straw tubes. The detector with its services are described together with the commissioning and calibration procedures. Based on data of the first LHC running period from 2010 to 2012, the performance of the readout electronics and the single hit resolution and efficiency are presented. The efficiency to detect a hit in the central half of the straw is estimated to be 99.2%, and the position resolution is determined to be approximately 200 μm. The Outer Tracker received a dose in the hottest region corresponding to 0.12 C/cm, and no signs of gain deterioration or other ageing effects are observed
- …