1,074 research outputs found
Influence of Continuous Casting Speeds on Cast Microstructure and Mechanical Properties of an ADC14 Alloy
To improve the mechanical properties of the casting alloys, various attempts have been made to use alternative casting technologies. The Ohno continuous casting (OCC) process is a unidirectional solidification method, which leads to high-quality cast samples. In this study, the Al-Si-Cu-Mg alloy was cast at casting speeds of 1 mm/s, 2 mm/s, and 3 mm/s, by the OCC process. The aim of this study is to investigate the effects of the casting process parameters, such as casting speeds and cooling conditions, on the crystallization characteristics and mechanical properties of OCC-Al-Si-Cu-Mg alloy. Particularly, secondary dendrite arms spacing of alpha-Al dendrites in OCC samples significantly decreases with increasing casting speed. Moreover, the mean tensile strength of the samples, produced at the highest casting speed of 4.0 mm/s, is significantly higher than that for the samples produced at a casting speed of 1.0 mm/s
Estimates of Discharge Coefficient in Levee Breach Under Two Different Approach Flow Types
The amount of released water (discharge) in a levee breach is a primary input variable to establish an emergency action plan for the area next to the levee. However, although several studies have been conducted, there is still no widely applicable discharge coefficient formula; this needs to be known to estimate discharge amount through an opening caused by a levee breach. Sometimes, the discharge coefficient developed for a sharp crested side weir is used to rate the discharge, but, in case of a levee breach, the resulting geometry and flow types are similar to that over a broad crested weir. Thus, in this study, two different openings—rectangular and trapezoidal shape—are constructed in the center of a levee at a height of 0.6m to replicate levee breach scenarios, and the effect of two different approach flow types—the river type approach and reservoir type approach—are explored to suggest a discharge coefficient formula applicable for discharge rating for a levee breach. The results show that the ratio of head above the bottom of an opening and the opening width is a key variable for calculating the discharge coefficient of a reservoir type, but the approach Froude number should also be considered for a river type approach. The measured data are used to improve rating equations and will be useful in the future to validate computational fluid dynamics simulations of wave propagation during levee failure into the inundation area
Safety and tissue yield for percutaneous native kidney biopsy according to practitioner and ultrasound technique
BACKGROUND: Although percutaneous renal biopsy remains an essential tool in the diagnosis and treatment of renal diseases, in recent times the traditional procedure of nephrologists has been performed by non-nephrologists rather than nephrologists at many institutions. The present study assessed the safety and adequacy of tissue yield during percutaneous renal biopsy according to practitioners and techniques based on ultrasound. METHODS: This study included 658 native renal biopsies performed from 2005 to 2010 at a single centre. The biopsies were performed by nephrologists or expert ultrasound radiologists using the ultrasound-marked blind or real-time ultrasound-guided techniques. RESULTS: A total of 271 ultrasound-marked blind biopsies were performed by nephrologists, 170 real-time ultrasound-guided biopsies were performed by nephrologists, and 217 real-time ultrasound-guided biopsies were performed by radiologists during the study period. No differences in post-biopsy complications such as haematoma, need for transfusion and intervention, gross haematuria, pain, or infection were observed among groups. Glomerular numbers of renal specimens from biopsies performed by nephrologists without reference to any technique were higher than those obtained from real-time ultrasound-guided biopsies performed by expert ultrasound radiologists. CONCLUSIONS: Percutaneous renal biopsy performed by nephrologists was not inferior to that performed by expert ultrasound radiologists as related to specimen yield and post-biopsy complications
A low-voltage Two-axis Electromagnetically Actuated Micromirror with Bulk Silicon Mirror
ABSTRACT In this paper, a new micromirror structure has been proposed and fabricated. The proposed micromirror is electromagnetically actuated along two-axis at low voltage using an external magnetic field. The mirror plates and torsion bars are made of bulk silicon and the actuation coils are made of electroplated copper. The maximum deflection angles have been measured as ±4.35° for x-axis actuation and ±15.7° for y-axis actuation. The actuation voltages are below 4.2V for xaxis actuation and 1.76V for y-axis actuation, respectively
Progression from Chronic Atrophic Gastritis to Gastric Cancer; Tangle, Toggle, Tackle with Korea Red Ginseng
Key molecular players that link inflammation to carcinogenesis are prostaglandins, cytokines, nuclear factor-κB (NF-κB), chemokines, angiogenic growth factors, and free radicals, all of which lead to increased mutations and altered functions of important enzymes and proteins, for example, activation of oncogenic products and/or inhibition of tumor suppressor proteins, in inflamed tissues, thus contributing to multi-stage carcinogenesis process. Interpreted reversely, the identification of the molecular mechanisms by which chronic inflammation increases cancer risk or optimal intervention of targeted drugs or agents during the inflammation-associated carcinogenic process could be a necessary basis for developing new strategy of cancer prevention at many sites. In this review, we discuss the possibilities for cancer prevention by controlling inflammation process in Helicobacter pylori (H. pylori)-associated inflamed stomach with Korea red ginseng. Korea red ginseng is a good example of a natural herb that has ubiquitous properties that are conductive to stop inflammatory carcinogenesis that is un wanted outcome of H. pylori infection, rendering rejuvenation of chronic atrophic gastritis
Does robot-assisted laparoscopic radical prostatectomy enable to obtain adequate oncological and functional outcomes during the learning curve? From the Korean experience
To estimate the short-term results of robot-assisted laparoscopic radical prostatectomy (RALRP) during the learning curve, in terms of surgical, oncological and functional outcomes, we conducted a prospective survey on RALRP. From July 2007, a single surgeon performed 63 robotic prostatectomies using the same operative technique. Perioperative data, including pathological and early functional results of the patient, were collected prospectively and analyzed. Along with the accumulation of the cases, the total operative time, setup time, console time and blood loss were significantly decreased. No major complication was present in any patient. Transfusion was needed in six patients; all of them were within the initial 15 cases. The positive surgical margin rate was 9.8% (5/51) in pT2 disease. The most frequent location of positive margin in this stage was the lateral aspect (60%), but in pT3 disease multiple margins were the most frequent (41.7%). Overall, 53 (84.1%) patients had totally continent status and the median time to continence was 6.56 weeks. Among 17 patients who maintained preoperative sexual activity ( Sexual Health Inventory for Men \u3e = 17), stage below pT2, followed up for \u3e 6 months with minimally one side of neurovascular bundle preservation procedure, 12 (70.6%) were capable of intercourse postoperatively, and the mean time for sexual intercourse after operation was 5.7 months. In this series, robotic prostatectomy was a feasible and reproducible technique, with a short learning curve and low perioperative complication rate. Even during the initial phase of the learning curve, satisfactory results were obtained with regard to functional and oncological outcome
Cervical Length and the Risk of Microbial Invasion of the Amniotic Cavity in Women with Preterm Premature Rupture of Membranes
The aims of this study were to determine whether sonographically measured cervical length is of value in the identification of microbial invasion of the amniotic cavity in women with preterm premature rupture of membranes (PPROM) and to compare its performance with maternal blood C-reactive protein (CRP), white blood cell count (WBC), and amniotic fluid (AF) WBC. This prospective observational study enrolled 50 singleton pregnancies with PPROM. Transvaginal ultrasound for measurement of cervical length was performed and maternal blood was collected for the determination of CRP and WBC at the time of amniocentesis. AF obtained by amniocentesis was cultured and WBC determined. The prevalence of a positive amniotic fluid culture was 26% (13/50). Patients with positive amniotic fluid cultures had a significantly shorter median cervical length and higher median CRP, WBC, and AF WBC than did those with negative cultures. Multiple logistic regression indicated that only cervical length had a significant relationship with the log odds of a positive AF culture. Transvaginal sonographic measurement of cervical length is valuable in the identification of microbial invasion of amniotic cavity in women with PPROM. Cervical length performs better than AF WBC, maternal blood CRP, and WBC in the identification of a positive amniotic fluid culture
Dissociating stable nitrogen molecules under mild conditions by cyclic strain engineering
All quiet on the nitrogen front. The dissociation of stable diatomic nitrogen molecules (N-2) is one of the most challenging tasks in the scientific community and currently requires both high pressure and high temperature. Here, we demonstrate that N-2 can be dissociated under mild conditions by cyclic strain engineering. The method can be performed at a critical reaction pressure of less than 1 bar, and the temperature of the reaction container is only 40 degrees C. When graphite was used as a dissociated N* receptor, the normalized loading of N to C reached as high as 16.3 at/at %. Such efficient nitrogen dissociation is induced by the cyclic loading and unloading mechanical strain, which has the effect of altering the binding energy of N, facilitating adsorption in the strain-free stage and desorption in the compressive strain stage. Our finding may lead to opportunities for the direct synthesis of N-containing compounds from N-2
- …