364 research outputs found
Parametric instabilities in the LCGT arm cavity
We evaluated the parametric instabilities of LCGT (Japanese interferometric
gravitational wave detector project) arm cavity. The number of unstable modes
of LCGT is 10-times smaller than that of Advanced LIGO (U.S.A.). Since the
strength of the instabilities of LCGT depends on the mirror curvature more
weakly than that of Advanced LIGO, the requirement of the mirror curvature
accuracy is easier to be achieved. The difference in the parametric
instabilities between LCGT and Advanced LIGO is because of the thermal noise
reduction methods (LCGT, cooling sapphire mirrors; Advanced LIGO, fused silica
mirrors with larger laser beams), which are the main strategies of the
projects. Elastic Q reduction by the barrel surface (0.2 mm thickness
TaO) coating is effective to suppress instabilities in the LCGT arm
cavity. Therefore, the cryogenic interferometer is a smart solution for the
parametric instabilities in addition to thermal noise and thermal lensing.Comment: 6 pages,3 figures. Amaldi7 proceedings, J. Phys.: Conf. Ser.
(accepted
Current status of the CLIO project
CLIO (Cryogenic Laser Interferometer Observatory) is a Japanese gravitational
wave detector project. One of the main purposes of CLIO is to demonstrate
thermal-noise suppression by cooling mirrors for a future Japanese project,
LCGT (Large-scale Cryogenic Gravitational Telescope). The CLIO site is in
Kamioka mine, as is LCGT. The progress of CLIO between 2005 and 2007 (room- and
cryogenic-temperature experiments) is introduced in this article. In a
room-temperature experiment, we made efforts to improve the sensitivity. The
current best sensitivity at 300 K is about
around 400 Hz. Below 20 Hz, the strain (not displacement) sensitivity is
comparable to that of LIGO, although the baselines of CLIO are 40-times shorter
(CLIO: 100m, LIGO: 4km). This is because seismic noise is extremely small in
Kamioka mine. We operated the interferometer at room temperature for
gravitational wave observations. We obtained 86 hours of data. In the cryogenic
experiment, it was confirmed that the mirrors were sufficiently cooled (14 K).
However, we found that the radiation shield ducts transferred 300K radiation
into the cryostat more effectively than we had expected. We observed that noise
caused by pure aluminum wires to suspend a mirror was suppressed by cooling the
mirror.Comment: 8 pages, 9 figures. Amaldi7 proceedings, J. Phys.: Conf. Ser.
(accepted
Current status of Japanese detectors
Current status of TAMA and CLIO detectors in Japan is reported in this
article. These two interferometric gravitational-wave detectors are being
developed for the large cryogenic gravitational wave telescope (LCGT) which is
a future plan for detecting gravitational wave signals at least once per year.
TAMA300 is being upgraded to improve the sensitivity in low frequency region
after the last observation experiment in 2004. To reduce the seismic noises, we
are installing new seismic isolation system, which is called TAMA Seismic
Attenuation System, for the four test masses. We confirmed stable mass locks of
a cavity and improvements of length and angular fluctuations by using two SASs.
We are currently optimizing the performance of the third and fourth SASs. We
continue TAMA300 operation and R&D studies for LCGT. Next data taking in the
summer of 2007 is planned.
CLIO is a 100-m baseline length prototype detector for LCGT to investigate
interferometer performance in cryogenic condition. The key features of CLIO are
that it locates Kamioka underground site for low seismic noise level, and
adopts cryogenic Sapphire mirrors for low thermal noise level. The first
operation of the cryogenic interferometer was successfully demonstrated in
February of 2006. Current sensitivity at room temperature is close to the
target sensitivity within a factor of 4. Several observation experiments at
room temperature have been done. Once the displacement noise reaches at thermal
noise level of room temperature, its improvement by cooling test mass mirrors
should be demonstrated.Comment: 6 pages, 5 figures, Proceedings of GWDAW-1
Mechanical quality factor of a sapphire fiber at cryogenic temperatures
A mechanical quality factor of was obtained for the 199
Hz bending vibrational mode in a monocrystalline sapphire fiber at 6 K.
Consequently, we confirm that pendulum thermal noise of cryogenic mirrors used
for gravitational wave detectors can be reduced by the sapphire fiber
suspension.Comment: To be published to Physiscs Letters A. Number of pages: 10 Number of
figures: 5 Number of tables:
Force measurements of a superconducting-film actuator for a cryogenic interferometric gravitational-wave detector
We measured forces applied by an actuator with a YBCO film at near 77 K for
the Large-scale Cryogenic Gravitational-wave Telescope (LCGT) project. An
actuator consisting of both a YBCO film of 1.6 micrometers thickness and 0.81
square centimeters area and a solenoid coil exerted a force of up to 0.2 mN on
a test mass. The presented actuator system can be used to displace the mirror
of LCGT for fringe lock of the interferometer.Comment: 9 pages, 3 figure
Reduction of thermal fluctuations in a cryogenic laser interferometric gravitational wave detector
The thermal fluctuation of mirror surfaces is the fundamental limitation for
interferometric gravitational wave (GW) detectors. Here, we experimentally
demonstrate for the first time a reduction in a mirror's thermal fluctuation in
a GW detector with sapphire mirrors from the Cryogenic Laser Interferometer
Observatory at 17\,K and 18\,K. The detector sensitivity, which was limited by
the mirror's thermal fluctuation at room temperature, was improved in the
frequency range of 90\,Hz to 240\,Hz by cooling the mirrors. The improved
sensitivity reached a maximum of at 165\,Hz.Comment: Accepted for publication in Physical Review Letters, 5 pages, 2
figure
Effect of energy deposited by cosmic-ray particles on interferometric gravitational wave detectors
We investigated the noise of interferometric gravitational wave detectors due to heat energy deposited by cosmic-ray particles. We derived a general formula that describes the response of a mirror against a cosmic-ray passage. We found that there are differences in the comic-ray responses (the dependence of temperature and cosmic-ray track position) in cases of interferometric and resonant gravitational wave detectors. The power spectral density of vibrations caused by low-energy secondary muons is 100 times smaller than the goal sensitivity of future second-generation interferometer projects, such as LCGT and Advanced LIGO. The arrival frequency of high-energy cosmic-ray muons that generate enough large showers inside mirrors of LCGT and Advanced LIGO is one per a millennium. We also discuss the probability of exotic-particle detection with interferometers
Ultra-stable performance of an underground-based laser interferometer observatory for gravitational waves
In order to detect the rare astrophysical events that generate gravitational
wave (GW) radiation, sufficient stability is required for GW antennas to allow
long-term observation. In practice, seismic excitation is one of the most
common disturbances effecting stable operation of suspended-mirror laser
interferometers. A straightforward means to allow more stable operation is
therefore to locate the antenna, the ``observatory'', at a ``quiet'' site. A
laser interferometer gravitational wave antenna with a baseline length of 20m
(LISM) was developed at a site 1000m underground, near Kamioka, Japan. This
project was a unique demonstration of a prototype laser interferometer for
gravitational wave observation located underground. The extremely stable
environment is the prime motivation for going underground. In this paper, the
demonstrated ultra-stable operation of the interferometer and a well-maintained
antenna sensitivity are reported.Comment: 8 pages, to appear on PR
- …