Finite element analysis of gradient coil deformation and vibration in NMR microscopy

Resolution degradation due to gradient coil deformation and vibration in NMR microscopy is investigated using finite element analysis. From the analysis, deformations due to the Lorentz force can be as large as 1-10 μm depending on the gradient strength and coil frame material. Thus, these deformations can be one of the major resolution limiting factors in NMR microscopy. Coil vibration, which depends on the input current waveform and resolution degradation due to time-variant deformation and time-invariant deformation are investigated by numerical simulations

Improved simulation of aerosol, cloud, and density measurements by shuttle lidar

Data retrievals are simulated for a Nd:YAG lidar suitable for early flight on the space shuttle. Maximum assumed vertical and horizontal resolutions are 0.1 and 100 km, respectively, in the boundary layer, increasing to 2 and 2000 km in the mesosphere. Aerosol and cloud retrievals are simulated using 1.06 and 0.53 microns wavelengths independently. Error sources include signal measurement, conventional density information, atmospheric transmission, and lidar calibration. By day, tenuous clouds and Saharan and boundary layer aerosols are retrieved at both wavelengths. By night, these constituents are retrieved, plus upper tropospheric, stratospheric, and mesospheric aerosols and noctilucent clouds. Density, temperature, and improved aerosol and cloud retrievals are simulated by combining signals at 0.35, 1.06, and 0.53 microns. Particlate contamination limits the technique to the cloud free upper troposphere and above. Error bars automatically show effect of this contamination, as well as errors in absolute density nonmalization, reference temperature or pressure, and the sources listed above. For nonvolcanic conditions, relative density profiles have rms errors of 0.54 to 2% in the upper troposphere and stratosphere. Temperature profiles have rms errors of 1.2 to 2.5 K and can define the tropopause to 0.5 km and higher wave structures to 1 or 2 km

The Drosophila genome nexus: a population genomic resource of 623 Drosophila melanogaster genomes, including 197 from a single ancestral range population.

Hundreds of wild-derived Drosophila melanogaster genomes have been published, but rigorous comparisons across data sets are precluded by differences in alignment methodology. The most common approach to reference-based genome assembly is a single round of alignment followed by quality filtering and variant detection. We evaluated variations and extensions of this approach and settled on an assembly strategy that utilizes two alignment programs and incorporates both substitutions and short indels to construct an updated reference for a second round of mapping prior to final variant detection. Utilizing this approach, we reassembled published D. melanogaster population genomic data sets and added unpublished genomes from several sub-Saharan populations. Most notably, we present aligned data from phase 3 of the Drosophila Population Genomics Project (DPGP3), which provides 197 genomes from a single ancestral range population of D. melanogaster (from Zambia). The large sample size, high genetic diversity, and potentially simpler demographic history of the DPGP3 sample will make this a highly valuable resource for fundamental population genetic research. The complete set of assemblies described here, termed the Drosophila Genome Nexus, presently comprises 623 consistently aligned genomes and is publicly available in multiple formats with supporting documentation and bioinformatic tools. This resource will greatly facilitate population genomic analysis in this model species by reducing the methodological differences between data sets

Fluid/solid transition in a hard-core system

We prove that a system of particles in the plane, interacting only with a certain hard-core constraint, undergoes a fluid/solid phase transition

Colloidal stabilization via nanoparticle haloing

We present a detailed numerical study of effective interactions between micron-sized silica spheres, induced by highly charged zirconia nanoparticles. It is demonstrated that the effective interactions are consistent with a recently discovered mechanism for colloidal stabilization. In accordance with the experimental observations, small nanoparticle concentrations induce an effective repulsion that counteracts the intrinsic van der Waals attraction between the colloids and thus stabilizes the suspension. At higher nanoparticle concentrations an attractive potential is recovered, resulting in reentrant gelation. Monte Carlo simulations of this highly size-asymmetric mixture are made possible by means of a geometric cluster Monte Carlo algorithm. A comparison is made to results obtained from the Ornstein-Zernike equations with the hypernetted-chain closure

Experimental characterisation of dynamic properties of an all-FRP truss bridge

This is the author accepted manuscript. The final version is available from the publisher via the DOI in this recordFibre Reinforced Polymers (FRPs) have increasingly been utilised for construction of pedestrian bridges due to high strength- and stiffness-to-weight ratios, low maintenance costs and quick installation. Their relatively low mass and stiffness make these bridges potentially susceptible to vibration serviceability problems, which increasingly govern the design. Currently, the wider application of FRPs in civil engineering is hindered by the lack of experimental insight in dynamic performance of as-built structures. This paper presents an experimental investigation on a 25, m long glass-FRP truss footbridge in Italy. Ambient vibration tests were conducted to identify the dynamic properties. The peak-picking method and stochastic subspace identification approach were employed for modal parameter identification. The two methods produced very consistent results. Eight vibration modes were identified in the frequency range up to 10, Hz. Two lateral flexural vibration modes having natural frequencies of 5.8 and 9.6, Hz were identified, as well as two vertical flexural modes (at 7.5 and 8.1, Hz) and four torsional modes (at 2.1, 2.7, 4.8 and 9.3, Hz). Damping ratios for all modes up to 10, Hz except the eighth mode were above 1.2%.Engineering and Physical Sciences Research Council (EPSRC

Comparison of humic fractions of Chernozemic and Luvisolic soils by elemental analyses, UV and ESR spectroscopy, A

Includes bibliographical references (pages 455-456).The Ah horizons of a Brown–Dark Brown–Black–Dark Gray–Gray Luvisolic sequence of Canadian grassland and forest soils were studied. Clay-associated humus was present in greater proportions in the grassland than in forest soils, particularly in the grassland soils of the more arid regions. Amounts of alkali-pyrophosphate-extractable humus increased in the Brown to Gray Luvisolic sequence. Alkali-pyrophosphate-extractable humic acid (HA-A) contents were greatest in the Black and Dark Gray soils. C:H ratios, extinction coefficients at 280 nm (E280), and resistance to acid hydrolysis of the HA-A and clay-associated HA-B increased in the Brown to Gray Luvisolic sequence. Free radical concentrations were least for the Brown and Dark Brown soils, moderate for the Black and greatest for the Gray Luvisolic soils. The data suggest an increase in the proportion of aromatic components in the humic acids in going from the Brown to the Gray Luvisolic soils. An objective, multivariate similarity analysis based on 22 humus characteristics showed a relationship between soil zone or soil environment and the nature of the soil's humus

Structure of the low latitude boundary layer

Observations at high temporal resolution of the frontside magnetopause and plasma boundary layer, made with the LASL/MPE fast plasma analyzer onboard the ISEE 1 and 2 spacecraft, revealed a complex quasiperiodic structure of some of the observed boundary layers. A cool tailward streaming boundary layer plasma was seen intermittently, with intervening periods of hot tenuous plasma which has properties similar to the magnetospheric population. While individual encounters with the boundary layer plasma last only a few minutes, the total observation time may extend over one hour or more

Learning about knowledge: A complex network approach

This article describes an approach to modeling knowledge acquisition in terms of walks along complex networks. Each subset of knowledge is represented as a node, and relations between such knowledge are expressed as edges. Two types of edges are considered, corresponding to free and conditional transitions. The latter case implies that a node can only be reached after visiting previously a set of nodes (the required conditions). The process of knowledge acquisition can then be simulated by considering the number of nodes visited as a single agent moves along the network, starting from its lowest layer. It is shown that hierarchical networks, i.e. networks composed of successive interconnected layers, arise naturally as a consequence of compositions of the prerequisite relationships between the nodes. In order to avoid deadlocks, i.e. unreachable nodes, the subnetwork in each layer is assumed to be a connected component. Several configurations of such hierarchical knowledge networks are simulated and the performance of the moving agent quantified in terms of the percentage of visited nodes after each movement. The Barab\'asi-Albert and random models are considered for the layer and interconnecting subnetworks. Although all subnetworks in each realization have the same number of nodes, several interconnectivities, defined by the average node degree of the interconnection networks, have been considered. Two visiting strategies are investigated: random choice among the existing edges and preferential choice to so far untracked edges. A series of interesting results are obtained, including the identification of a series of plateaux of knowledge stagnation in the case of the preferential movements strategy in presence of conditional edges.Comment: 18 pages, 19 figure