Study of process parameters on aluminium foam formation in the Al-6Si-3Mg alloy

The aim of this research was to study the process parameters that promote foam formation by injecting N2 into Al-6Si-3Mg wt % molten alloy with silicon carbide particles additions (SiC). An experimental design was proposed, in which the contents of SiC particles were 0, 10, 30 and 50 wt %, and the overheating was defined as ΔT= TF - TL , where TL is the liquidus temperature and was determined by the cooling curve method and the foaming temperatures were selected as TF at 630, 610, 580 and 570 °C. Flow and pressure of air blow were constant, 2,0 lt/min and 4,0 atm, respectively. The foam formation was possible only under two experimental conditions, 10 wt % SiC at ΔT > 12 °C and 30 wt % SiC at ΔT > 10 °C. The foams obtained under these conditions were stable, while with other conditions of experiments, bubble coallesence occurred. Finally, it was concluded that the foam formation occurred by SiC contents lower than 30 wt % SiC and temperatures slightly above the liquidus

A GEANT4 Study of a Gamma-ray Collimation Array

Proton beam therapy uses high-energy protons to destroy cancer cells which are still uncertain about where in the body they hit. A possible way to answer this question is to detect the gamma rays produced during the irradiation and determine where in the body they are produced. This work investigates the use of collimators to determine where the proton interactions occur. GEANT4 is used to simulate the gamma production of a source interacting with a collimator. Each event simulates a number of gammas obtained as a function of the position along the detector. Repeating for different collimator configurations can thus help determine the best characteristics of a detector device

Tribological behavior of oils additised with a phosphonium-derived ionic liquid compared to a commercial oil

Purpose: The purpose of this paper is to study the antifriction, antiwear and tribolayer formation properties of the trihexyltetradecylphosphonium bis(2,4,4-trimethylpentyl) phosphinate ionic liquid (IL) as additive at 1 wt.% in two base oils and their mixtures, comparing the results with those of a commercial oil. Design/methodology/approach: The mixture of the base oils used in the formulation of the commercial oil SAE 0W20 plus the IL was tested under rolling/sliding and reciprocating conditions to determine the so-called Stribeck curve, the tribolayer formation and the antifriction and antiwear behaviors. Findings: The use of this IL as additive in these oils does not change their viscosity; improves the antifriction and antiwear properties of the base oils, making equal or outperforming these properties of the SAE 0W20; and the thickness and formation rate of the tribolayer resulting from the IL-surface interaction is highly dependent on the type of base oil and influence on the friction and wear results. Originality/value: The use of this IL allows to replace partial or totally commercial antifriction and antiwear additives. Peer review: The peer review history for this article is available at: https://publons.com/publon/10.1108/ILT-05-2020-0179/

LanderPick, a Remote Operated Trawled Vehicle to cost-effectively deploy and recover lightweight oceanographic landers

Versión del edito

Effect of Co-Inoculation with Mycorrhiza and Rhizobia on the Nodule Trehalose Content of Different Bean Genotypes

Studies on Rhizobium-legume symbiosis show that trehalose content in nodules under drought stress correlates positively with an increase in plant tolerance to this stress. Fewer reports describe trehalose accumulation in mycorrhiza where, in contrast with rhizobia, there is no flux of carbohydrates from the microsymbiont to the plant. However, the trehalose dynamics in the Mycorrhiza-Rhizobium-Legume tripartite symbiosis is unknown. The present study explores the role of this tripartite symbiosis in the trehalose content of nodules grown under contrasting moisture conditions. Three wild genotypes (P. filiformis, P. acutifolis and P. vulgaris) and two commercial genotypes of Phaseolus vulgaris (Pinto villa and Flor de Mayo) were used. Co-inoculation treatments were conducted with Glomus intraradices and a mixture of seven native rhizobial strains, and trehalose content was determined by GC/MS. The results showed a negative effect of mycorrhizal inoculation on nodule development, as mycorrhized plants showed fewer nodules and lower nodule dry weight compared to plants inoculated only with Rhizobium. Mycorrhizal colonization was also higher in plants inoculated only with Glomus as compared to plants co-inoculated with both microsymbionts. In regard to trehalose, co-inoculation negatively affects its accumulation in the nodules of each genotype tested. However, the correlation analysis showed a significantly positive correlation between mycorrhizal colonization and nodule trehalose content

Lubrication performance of an ammonium cation-based ionic liquid used as an additive in a polar oil.

This paper studies the tribological behavior of the ionic liquid methyltrioctylammonium bis(trifluoromethylsulfonyl)imide ([N 1888 ][NTf 2 ]) as additive at different concentrations (1.25, 2.50, 3.75 and 5.00 wt%) in a polar base oil (diester). A tribometer using a ball-on-disk reciprocating configuration under fully flooded lubrication was used at a frequency of 15 Hz, at three different loads (40, 80 and 120 N), stroke length of 4 mm, and duration of 45 min. Worn surface on the disk was studied by confocal microscopy, SEM and XPS. Main results showed similar coefficient of friction for all lubricant samples; but different wear results were found at different loads, probably related with the chemical states found for fluorine on the worn surface and the temperature-dependent adsorption-desorption processes

A combined high-pressure experimental and theoretical study of the electronic band-structure of scheelite-type AWO4 (A = Ca, Sr, Ba, Pb) compounds

The optical-absorption edge of single crystals of CaWO4, SrWO4, BaWO4, and PbWO4 has been measured under high pressure up to ~20 GPa at room temperature. From the measurements we have obtained the evolution of the band-gap energy with pressure. We found a low-pressure range (up to 7-10 GPa) where alkaline-earth tungstates present a very small Eg pressure dependence (-2.1 < dEg/dP < 8.9 meV/GPa). In contrast, in the same pressure range, PbWO4 has a pressure coefficient of -62 meV/GPa. The high-pressure range is characterized in the four compounds by an abrupt decrease of Eg followed by changes in dEg/dP. The band-gap collapse is larger than 1.2 eV in BaWO4. We also calculated the electronic-band structures and their pressure evolution. Calculations allow us to interpret experiments considering the different electronic configuration of divalent metals. Changes in the pressure evolution of Eg are correlated with the occurrence of pressure-induced phase transitions. The band structures for the low- and high-pressure phases are also reported. No metallization of any of the compounds is detected in experiments nor is predicted by calculations.Comment: 26 pages, 1 table, 6 figure

Diagnoses, Intervention Strategies, and Rates of Functional Improvement in Integrated Behavioral Health Care Patients

Objective—Compared with more traditional mental health care, integrated behavioral health care (IBHC) offers greater access to services and earlier identification and intervention of behavioral and mental health difficulties. The current study examined demographic, diagnostic, and intervention factors that predict positive changes for IBHC patients. Method—Participants were 1,150 consecutive patients (mean age = 30.10 years, 66.6% female, 60.1% Hispanic, 47.9% uninsured) seen for IBHC services at 2 primary care clinics over a 34-month period. Patients presented with depressive (23.2%), anxiety (18.6%), adjustment (11.3%), and childhood externalizing (7.6%) disorders, with 25.7% of patients receiving no diagnosis. Results—The most commonly delivered interventions included behavioral activation (26.1%), behavioral medicine-specific consultation (14.6%), relaxation training (10.3%), and parent-management training (8.5%). There was high concordance between diagnoses and evidence-based intervention selection. We used latent growth curve modeling to explore predictors of baseline global assessment of functioning (GAF) and improvements in GAF across sessions, utilizing data from a subset of 117 patients who attended at least 3 behavioral health visits. Hispanic ethnicity and being insured predicted higher baseline GAF, while patients with an anxiety disorder had lower baseline GAF than patients with other diagnoses. Controlling for primary diagnosis, patients receiving behavioral activation or exposure therapy improved at faster rates than patients receiving other interventions. Demographic variables did not relate to rates of improvement. Conclusion—Results suggest even brief IBHC interventions can be focused, targeting specific patient concerns with evidence-based treatment components