20,950 research outputs found
Using presence-absence data to establish reserve selection procedures that are robust to temporal species turnover
Previous studies suggest that a network of nature reserves with maximum efficiency (obtained by selecting the minimum area such that each species is represented once) is likely to be insufficient to maintain species in the network over time. Here, we test the performance of three selection strategies which require presence-absence data, two of them previously proposed (multiple representations and selecting an increasing percentage of each species' range) and a novel one based on selecting the site where each species has exhibited a higher permanence rate in the past. Multiple representations appear to be a safer strategy than selecting a percentage of range because the former gives priority to rarer species while the latter favours the most widespread.
The most effective strategy was the one based on the permanence rate, indicating that the robustness of reserve networks can be improved by adopting reserve selection procedures that integrate information about the relative value of sites. This strategy was also very efficient, suggesting that the investment made in the monitoring schemes may be compensated for by a lower cost in reserve acquisition
Is Small Perfect? Size Limit to Defect Formation in Pyramidal Pt Nanocontacts
We report high resolution transmission electron microscopy and ab initio
calculation results for the defect formation in Pt nanocontacts (NCs). Our
results show that there is a size limit to the existence of twins (extended
structural defects). Defects are always present but blocked away from the tip
axes. The twins may act as scattering plane, influencing contact electron
transmission for Pt NC at room temperature and Ag/Au NC at low temperature.Comment: 4 pages, 3 figure
A systematic comparison of supervised classifiers
Pattern recognition techniques have been employed in a myriad of industrial,
medical, commercial and academic applications. To tackle such a diversity of
data, many techniques have been devised. However, despite the long tradition of
pattern recognition research, there is no technique that yields the best
classification in all scenarios. Therefore, the consideration of as many as
possible techniques presents itself as an fundamental practice in applications
aiming at high accuracy. Typical works comparing methods either emphasize the
performance of a given algorithm in validation tests or systematically compare
various algorithms, assuming that the practical use of these methods is done by
experts. In many occasions, however, researchers have to deal with their
practical classification tasks without an in-depth knowledge about the
underlying mechanisms behind parameters. Actually, the adequate choice of
classifiers and parameters alike in such practical circumstances constitutes a
long-standing problem and is the subject of the current paper. We carried out a
study on the performance of nine well-known classifiers implemented by the Weka
framework and compared the dependence of the accuracy with their configuration
parameter configurations. The analysis of performance with default parameters
revealed that the k-nearest neighbors method exceeds by a large margin the
other methods when high dimensional datasets are considered. When other
configuration of parameters were allowed, we found that it is possible to
improve the quality of SVM in more than 20% even if parameters are set
randomly. Taken together, the investigation conducted in this paper suggests
that, apart from the SVM implementation, Weka's default configuration of
parameters provides an performance close the one achieved with the optimal
configuration
Fano-like Anti-resonances in Nanomechanical and Optomechanical Systems
We study a resonator coupled to a generic detector and calculate the noise
spectra of the two sub-systems. We describe the coupled system by a closed,
linear, set of Langevin equations and derive a general form for the finite
frequency noise of both the resonator and the detector. The resonator spectrum
is the well-known thermal form with an effective damping, frequency shift and
diffusion term. In contrast, the detector noise shows a rather striking
Fano-like resonance, i.e. there is a resonance at the renormalized frequency,
and an anti-resonance at the bare resonator frequency. As examples of this
effect, we calculate the spectrum of a normal state single electron transistor
coupled capacitively to a resonator and of a cavity coupled parametrically to a
resonator.Comment: 5 page
- …