346 research outputs found
The effect of heat treatments on pure and potassium doped drawn tungsten wires: Part II â Fracture properties
Sex-specific local life-history adaptation in surface- and cave-dwelling Atlantic mollies (Poecilia mexicana)
Cavefishes have long been used as model organisms showcasing adaptive diversification, but does adaptation to caves also facilitate the evolution of reproductive isolation from surface ancestors? We raised offspring of wild-caught surface- and cave-dwelling ecotypes of the neotropical fish Poecilia mexicana to sexual maturity in a 12-month common garden experiment. Fish were raised under one of two food regimes (high vs. low), and this was crossed with differences in lighting conditions (permanent darkness vs. 12:12âh light:dark cycle) in a 2âĂâ2 factorial design, allowing us to elucidate potential patterns of local adaptation in life histories. Our results reveal a pattern of sex-specific local life-history adaptation: Surface molly females had the highest fitness in the treatment best resembling their habitat of origin (high food and a light:dark cycle), and suffered from almost complete reproductive failure in darkness, while cave molly females were not similarly affected in any treatment. Males of both ecotypes, on the other hand, showed only weak evidence for local adaptation. Nonetheless, local life-history adaptation in females likely contributes to ecological diversification in this system and other cave animals, further supporting the role of local adaptation due to strong divergent selection as a major force in ecological speciation
Chemical vapor deposition and infiltration for the production of tungsten fiber reinforced tungsten composite material
Contribution submission to the conference Regensburg 2016Chemical vapor deposition and infiltration for the productionof tungsten fiber reinforced tungsten composite material ââMartin Aumann1, Jan Willem Coenen1, Hanns Gietl2, TillHoeschen2, Johann Riesch2, Klaus Schmid2, Rudolf Neu2, andChristian Linsmeier1 â 1Forschungszentrum Juelich GmbH, InstitutfĂŒr Energie- und Klimaforschung, 52425 Juelich â 2Max-Planck-Institut fĂŒr Plasmaphysik, 85748 GarchingDue to its high melting point, high corrosion resistance and its preferableproperties in terms of hydrogen retention, tungsten is a promisingcandidate in future nuclear fusion devices. However, the mechanicalbehavior of tungsten is crucial, as it is inherently brittle at room temperature.As possibility to overcome this brittleness, a composite materialcan be formed, which shows pseudo-ductility and therefore avoidscatastrophic failure of the material. A possibility to produce such aWf/W-composite is chemical vapor deposition and chemical vapor infiltration,where tungsten is deposited on small tungsten wires throughthe reaction of WF6 and H2. With ongoing infiltration time, pores areformed between the fibers, which decrease in size through the chemicalreaction. For better process understanding, a pore model was established,which solves the mass balance inside the pore and the resultingpore diameter simultaneously. It shows a significant difference in diameterfor longer infiltration times. This behavior shall be proved inexperiments with an experimental pore, which is similar to the simulatedone. Furthermore also kinetic investigations on the chemicalsurface reaction are carried out to increase the process understanding.Part: MMType: Vortrag;TalkTopic: Transport (Diffusion, LeitfĂ€higkeit,WĂ€rme)/ Transport (Diffusion,conductivity, heat)Email: [email protected]
Microstructure, mechanical behaviour and fracture of pure tungsten wire after different heat treatments
Plastic deformation of tungsten wire is an effective source of toughening tungsten fibre-reinforced tungsten composites (Wf/W) and other tungsten fibre-reinforced composites. To provide a reference for optimization of those composites, unconstrained pure tungsten wire is studied after various heat treatments in terms of microstructure, mechanical behaviour and fracture mode. Recrystallization is already observed at a relatively low temperature of 1273 K due to the large driving force caused by a high dislocation density. Annealing for 30 min at 1900 K also leads to recrystallization, but causes a rather different microstructure. As-fabricated wire and wire recrystallized at 1273 K for 3 h show fine grains with a high aspect ratio and a substantial plastic deformability: a clearly defined tensile strength, high plastic work, similar necking shape, and the characteristic knife-edge-necking of individual grains on the fracture surface. While the wire recrystallized at 1900 K displays large, almost equiaxed grains with low aspect ratios as well as distinct brittle properties. Therefore, it is suggested that a high aspect ratio of the grains is important for the ductile behaviour of tungsten wire and that embrittlement is caused by the loss of the preferable elongated grain structure rather than by recrystallization. In addition, a detailed evaluation of the plastic deformation behaviour during tensile test gives guidance to the design and optimization of tungsten fibre-reinforced composites
Tungsten fibre-reinforced composites for advanced plasma facing components
AbstractThe European Fusion Roadmap foresees water cooled plasma facing components in a first DEMO design in order to provide enough margin for the cooling capacity and to only moderately extrapolate the technology which was developed and tested for ITER. In order to make best use of the water cooling concept copper (Cu) and copper-chromium-zirconium alloy (CuCrZr) are envisaged as heat sink whereas as armour tungsten (W) based materials will be used. Combining both materials in a high heat flux component asks for an increase of their operational range towards higher temperature in case of Cu/CuCrZr and lower temperatures for W. A remedy for both issues- brittleness of W and degrading strength of CuCrZr- could be the use of W fibres (Wf) in W and Cu based composites. Fibre preforms could be manufactured with industrially viable textile techniques. Flat textiles with a combination of 150/70 ”m W wires have been chosen for layered deposition of tungsten-fibre reinforced tungsten (Wf/W) samples and tubular multi-layered braidings with W wire thickness of 50 ”m were produced as a preform for tungsten-fibre reinforced copper (Wf /Cu) tubes. Cu melt infiltration was performed together with an industrial partner resulting in sample tubes without any blowholes. Property estimation by mean field homogenisation predicts strongly enhanced strength of the Wf/CuCrZr composite compared to its pure CuCrZr counterpart. Wf /W composites show very high toughness and damage tolerance even at room temperature. Cyclic load tests reveal that the extrinsic toughening mechanisms counteracting the crack growth are active and stable. FEM simulations of the Wf/W composite suggest that the influence of fibre debonding, which is an integral part of the toughening mechanisms, and reduced thermal conductivity of the fibre due to the necessary interlayers do not strongly influence the thermal properties of future components
Targetâoriented habitat and wildlife management: estimating forage quantity and quality of semiânatural grasslands with Sentinelâ1 and Sentinelâ2 data
Semiânatural grasslands represent ecosystems with high biodiversity. Their conservation depends on the removal of biomass, for example, through grazing by livestock or wildlife. For this, spatially explicit information about grassland forage quantity and quality is a prerequisite for efficient management. The recent advancements of the Sentinel satellite mission offer new possibilities to support the conservation of semiânatural grasslands. In this study, the combined use of radar (Sentinelâ1) and multispectral (Sentinelâ2) data to predict forage quantity and quality indicators of semiânatural grassland in Germany was investigated. Field data for organic acid detergent fibre concentration (oADF), crude protein concentration (CP), compressed sward height (CSH) and standing biomass dry weight (DM) collected between 2015 and 2017 were related to remote sensing data using the random forest regression algorithm. In total, 102 opticalâ and radarâbased predictor variables were used to derive an optimized dataset, maximizing the predictive power of the respective model. High R2 values were obtained for the grassland quality indicators oADF (R2 = 0.79, RMSE = 2.29%) and CP (R2 = 0.72, RMSE = 1.70%) using 15 and 8 predictor variables respectively. Lower R2 values were achieved for the quantity indicators CSH (R2 = 0.60, RMSE = 2.77 cm) and DM (R2 = 0.45, RMSE = 90.84 g/mÂČ). A permutationâbased variable importance measure indicated a strong contribution of simple ratioâbased optical indices to the model performance. In particular, the ratios between the narrow nearâinfrared and redâedge region were among the most important variables. The model performance for oADF, CP and CSH was only marginally increased by adding Sentinelâ1 data. For DM, no positive effect on the model performance was observed by combining Sentinelâ1 and Sentinelâ2 data. Thus, optical Sentinelâ2 data might be sufficient to accurately predict forage quality, and to some extent also quantity indicators of semiânatural grassland
Predator-induced changes of female mating preferences: innate and experiential effects
Background: In many species males face a higher predation risk than females because males display elaborate traits that evolved under sexual selection, which may attract not only females but also predators. Females are, therefore, predicted to avoid such conspicuous males under predation risk. The present study was designed to investigate predator-induced changes of female mating preferences in Atlantic mollies (Poecilia mexicana). Males of this species show a pronounced polymorphism in body size and coloration, and females prefer large, colorful males in the absence of predators. Results: In dichotomous choice tests predator-naĂŻve (lab-reared) females altered their initial preference for larger males in the presence of the cichlid Cichlasoma salvini, a natural predator of P. mexicana, and preferred small males instead. This effect was considerably weaker when females were confronted visually with the non-piscivorous cichlid Vieja bifasciata or the introduced non-piscivorous Nile tilapia (Oreochromis niloticus). In contrast, predator experienced (wild-caught) females did not respond to the same extent to the presence of a predator, most likely due to a learned ability to evaluate their predators' motivation to prey. Conclusions: Our study highlights that (a) predatory fish can have a profound influence on the expression of mating preferences of their prey (thus potentially affecting the strength of sexual selection), and females may alter their mate choice behavior strategically to reduce their own exposure to predators. (b) Prey species can evolve visual predator recognition mechanisms and alter their mate choice only when a natural predator is present. (c) Finally, experiential effects can play an important role, and prey species may learn to evaluate the motivational state of their predators. Keywords: Sexual selection; female choice; non-independent mate choice; predator recognition; Poecilia mexican
- âŠ