Predictions and measurements of isothermal flowfields in axisymmetric combustor geometries

Numerical predictions, flow visualization experiments and time-mean velocity measurements were obtained for six basic nonreacting flowfields (with inlet swirl vane angles of 0 (swirler removed), 45 and 70 degrees and sidewall expansion angles of 90 and 45 degrees) in an idealized axisymmetric combustor geometry. A flowfield prediction computer program was developed which solves appropriate finite difference equations including a conventional two equation k-epsilon eddy viscosity turbulence model. The wall functions employed were derived from previous swirling flow measurements, and the stairstep approximation was employed to represent the sloping wall at the inlet to the test chamber. Recirculation region boundaries have been sketched from the entire flow visualization photograph collection. Tufts, smoke, and neutrally buoyant helium filled soap bubbles were employed as flow tracers. A five hole pitot probe was utilized to measure the axial, radial, and swirl time mean velocity components

The effect of resin on the impact damage tolerance of graphite-epoxy laminates

The effect of the matrix resin on the impact damage tolerance of graphite-epoxy composite laminates was investigated. The materials were evaluated on the basis of the damage incurred due to local impact and on their ability to retain compression strength in the presence of impact damage. Twenty-four different resin systems were evaluated. Five of the systems demonstrated substantial improvements compared to the baseline system including retention of compression strength in the presence of impact damage. Examination of the neat resin mechanical properties indicates the resin tensile properties influence significantly the laminate damage tolerance and that improvements in laminate damage tolerance are not necessarily made at the expense of room temperature mechanical properties. Preliminary results indicate a resin volume fraction on the order of 40 percent or greater may be required to permit the plastic flow between fibers necessary for improved damage tolerance

Concepts for improving the damage tolerance of composite compression panels

The residual strength of specimens with damage and the sensitivity to damage while subjected to an applied inplane compression load were determined for flatplate specimens and blade-stiffened panels. The results suggest that matrix materials that fail by delamination have the lowest damage tolerance capability. Alternate matrix materials or laminates which are transversely reinforced suppress the delamination mode of failure and change the failure mode to transverse shear crippling which occurs at a higher strain value. Several damage-tolerant blade-stiffened panel design concepts are evaluated. Structural efficiency studies conducted show only small mass penalties may result from incorporating these damage-tolerant features in panel design. The implication of test results on the design of aircraft structures was examined with respect to FAR requirements

Underperforming policy networks : the biopesticides network in the United Kingdom

Loosely integrated and incomplete policy networks have been neglected in the literature. They are important to consider in terms of understanding network underperformance. The effective delivery and formulation of policy requires networks that are not incomplete or underperforming. The biopesticides policy network in the United Kingdom is considered and its components identified with an emphasis on the lack of integration of retailers and environmental groups. The nature of the network constrains the actions of its agents and frustrates the achievement of policy goals. A study of this relatively immature policy network also allows for a focus on network formation. The state, via an external central government department, has been a key factor in the development of the network. Therefore, it is important to incorporate such factors more systematically into understandings of network formation. Feedback efforts from policy have increased interactions between productionist actors but the sphere of consumption remains insufficiently articulated

The effect of impact damage and circular holes on the compressive strength of a graphite-epoxy laminate

Specimens were impacted by 1.27-cm-diameter aluminum spheres with speeds ranging from 52 to 101 m/s. Some specimens were impacted without any applied compressive load and then loaded to failure to determine their residual strength. Other specimens were loaded to a prescribed axial compressive strain and impacted while at that applied load. Loaded specimens that did not fail catastrophically on impact were subsequently loaded to failure to determine their residual strength. Low-velocity impact damage was found to degrade seriously the laminate static compressive strength. Low-strain compression-compression cyclic loading was found to degrade further the compressive strength of impact-damaged specimens. Specimens with circular holes having diameters up to a third of the specimen width were loaded to failure in compression. It was found that circular holes can also degrade the static compressive strength of the laminate. The effects of circular holes and impact damage on the compressive strength of the laminate are compared

Tensor Rank, Invariants, Inequalities, and Applications

Though algebraic geometry over $\mathbb C$ is often used to describe the closure of the tensors of a given size and complex rank, this variety includes tensors of both smaller and larger rank. Here we focus on the $n\times n\times n$ tensors of rank $n$ over $\mathbb C$, which has as a dense subset the orbit of a single tensor under a natural group action. We construct polynomial invariants under this group action whose non-vanishing distinguishes this orbit from points only in its closure. Together with an explicit subset of the defining polynomials of the variety, this gives a semialgebraic description of the tensors of rank $n$ and multilinear rank $(n,n,n)$. The polynomials we construct coincide with Cayley's hyperdeterminant in the case $n=2$, and thus generalize it. Though our construction is direct and explicit, we also recast our functions in the language of representation theory for additional insights. We give three applications in different directions: First, we develop basic topological understanding of how the real tensors of complex rank $n$ and multilinear rank $(n,n,n)$ form a collection of path-connected subsets, one of which contains tensors of real rank $n$. Second, we use the invariants to develop a semialgebraic description of the set of probability distributions that can arise from a simple stochastic model with a hidden variable, a model that is important in phylogenetics and other fields. Third, we construct simple examples of tensors of rank $2n-1$ which lie in the closure of those of rank $n$.Comment: 31 pages, 1 figur

Effect of Low Velocity Impact Damage on the Compressive Strength of Graphite/Epoxy Hat-Stiffened Panels

Low velocity impact damage on the compressive strength of graphite/epoxy hat stiffened panels is studied. Fourteen panels, representative of minimum-mass designs for two compression load levels were tested. Eight panels were damaged by impact and the effect on compressive strength was evaluated by comparing the results with data for undamaged panels. The impact tests consisted of firing 1.27 cm diameter aluminum projectiles normal to the plane of the panel at a velocity of approximately 55 m/sec to simulate impact from runway debris. The results of this investigation indicate that impact damage in the panels designed for 0.53 MN/m was contained locally and the damaged panels were capable of carrying the design load. The panels designed for 1.58 MN/m failed between 50 and 58 percent of the design load due to impact damage in the high axial stiffness region. The extent of damage in the high axial stiffness region of both panel designs increased with the magnitude of applied axial load. Damage in this region was the most significant factor in reducing panel strength. Limited damage that was not visually detectable reduced ultimate strength as much as extensive visible damage

A catchment-based study of endocrine disruption in surface waters: multivariate evaluation of the health of a sentinel fish species exposed to sewage treatment works effluent

Summary of the results in the context of EDCAT 5 project aims: 1. By comparing appropriate biomarkers in fish sampled from STW-impacted sites and control sites during the pre-remediation period, to determine whether there was evidence for any effects that might be attributed to the presence of estrogenic (or androgenic, or anti-androgenic/-estrogenic) endocrine disrupting chemicals in the former. This aim was addressed by measuring concentrations of the estrogen-dependent yolk protein precursor vitellogenin, and the androgen-dependent nest glue spiggin in male and female sticklebacks. In addition histological examination of the gonadal structure of fish captured at the impacted and non-impacted sites was employed to seek evidence of overt alterations in reproductive physiology of the fish. For a subset of matched samples from the two rivers, the relative induction of hepatic choriogenin mRNA, a biomarker of estrogen exposure, was measured. Conclusions: Chemistry data provided by EDCAT3&4 showed that estrogenicity of the effluent was low prior to remediation and lower still following installation of the GAC plant. No evidence of overt estrogenic effects was detected in male sticklebacks in the Ray, VTG and ChG levels were similar in males from both rivers. Nor was there any evidence of alterations in spiggin concentrations in the kidneys of males from the Ray compared to the Ock. However, VTG concentrations in female sticklebacks from the Ray were increased following the STW upgrade as were hepatic ChG transcript levels, and kidney spiggin concentrations. No changes in these elements of the reproductive system were observed in females from the Ock across the same time periods. Chemical analysis of the effluent indicated that prior to installation of the GAC plant substantial concentrations of anti-androgenic chemicals were present, together with a wide range of other organics. Concentrations of these were much reduced following the plant upgrade. It is reasonable to suppose that the changes observed in the female reproductive endocrine system following the upgrade were related to the removal of some or all of this complex mixture of chemicals. The absence of effects in males may be related to the balance between exogenous and endogenous signals, or to the specificity of effects exerted by the chemicals present. No intersex fish were detected from either river. A significant bias in favour of females was detected in the stickleback populations in both rivers suggesting a factor associated with life-history of the fish, rather than contaminant burden, was responsible. 2. By comparing appropriate biomarkers in fish sampled from STW-impacted sites and control sites during the pre-remediation period, to determine whether there was evidence for any effects that might be attributed to the presence of “conventionally” toxic chemicals. This was addressed by measurement of the activity of a key Phase I transforming enzyme in the liver of fish, either using direct enzymatic assay (EROD) or by quantifying the levels of expression of the corresponding gene (CYP1A). Conclusions: EROD activity was significantly greater in fish from the Ray than the Ock in two samples collected prior to the installation of the GAC plant (2006, 2007) and this likely reflects the differential contaminant loading in the two rivers. A single sample following the commissioning of the GAC plant (2008) indicated that EROD activity had increased among fish from the Ock while that in fish from the Ray remained unchanged. While a delayed recovery of this biomarker in fish from the Ray may be expected depending on the route of exposure (direct via water or indirect via contaminated food) the reasons for elevated EROD activity in fish from the Ock/Childrey Brook are not immediately evident. Provision of a full data set for Cyp1A expression awaits the repeat of the assay. When this is complete the factors underlying the EROD findings may become clear. 3. To determine whether the adaptive capacity and energetic status of fish varied between the STW-impacted and non-impacted sites. This was addressed by measurement of indicators of stress (whole-body corticosteroid levels), metabolic status (whole-body glucose levels) and anabolic activity (RNA:DNA ratios). Conclusions: The data provide no evidence that the stress response of fish captured in the Ray prior to installation of the GAC plant was modified by exposure to the effluent. However, large variations in whole-body corticosteroid and glucose concentrations in fish from both rivers, with clear trends over time, were closely linked to perturbations in the river flow regime. Whether there was interaction between environmental and chemical factors in determining corticosteroid and glucose status is difficult to discern but it seems likely that variation in these indicators of the stress axis was driven primarily by environmental factors. The RNA:DNA ratios were closely linked with seasonal change in temperature and closely matched observed patterns of weight and length gain in stickleback populations in the two rivers. The longer growth period enjoyed by fish in the Ray was clearly evident. For both rivers, mean anabolic activity was greater during 2008 than 2007 and it seems likely that this is related to adverse effects associated with the periods of extreme flow change observed on both rivers in 2007. 4. To assess whether there were differences in population size and structure between STW-impacted and non-impacted sites. This was addressed by comparison of key somatic measures, in particular frequency distributions for fork length. Conclusions: Because of the extreme patchiness of the distribution of stickleback populations in both rivers accurate abundance estimates were not obtained. However, the catch per unit effort across the life of the project was similar for both rivers. While population size, and age structure (both rivers hosted annual populations), appeared to be similar fish in the Ray were overall larger than those from the Ock, and spawned earlier. The differences in growth and timing of spawning between the rivers were likely to have been associated with the Rodbourne STW effluent. Downstream of the discharge on the Ray water temperatures were consistently 2 – 3oC above those of the Ock. This temperature difference, in combination with the introduction of additional nutrients into the river which is likely to have affected the availaibility of food, probably accounts for the different growth profile among the sticklebacks in the two rivers. However, over and above this difference, there was a significant increase in size of sticklebacks in the Ray between the matched pre- and post-remediation periods in the Ray while no change in size of the fish in the Ock occurred during the same period. Similarly, the RNA:DNA ratio was higher in fish from the Ock during 2007 but greater in fish from the Ray during 2008. Taken together, these observations suggest that there was an improvement in the status of the fish in the Ray following the commissioning of the GAC plant, while the population in the Ock remained relatively stable. It is reasonable to suppose that this may be linked to the reduction of the chemical load entering the Ray at Rodbourne following the installation of the GAC plant. The Ray is “cleaner” now than was the case prior to remediation but remains nutrient rich and several degrees warmer than the Ock, this combination of factors providing fish in the Ray with greater scope for growth relative to populations in the Ock

W290-B Diagnosing Suspected Off-Target Herbicide Damage to Tobacco

Herbicide Stewardship Publicatio

Recent development in the design, testing and impact-damage tolerance of stiffened composite panels

Structural technology of laminated filamentary-composite stiffened-panel structures under combined inplane and lateral loadings is discussed. Attention is focused on: (1) methods for analyzing the behavior of these structures under load and for determining appropriate structural proportions for weight-efficient configurations; and (2) effects of impact damage and geometric imperfections on structural performance. Recent improvements in buckling analysis involving combined inplane compression and shear loadings and transverse shear deformations are presented. A computer code is described for proportioning or sizing laminate layers and cross-sectional dimensions, and the code is used to develop structural efficiency data for a variety of configurations, loading conditions, and constraint conditions. Experimental data on buckling of panels under inplane compression is presented. Mechanisms of impact damage initiation and propagation are described