A self-organized model for cell-differentiation based on variations of molecular decay rates

Systemic properties of living cells are the result of molecular dynamics governed by so-called genetic regulatory networks (GRN). These networks capture all possible features of cells and are responsible for the immense levels of adaptation characteristic to living systems. At any point in time only small subsets of these networks are active. Any active subset of the GRN leads to the expression of particular sets of molecules (expression modes). The subsets of active networks change over time, leading to the observed complex dynamics of expression patterns. Understanding of this dynamics becomes increasingly important in systems biology and medicine. While the importance of transcription rates and catalytic interactions has been widely recognized in modeling genetic regulatory systems, the understanding of the role of degradation of biochemical agents (mRNA, protein) in regulatory dynamics remains limited. Recent experimental data suggests that there exists a functional relation between mRNA and protein decay rates and expression modes. In this paper we propose a model for the dynamics of successions of sequences of active subnetworks of the GRN. The model is able to reproduce key characteristics of molecular dynamics, including homeostasis, multi-stability, periodic dynamics, alternating activity, differentiability, and self-organized critical dynamics. Moreover the model allows to naturally understand the mechanism behind the relation between decay rates and expression modes. The model explains recent experimental observations that decay-rates (or turnovers) vary between differentiated tissue-classes at a general systemic level and highlights the role of intracellular decay rate control mechanisms in cell differentiation.Comment: 16 pages, 5 figure

Practical recipes for the model order reduction, dynamical simulation, and compressive sampling of large-scale open quantum systems

This article presents numerical recipes for simulating high-temperature and non-equilibrium quantum spin systems that are continuously measured and controlled. The notion of a spin system is broadly conceived, in order to encompass macroscopic test masses as the limiting case of large-j spins. The simulation technique has three stages: first the deliberate introduction of noise into the simulation, then the conversion of that noise into an equivalent continuous measurement and control process, and finally, projection of the trajectory onto a state-space manifold having reduced dimensionality and possessing a Kahler potential of multi-linear form. The resulting simulation formalism is used to construct a positive P-representation for the thermal density matrix. Single-spin detection by magnetic resonance force microscopy (MRFM) is simulated, and the data statistics are shown to be those of a random telegraph signal with additive white noise. Larger-scale spin-dust models are simulated, having no spatial symmetry and no spatial ordering; the high-fidelity projection of numerically computed quantum trajectories onto low-dimensionality Kahler state-space manifolds is demonstrated. The reconstruction of quantum trajectories from sparse random projections is demonstrated, the onset of Donoho-Stodden breakdown at the Candes-Tao sparsity limit is observed, a deterministic construction for sampling matrices is given, and methods for quantum state optimization by Dantzig selection are given.Comment: 104 pages, 13 figures, 2 table

Identifying robust subspaces for dynamically consistent reduced-order models

Nonlinear models for large/complex structures are hard to simulate for parametric studies of long-time dynamical behaviors. Reduced order models (ROMs) provide tools that both allow long-time dynamical simulations and reduce data storage requirements. In data-based model reduction, there is usually no consistent way to determine if the obtained ROM is robust to the variations in system parameters. Here, we use two concepts of dynamical consistency and subspace robustness to evaluate ROMs validity for parametric studies. The application of these concepts is demonstrated by reducing a nonlinear finite element model of a cantilever beam in a two well potential field. The resulting procedure can be used for developing and evaluating ROMs that are robust to the variations in the parameters or operating conditions. © The Society for Experimental Mechanics, Inc. 2014