380 research outputs found
The edge effect of specimens in abrasive wear testing
In abrasive wear testing, the specimen edges may exhibit increased wear rates. To determine the extent of edge wear, a series of tests was conducted with the crushing pin-on-disk device. The test pin was divided into two sections, separating the wear area into inner and outer pin areas. The tests were conducted with granite and quartz rocks of varying size.
The edge effect was determined as the difference of the mass loss of a specimen comprising both the inner and outer parts and the mass loss of the inner part alone scaled to the size of the combined pin area, representing a specimen without edge wear. The tests showed increased edge effect with larger rocks, depending on the mechanical strength of the abrasive material. When using only large rocks with good mechanical strength, the edge effect could be as high as 50 % of the total specimen mass loss, whereas with more fragile rocks of smaller size, the edge effect was close to 0 %
Laser Spectroscopy of Niobium Fission Fragments: First Use of Optical Pumping in an Ion Beam Cooler Buncher
A new method of optical pumping in an ion beam cooler buncher has been developed to selectively enhance ionic metastable state populations. The technique permits the study of elements previously inaccessible to laser spectroscopy and has been applied here to the study of Nb. Model independent mean-square charge radii and nuclear moments have been studied for Nb to cover the region of the N=50 shell closure and N≈60 sudden onset of deformation. The increase in mean-square charge radius is observed to be less than that for Y, with a substantial degree of β softness observed before and after N=60
Q_EC values of the Superallowed beta-Emitters 10-C, 34-Ar, 38-Ca and 46-V
The Q_EC values of the superallowed beta+ emitters 10-C, 34-Ar, 38-Ca and
46-V have been measured with a Penning-trap mass spectrometer to be 3648.12(8),
6061.83(8), 6612.12(7) and 7052.44(10) keV, respectively. All four values are
substantially improved in precision over previous results.Comment: 9 pages, 7 figures, 5 table
Mass measurements in the vicinity of the doubly-magic waiting point 56Ni
Masses of 56,57Fe, 53Co^m, 53,56Co, 55,56,57Ni, 57,58Cu, and 59,60Zn have
been determined with the JYFLTRAP Penning trap mass spectrometer at IGISOL with
a precision of dm/m \le 3 x 10^{-8}. The QEC values for 53Co, 55Ni, 56Ni, 57Cu,
58Cu, and 59Zn have been measured directly with a typical precision of better
than 0.7 keV and Coulomb displacement energies have been determined. The Q
values for proton captures on 55Co, 56Ni, 58Cu, and 59Cu have been measured
directly. The precision of the proton-capture Q value for 56Ni(p,gamma)57Cu,
Q(p,gamma) = 689.69(51) keV, crucial for astrophysical rp-process calculations,
has been improved by a factor of 37. The excitation energy of the proton
emitting spin-gap isomer 53Co^m has been measured precisely, Ex = 3174.3(10)
keV, and a Coulomb energy difference of 133.9(10) keV for the 19/2- state has
been obtained. Except for 53Co, the mass values have been adjusted within a
network of 17 frequency ratio measurements between 13 nuclides which allowed
also a determination of the reference masses 55Co, 58Ni, and 59Cu.Comment: 14 pages, 13 figures, submitted to Phys. Rev.
Resonance ionization spectroscopy of thorium isotopes - towards a laser spectroscopic identification of the low-lying 7.6 eV isomer of Th-229
In-source resonance ionization spectroscopy was used to identify an efficient
and selective three step excitation/ionization scheme of thorium, suitable for
titanium:sapphire (Ti:sa) lasers. The measurements were carried out in
preparation of laser spectroscopic investigations for an identification of the
low-lying Th-229m isomer predicted at 7.6 +- 0.5 eV above the nuclear ground
state. Using a sample of Th-232, a multitude of optical transitions leading to
over 20 previously unknown intermediate states of even parity as well as
numerous high-lying odd parity auto-ionizing states were identified. Level
energies were determined with an accuracy of 0.06 cm-1 for intermediate and
0.15 cm-1 for auto-ionizing states. Using different excitation pathways an
assignment of total angular momenta for several energy levels was possible. One
particularly efficient ionization scheme of thorium, exhibiting saturation in
all three optical transitions, was studied in detail. For all three levels in
this scheme, the isotope shifts of the isotopes Th-228, Th-229, and Th-230
relative to Th-232 were measured. An overall efficiency including ionization,
transport and detection of 0.6 was determined, which was predominantly limited
by the transmission of the mass spectrometer ion optics
Effects or anaesthesia method and tourniquet use on recovery following total knee arthroplasty : a randomised controlled study
Background: We investigated the effects of spinal and general anaesthesia and surgical tourniquet on acute pain and early recovery after total knee arthroplasty (TKA). Methods: Patients (n=413) were randomised to four parallel groups: spinal anaesthesia with or without tourniquet, and general anaesthesia with or without tourniquet. The primary outcome was patient-controlled i.v. oxycodone consumption over 24 postoperative hours. Results: Results from 395 subjects were analysed. Median i.v. oxycodone consumption did not differ between the four groups (spinal anaesthesia without [36.6 mg] and with tourniquet [38.0 mg], general anaesthesia without [42.3 mg] and with tourniquet [42.5 mg], P=0.42), between spinal (37.7 mg) and general anaesthesia (42.5 mg) groups (median difference -3.1, 95% confidence interval [CI] -7.4 to 1.2, P=0.15) and between tourniquet and no-tourniquet groups (40.0 vs 40.0 mg, median difference -0.8, CI -5.1 to 3.5, P=0.72). Vomiting incidence was higher with spinal than with general anaesthesia (21% [42/200] vs 13% [25/194], CI 1.05 to 3.1, P=0.034). The mean haemoglobin decrease was greater without than with tourniquet (-3.0 vs -2.5 g dl(-1), mean difference -0.48, CI -0.65 to -0.32, P Conclusions: For TKA, spinal and general anaesthesia with or without tourniquet did not differ in 24-h postoperative opioid consumption, pain management, blood transfusions, in-hospital complications, and length of hospital stay. Vomiting incidence was higher in the spinal than in the general anaesthesia group. Tourniquet use caused smaller decreases in haemoglobin levels.Peer reviewe
Local edge computing for radiological image reconstruction and computer-assisted detection: A feasibility study
Computational requirements for data processing at different stages of the radiology value chain are increasing. Cone beam computed tomography (CBCT) is a diagnostic imaging technique used in dental and extremity imaging, involving a highly demanding image reconstruction task. In turn, artificial intelligence (AI) assisted diagnostics are becoming increasingly popular, thus increasing the use of computation resources. Furthermore, the need for fully independent imaging units outside radiology departments and with remotely performed diagnostics emphasize the need for wireless connectivity between the imaging unit and hospital infrastructure. In this feasibility study, we propose an approach based on a distributed edge-cloud computing platform, consisting of small-scale local edge nodes, edge servers with traditional cloud resources to perform data processing tasks in radiology. We are interested in the use of local computing resources with Graphics Processing Units (GPUs), in our case Jetson Xavier NX, for hosting the algorithms for two use-cases, namely image reconstruction in cone beam computed tomography and AI-assisted cancer detection from mammographic images. Particularly, we wanted to determine the technical requirements for local edge computing platform for these two tasks and whether CBCT image reconstruction and breast cancer detection tasks are possible in a diagnostically acceptable time frame. We validated the use-cases and the proposed edge computing platform in two stages. First, the algorithms were validated use-case-wise by comparing the computing performance of the edge nodes against a reference setup (regular workstation). Second, we performed qualitative evaluation on the edge computing platform by running the algorithms as nanoservices. Our results, obtained through real-life prototyping, indicate that it is possible and technically feasible to run both reconstruction and AI-assisted image analysis functions in a diagnostically acceptable computing time. Furthermore, based on the qualitative evaluation, we confirmed that the local edge computing capacity can be scaled up and down during runtime by adding or removing edge devices without the need for manual reconfigurations. We also found all previously implemented software components to be transferable as such. Overall, the results are promising and help in developing future applications, e.g., in mobile imaging scenarios, where such a platform is beneficial
- …