982 research outputs found
Properties of Cu(In,Ga) Se2 Thin Films and Solar Cells Deposited by Hybrid Process
Cu(In,Ga)Se-2 solar cells were fabricated using a hybrid cosputtering/evaporation process, and efficiencies as high as 12.4% were achieved. The films were characterized by energy-dispersive X-ray spectroscopy, glancing incidence X-ray diffraction, scanning electron microscopy, auger electron spectroscopy, and transmittance and reflectance spectroscopy, and their properties were compared to the ones of films deposited by coevaporation. Even though the films were relatively similar, the ones deposited by the hybrid process tend to have smaller grains with a slightly preferred orientation along the (112) axis and a rougher surface. Both types of films have uniform composition through the depth. Characterization of these films by variable angle of incidence spectroscopic ellipsometry allowed for the calculation of the position of the critical points, via calculation of the second derivative of the dielectric function and fit with critical points parabolic band oscillators. The solar cells were then characterized by current-voltage and quantum efficiency measurements. An analysis of the diode parameters indicates that the cells are mostly limited by a low fill factor, associated mostly with a high diode quality factor (A - 1.8) and high series resistance (R-s similar to 1.1 Omega-cm(2))
Agro-morphological Diversity of High Altitude Bean Landraces in the Kailash Sacred Landscape of Nepal
Many varieties of bean are widely grown across diverse agro-ecological zones in Nepal. And opportunities exist for improving the crops and enhancing their resilience to various biotic and abiotic stressors. In this context, an experiment was conducted from June to October 2016 in Khar VDC of Darchula district to study the phenotypic traits of nine landraces of bean (Phaseolus vulgaris L.). The bean landraces were planted using randomized complete block design in three sites (Dhamidera, Dallekh and Sundamunda villages), with three replications in each site for their comparative analysis. The study considered the following phenotypic traits: days to emergence, days to 50% flowering, days to 90% pod maturity, number of nodes, pod length, pod width, number of pods, number of seeds per pod and weight and grain yield for 100 seeds. Kruskal-Wallis test showed significant differences in the landraces both within and among locations. KA-17-08-FB and KA-17-04-FB were late flowering (63 and 65 days respectively) compared to other landraces whereas KA-17-07-FB flowered earliest (within 42 days). In all three sites, three landraces namely KA-17-07-FB, KA-17-04-FB and KA-17-06-FB were found to be relatively more resistant to pest and diseases than other landraces. Eight out of nine landraces in Dhamidera and Dallekh villages and seven out of nine in Sundamunda village produced seeds greater than 1.0 t/ha. Among the nine varieties KA-17-02-FB was the highest yielding variety, with an average yield of 3.8 t/ha. This study is useful for identifying suitable landraces for future promotion based on their maturity, grain yield, diseases resistance and other qualitative and quantitative characteristics
In Situ and Ex Situ Studies of Molybdenum Thin Films Deposited by rf and dc Magnetron Sputtering as a Back Contact for CIGS Solar Cells
Molybdenum thin films were deposited by rf and dc magnetron sputtering and their properties analyzed with regards to their potential application as a back contact for CIGS solar cells. It is shown that both types of films tend to transition from tensile to compressive strain when the deposition pressure increases, while the conductivity and the grain size decreas. The nucleation of the films characterized by in situ and real time spectroscopic ellipsometry shows that both films follow a Volmer-Weber growth, with a higher surface roughness and lower deposition rate for the rf deposited films. The electronic relaxation time was then extracted as a function of bulk layer thickness for rf and dc films by fitting each dielectric function to a Drude free-electron model combined with a broad Lorentz oscillator. The values were fitted to a conical growth mode and demonstrated that the rf-deposited films have already smaller grains than the dc films when the bulk layer thickness is 30 nm
Black diholes in five dimensions
Using a generalized Weyl formalism, we show how stationary, axisymmetric
solutions of the four-dimensional vacuum Einstein equation can be turned into
static, axisymmetric solutions of five-dimensional dilaton gravity coupled to a
two-form gauge field. This procedure is then used to obtain new solutions of
the latter theory describing pairs of extremal magnetic black holes with
opposite charges, known as black diholes. These diholes are kept in static
equilibrium by membrane-like conical singularities stretching along two
different directions. We also present solutions describing diholes suspended in
a background magnetic field, and with unbalanced charges.Comment: 21 pages, 2 figures; reference adde
- …