29,322 research outputs found
Limit cycles of a flexible shaft with hydrodynamic journal bearings in unstable regimes
A symmetric 3 mass rotor supported on hydrodynamic bearings is described. An approximate method of representing finite bearings is used to calculate bearing forces. As the method sums forces from a number of independent circular lobes lemon 3 and 4 lobe bearings are taken into account. The calculations are based on an axial groove bearing. Linear analysis precedes nonlinear simulation of some unstable conditions. The demonstration of small limit cycles suggests that necessarily flexible rotors e.g., helicopter tail rotors, may be practical without either tilt pad bearings or external dampers
Aerodynamic design and performance testing of an advanced 30 deg swept, eight bladed propeller at Mach numbers from 0.2 to 0.85
The increased emphasis on fuel conservation in the world has stimulated a series of studies of both conventional and unconventional propulsion systems for commercial aircraft. Preliminary results from these studies indicate that a fuel saving of from 15 to 28 percent may be realized by the use of an advanced high speed turboprop. The turboprop must be capable of high efficiency at Mach 0.8 above 10.68 km (35,000 ft) altitude if it is to compete with turbofan powered commercial aircraft. An advanced turboprop concept was wind tunnel tested. The model included such concepts as an aerodynamically integrated propeller/nacelle, blade sweep and power (disk) loadings approximately three times higher than conventional propeller designs. The aerodynamic design for the model is discussed. Test results are presented which indicate propeller net efficiencies near 80 percent were obtained at high disk loadings at Mach 0.8
Numerical studies of collapsing interstellar clouds
Numerical simulation of the structure and evolution of interstellar clouds was initiated. Steps were taken toward an integrated treatment of the dynamical, thermal, and chemical processes entering model calculations. A detailed study was made of radiative transfer in molecular lines to allow model predictions to be tested against empirical data. The calculations have successfully reproduced and explained several observed cloud properties, including abundances of complex molecular species and the apparent depletion of CO in dense cores
Recommended from our members
Age-related changes to lumbosacral spinal cord motoneurons that modulate bladder and bowel functions in male C57BL/6 mice
Incontinence and sexual dysfunction are often increased in the aged human population. In rats and mice the pattern of micturition and faecal clearance also changes with ageing and is suggestive of bladder and bowel dysfunction
New nickel-base wrought superalloy with applications up to 1253 K (1800 F)
Alloy possesses combination of high tensile strength at low and intermediate temperatures to 1033 K with good rupture strength at high temperatures to 1255 K. Alloy has promise for turbine disk application in future gas turbine engines and for wrought integrally bladed turbine wheel; thickness and weight of disk portion of wheel could be reduced
National Transonic Facility: A review of the operational plan
The proposed National Transonic Facility (NTF) operational plan is reviewed. The NTF will provide an aerodynamic test capability significantly exceeding that of other transonic regime wind tunnels now available. A limited number of academic research program that might use the NTF are suggested. It is concluded that the NTF operational plan is useful for management, technical, instrumentation, and model building techniques available in the specialized field of aerodynamic analysis and simulation. It is also suggested that NASA hold an annual conference to discuss wind tunnel research results and to report on developments that will further improve the utilization and cost effectiveness of the NTF and other wind tunnels
Structure, bonding and morphology of hydrothermally synthesised xonotlite
The authors have systematically investigated the role of synthesis conditions upon the structure and morphology of xonotlite. Starting with a mechanochemically prepared, semicrystalline phase with Ca/Si=1, the authors have prepared a series of xonotlite samples hydrothermally, at temperatures between 200 and 250 degrees C. Analysis in each case was by X-ray photoelectron spectroscopy, environmental scanning electron microscopy and X-ray diffraction. The authors’ use of a much lower water/solid ratio has indirectly confirmed the ‘through solution’ mechanism of xonotlite formation, where silicate dissolution is a key precursor of xonotlite formation. Concerning the role of temperature, too low a temperature (~200 degrees C) fails to yield xonotlite or leads to increased number of structural defects in the silicate chains of xonotlite and too high a temperature (>250 degrees C) leads to degradation of the xonotlite structure, through leaching of interchain calcium. Synthesis duration meanwhile leads to increased silicate polymerisation due to diminishing of the defects in the silicate chains and more perfect crystal morphologies
Molecular clouds in the centers of galaxies: Constraints from HCN and CO-13 line emission
We have searched for HCN J=1-0 line emission in the centers of 12 galaxies and have detected it in 10 of them. We have obtained complementary data on J=1-0 and 2-1 transitions of CO-12 and CO-13 in these systems. The ratio of integrated intensities, I(CO 1-0)/I(HCN 1-0) = 25 +/- 11 for this sample. We find that HCN emission of this strength can be produced under conditions of subthermal excitation. In combination with the line ratios in CO and CO-13, HCN puts constraints on the mean conditions of molecular clouds and on the mix of cloud types within the projected beam
Investigating the nature of the Fried Egg nebula: CO mm-line and optical spectroscopy of IRAS 17163-3907
Through CO mm-line and optical spectroscopy, we investigate the properties of
the Fried Egg nebula IRAS 17163-3907, which has recently been proposed to be
one of the rare members of the yellow hypergiant class. The CO J=2-1 and J=3-2
emission arises from a region within 20" of the star and is clearly associated
with the circumstellar material. The CO lines show a multi-component
asymmetrical profile, and an unexpected velocity gradient is resolved in the
east-west direction, suggesting a bipolar outflow. This is in contrast with the
apparent symmetry of the dust envelope as observed in the infrared. The optical
spectrum of IRAS 17163-3907 between 5100 and 9000 {\AA} was compared with that
of the archetypal yellow hypergiant IRC+10420 and was found to be very similar.
These results build on previous evidence that IRAS 17163-3907 is a yellow
hypergiant.Comment: 14 pages including appendix, accepted for publication in A&
Risk of cancer following primary total hip replacement or primary resurfacing arthroplasty of the hip : A retrospective cohort study in Scotland
Acknowledgements: We are grateful to Lee Barnsdale, Doug Clark, and Richard Dobbie for advice and assistance with data preparation before analysis, and to the three anonymous referees for their helpful comments and suggestions.Peer reviewedPublisher PD
- …