5 research outputs found
Microstructure and texture evolutions in FeCrAl cladding tube during pilger processing
The microstructure of FeCrAl cladding tubes depends on the fabricating process history. In this study, the microstructural characteristics of wrought FeCrAl alloys during industrial pilger processing into thin-walled tubes were investigated. The hot extruded tube showed ∼100 μm equiaxed grains with weak α∗-fiber in {h11}<1/h12> texture, while pilger rolling process change the microstructure to fragmented and elongated grains along the rolling direction. The pilgered textures could be predicted with the VPSC model. The inter-pass annealing at 800–850 \ub0C for 1 h results in recovery and recrystallization of the ferric matrix and restoration of ductility. The final finished tube shows fine recrystallized grains (∼11 μm) with dominant γ-fiber in three dimensions. Pilger rolling enhanced α-fiber while annealing reduced α-fiber and enhanced γ-fiber. Microstructural evolution in the Laves precipitates followed the sequence of faceted needle-like → spherical → faceted ellipsoidal. Thermomechanical processing resulted in cladding tubes with an area fraction of ∼5% and a number density of 5
7 10−11 m−2 in Laves precipitates, which is half that of the first-pilgered tube. Laves precipitates pin the grain boundaries to control the microstructure and prevent grain coarsening
Recrystallization and texture evolution of cold pilgered FeCrAl cladding tube during annealing at 700 \ub0C∼1000 \ub0C
FeCrAl alloys are being developed as potential accident-tolerant fuel cladding materials for the light water reactors due to significantly improved steam oxidation and good mechanical properties at high temperatures. In this study, the recrystallization and texture evolution of the cold pilgered FeCrAl cladding tube was investigated by means of hardness measurements and electron backscatter diffraction (EBSD) during annealing at 700∼1000 \ub0C. The partially recrystallized maps were deconstructed into deformed, recovered, and recrystallized grain fractions based on the critical internal misorientation angle. In the early stages of recrystallization, cold pilgered cladding tubes contained a mixture of discontinuously recrystallized {111}<110> newly nucleated grains and heterogeneous deformed 〈110〉 orientation grains. The deformed microstructural inhomogeneity state could be explained based on the Taylor factor. The rate of recrystallization increased with increasing annealing temperature, which was described by the Johnson-Mehl-Avrami-Kolmogorov equation. The cladding tube showed slow recrystallization kinetics and thermally stable grains due to the pinning of the grain boundaries by the Laves precipitates. The dominant α-fiber decreased and γ-fiber increased with increasing recrystallization fraction in the cold pilgered tubes. The high area fraction and stable γ-fiber would be beneficial to the processability of the cladding tube