Programmable digital modem

The design of the Programmable Digital Modem (PDM) is outlined. The PDM will be capable of operating with numerous modulation techniques including: 2-, 4-, 8- and 16-ary phase shift keying (PSK), minimum shift keying (MSK), and 16-ary quadrature amplitude modulation (QAM), with spectral occupancy from 1.2x to 2x the data symbol rate. It will also be programmable for transmission rates ranging from 2.34 to 300 Mbit/s, where the maximum symbol rate is 75 Msymbol/s. Furthermore, these parameters will be executable in independent burst, dependent burst, or continuous mode. In dependent burst mode the carrier and clock oscillator sources are common from burst to burst. To achieve as broad a set of requirements as these, it is clear that the essential signal processing must be digital. In addition, to avoid hardware changes when the operational parameters are changed, a fixed interface to an analog intermediate frequency (IF) is necessary for transmission; and, common system level architectures are necessary for the modulator and demodulator. Lastly, to minimize size and power, as much of the design as possible will be implemented with application specific integrated circuit (ASIC) chips

On-board demux/demod

To make satellite channels cost competitive with optical cables, the use of small, inexpensive earth stations with reduced antenna size and high powered amplifier (HPA) power will be needed. This will necessitate the use of high e.i.r.p. and gain-to-noise temperature ratio (G/T) multibeam satellites. For a multibeam satellite, onboard switching is required in order to maintain the needed connectivity between beams. This switching function can be realized by either an receive frequency (RF) or a baseband unit. The baseband switching approach has the additional advantage of decoupling the up-link and down-link, thus enabling rate and format conversion as well as improving the link performance. A baseband switching satellite requires the demultiplexing and demodulation of the up-link carriers before they can be switched to their assigned down-link beams. Principles of operation, design and implementation issues of such an onboard demultiplexer/demodulator (bulk demodulator) that was recently built at COMSAT Labs. are discussed