Preliminary results of spectral reflectance studies of tycho crater

The preliminary analysis and interpretation of near infrared spectra obtained for both the interior and exterior deposits associated with the Tycho crater is presented. Specific objectives were: (1) to determine the composition and stratigraphy of the highland crust in the Tycho target site; (2) to determine the likely composition of the primary ejecta which may be present in ray deposits; (3) to investigate the nature of spectral units defined in previous studies; (4) to further investigate the nature and origin of both the bright and dark haloes around the rim crest; and (5) to compare the compositions determined for the Tycho units with those of the Aristarchus crater as well as typical highland deposits. The spectra obtained for the interior areas exhibit similar spectral features. These include relatively strong 1 micron absorption bands whose minima are centered between 0.97 and 0.99 microns and shallow to intermediate continuum slopes. The spectra generally exhibit indications of a 1.3 micron feature consistent with the presence of Fe(2+) bearing plagioclase feldspar. The strong 1 micron absorption features indicate a dominant high Ca clinopyroxene component. Results obtained from the ejecta deposits show that the spectrum of the inner, bright halo is almost identical with those obtained for interior units. The spectrum of the dark halo exhibits a wide, relatively shallow absorption feature centered at 1.01 microns, a 1.3 micron absorption, and a steep continuum slope. This spectrum is interpreted as indicating the presence of pyroxene, Fe-bearing feldspar, and a significant component of Fe-bearing impact melt glass. Finally, the spectra of spots inside Tycho show similarity with certain spectra for Aristarchus. However, the suite of spectra obtained for Tycho exhibits a different trend in terms of band center versus width

Contrast-enhanced ultrasound as support for prostate brachytherapy treatment planning

Purpose: To investigate the possibility of localization of intraprostatic lesions (IL) with contrast-enhanced ultrasound (CEUS) to support the brachytherapy treatment planning of temporary implants. Material and methods: Two brachytherapy treatment plans were generated for 8 patients treated with external beam radiotherapy and pulsed-dose rate brachytherapy boost for prostate cancer. The first and second brachytherapy treatment plan was without and with knowledge of the localization of the ILs, respectively. Pairwise comparison was performed on prostate, rectum, and urethra dose-volume parameters and total reference air kerma (TRAK)-values. Results: Coverage of the ILs by the 140% isodose was increased from mean 66.0-67.7% for the standard plan to mean 92.5-95.7% for the adapted plan. The mean D90 of the ILs increased from 1.49-1.57 Gy/pulse to 1.76-1.81 Gy/pulse. Dose-volume parameters for the prostate, rectum, and urethra and the TRAK did not change. Conclusions: CEUS technique is a promising method for IL localization to aid in brachytherapy treatment planning. Dose coverage on the IL could be improved without any increase of dose in organs at ris

Supportive Care in Older Adults with Cancer: Across the Continuum

Supportive care is an essential component of anti-cancer treatment regardless of age or treatment intent. As the number of older adults with cancer increases, and supportive care strategies enable more patients to undergo treatment, greater numbers of older patients will become cancer survivors. These patients may have lingering adverse effects from treatment and will need continued supportive care interventions. Older adults with cancer benefit from geriatric assessment (GA)-guided supportive care interventions. This can occur at any stage across the cancer treatment continuum. As a GA commonly uncovers issues potentially unrelated to anti-cancer treatment, it could be argued that the assessment is essentially a supportive care strategy. Key aspects of a GA include identification of comorbidities, assessing for polypharmacy, screening for cognitive impairment and delirium, assessing functional status, and screening for psychosocial issues. Treatment-related issues of particular importance in older adults include recognition of increased bone marrow toxicity, management of nausea and vomiting, identification of anemia, and prevention of neurotoxicity. The role of physical therapy and cancer rehabilitation as a supportive care strategy in older adults is important regardless of treatment stage or intent

Pesticide Use in South Africa: One of the Largest Importers of Pesticides in Africa

South Africa is a diverse country, with a diverse environment that is home to more than 49 000 000 people. Pesticide usage is very often necessary to maintain both agricultural productivity as well as human health. The climatic conditions range from semi-tropic to semi-arid regions. Although the majority of the country has summer rainfall, the south western coastal region is predominantly a winter rainfall area. These variations in climate allows for a wide variety of crops, from tropical fruit to maize and tree plantations. Each individual crop is susceptible to a unique host of pests that in-turn require a unique mixture of pesticides to ensure the best resulting turnover. Currently, South Africa has more than 500 registered pesticides (Pesticide Action Network (PAN), 2010) and is one of the four largest importers of pesticides in sub-Saharan Africa (Osbanjo et al., 2002). In 2006 the import of insecticides, fungicides and herbicides that were packaged for retail totalled $ 170 056 000 the main import partners being Australia, China, Germany and the United States of America (USA) (International Trade Centre, 2011). These pesticides are used in almost every facet of our everyday lives; ensuring the quantity and quality of food we eat to managing the number of rodents and insects in our homes. Although it is evident that there is a vast amount of pesticides present in the South African environment, there is very limited data on the production of pesticides. The last published data indicates that in 2002 around 10 000 kℓ of liquid insecticides was produced exclusively for crop protection of which 43% consisted of organophosphates. During the same year 2 800-tonnes of solid insecticides were produced (Statistics South Africa, 2003). Although the usefulness of pesticides cannot be denied, the negative environmental and human health effects cannot be ignored. In South Africa, a number of environmental and anthropogenic factors have to be considered before the impact of large-scale pesticide use can be assessed. South Africa is a water poor country, with water resources being utilised to their maximum capacity. As discussed by Dabrowski et al. (2009), the trade-off between the economic benefits of exporting agricultural products has to be measured against the loss of water, not only through crop irrigation but also through water quality degradation. The article highlighted this aspect through the calculation of virtual water volumes. These calculated volumes indicated that to ensure sufficient dilution of all agrochemicals, to an acceptable water quality level (used in a typical farming situation applying current-use pesticides), was greater than the amount of water needed for irrigation. The seriousness of these scenarios is highlighted in literature where a diverse array of agricultural chemicals has been measured during run-off events, by once-off sampling and by water monitoring during the growing seasons. Detectable levels of atrazine, terbuthylazine, simazine, acetochlor (Du Preez et al., 2005), DDT and its metabolites, endosulfan, hexachlorocyclohexane (HCH), heptachlor, aldrin, dieldrin, endrin, chlordane (Fatoki et al., 2003), azinophos-methyl, chloropyriphos (Schultz et al., 2001; Dabrowski et al., 2002) prothiofos (Schultz, 2001), malathion, zendoxsulfan (Thiere &  Schultz, 2004), cypermethrin and fenvalerate (Bollmohr et al., 2007), to name a few, have all been measured in South African waters. Pesticides in the aquatic environment have the potential to affect all end-users, including both humans and wildlife. South Africa has the distinction of being one of the countries with the most species richness in the world. To date more than 900 bird species as well as over 200 mammals, call South Africa home. Of these mammals, seven species are endangered and 30 are vulnerable according to the 2004 IUCN red data list (IUCN, 2010). These endangered species include bats, moles, shrews and mice that are often insectivorous, thus increasing their risk of unintentional exposure to pesticides. Within avian populations, 11 species are listed as critically endangered and 43 species as vulnerable. The sensitivity of avian species to pollutants has been widely reported. With this unique diversity of species, South Africans have a responsibility towards maintaining the viability of ecosystems and natural habitats to ensure the continued existence of these creatures. This objective is not only morally relevant but also economically relevant especially in a country where tourism creates over 400 000 jobs and contributes approximately 8% to the GDP. Few studies have reported the levels of insecticides in wildlife species. However, pesticides have been detected in wild bird species (Van Wyk et al., 2001; Bouwman et al., 2008), as well as in indigenous fish species (Barnhoorn et al., 2009), indicating pesticide contamination within various habitats. This is of particular concern due to the health risks associated with many pesticides

Selecting and Certifying a Landing Site for Moonrise in South Pole-Aitken Basin

MoonRise is a New Frontiers mission concept to land in the South Pole-Aitken (SPA) basin, collect samples, and return the samples to Earth for detailed mineral, chemical, petrologic, geochronologic, and physical properties analyses to address science questions relevant to the early evolution of the Solar System and the Moon. Science associated with this mission concept is described elsewhere; here we discuss selection of sites within SPA to address science objectives using recent scientific studies (orbital spectroscopy, gravity, topography), and the use of new data (LRO) to certify safe landing sites for a robotic sample return mission such as MoonRise

The Benefits of Sample Return: Connecting Apollo Soils and Diviner Lunar Radiometer Remote Sensing Data

The Diviner Lunar Radiometer, onboard NASA's Lunar Reconnaissance Orbiter, has produced the first global, high resolution, thermal infrared observations of an airless body. The Moon, which is the most accessible member of this most abundant class of solar system objects, is also the only body for which we have extraterrestrial samples with known spatial context. Here we present the results of a comprehensive study to reproduce an accurate simulated lunar environment, evaluate the most appropriate sample and measurement conditions, collect thermal infrared spectra of a representative suite of Apollo soils, and correlate them with Diviner observations of the lunar surface. We find that analyses of Diviner observations of individual sampling stations and SLE measurements of returned Apollo soils show good agreement, while comparisons to thermal infrared reflectance under terrestrial conditions do not agree well, which underscores the need for SLE measurements and validates the Diviner compositional dataset. Future work includes measurement of additional soils in SLE and cross comparisons with measurements in JPL Simulated Airless Body Emission Laboratory (SABEL)

Connecting Returned Apollo Soils and Remote Sensing: Application to the Diviner Lunar Radiometer

The Diviner Lunar Radiometer, onboard NASA's Lunar Reconnaissance Orbiter, has produced the first global, high resolution, thermal infrared observations of an airless body. The Moon, which is the most accessible member of this most abundant class of solar system objects, is also the only body for which we have extraterrestrial samples with known spatial context, returned Apollo samples. Here we present the results of a comprehensive study to reproduce an accurate simulated lunar environment, evaluate the most appropriate sample and measurement conditions, collect thermal infrared spectra of a representative suite of Apollo soils, and correlate them with Diviner observations of the lunar surface. It has been established previously that thermal infrared spectra measured in simulated lunar environment (SLE) are significantly altered from spectra measured under terrestrial or martian conditions. The data presented here were collected at the University of Oxford Simulated Lunar Environment Chamber (SLEC). In SLEC, we simulate the lunar environment by: (1) pumping the chamber to vacuum pressures (less than 104 mbar) sufficient to simulate lunar heat transport processes within the sample, (2) cooling the chamber with liquid nitrogen to simulate radiation to the cold space environment, and (3) heating the samples with heaters and lamp to setup thermal gradients similar to those experienced in the upper hundreds of microns of the lunar surface. We then conducted a comprehensive suite of experiments using different sample preparation and heating conditions on Apollo soils 15071 (maria) and 67701 (highland) and compared the results to Diviner noontime data to select the optimal experimental conditions. This study includes thermal infrared SLE measurements of 10084 (A11 - LM), 12001 (A12 - LM), 14259 (A14 - LM), 15071 (A15 - S1), 15601 (A15 - S9a), 61141 (A16 - S1), 66031 (A16 - S6), 67701 (A16 - S11), and 70181 (A17 - LM). The Diviner dataset includes all six Apollo sites at approximately 200 m spatial resolution We find that analyses of Diviner observations of individual sampling stations and SLE measurements returned Apollo soils show good agreement, while comparisons to thermal infrared reflectance under ambient conditions do not agree well, which underscores the need for SLE measurements and validates the Diviner compositional measurement technique