Improved sampling of compressed gases for condensable hydrocarbon content

Sampling process was developed which uses commercially available high pressure filters and provides measurements in fraction of time required by older methods. Measurements show no significant difference in results between low pressure and high pressure samples. Filter method is slightly more accurate than scrubber technique

Of Cherries, Fudge, and Onions: Science and Its Courtroom Perversion

The thesis of this article is that the Supreme Court decision in Daubert v. Merrell Dow Pharmaceuticals, Inc.\u27s focus on the scientific method, however rigorously applied, invites certain classes of abuses. There are instances in which evidence can be made to look more scientific by a process that in fact and substance makes is utterly unscientific

A circumpolar perspective on fluvial sediment flux to the Arctic ocean

Quantification of sediment fluxes from rivers is fundamental to understanding land‐ocean linkages in the Arctic. Numerous publications have focused on this subject over the past century, yet assessments of temporal trends are scarce and consensus on contemporary fluxes is lacking. Published estimates vary widely, but often provide little accessory information needed to interpret the differences. We present a pan‐arctic synthesis of sediment flux from 19 arctic rivers, primarily focusing on contributions from the eight largest ones. For this synthesis, historical records and recent unpublished data were compiled from Russian, Canadian, and United States sources. Evaluation of these data revealed no long‐term trends in sediment flux, but did show stepwise changes in the historical records of two of the rivers. In some cases, old values that do not reflect contemporary fluxes are still being reported, while in other cases, typographical errors have been propagated into the recent literature. Most of the discrepancy among published estimates, however, can be explained by differences in years of records examined and gauging stations used. Variations in sediment flux from year to year in arctic rivers are large, so estimates based on relatively few years can differ substantially. To determine best contemporary estimates of sediment flux for the eight largest arctic rivers, we used a combination of newly available data, historical records, and literature values. These estimates contribute to our understanding of carbon, nutrient, and contaminant transport to the Arctic Ocean and provide a baseline for detecting future anthropogenic or natural change in the Arctic

Avatars:the other side of Proteus's mirror : a study into avatar choice regarding perception

The trend for online interactions, can be regarded as being ‘anti-so-cially social’, meaning that a great deal of time is spent playing, working and socializing with the internet serving as the communication conduit. Within that Virtual Social Environment very deep relationships are formed and maintained without the parties ever having met each other face-to-face. Raising the question how much does the physical appearance of an avatar influence the perception of the person behind it? Are relationships informed by appearance even in the vir-tual world and what implications does that have for second language acquisition? This paper leads to a small-scale research project where a selection of avatars with various racially identifiable characteristics were used to identify which av-atars a second language speaker would feel more at ease interacting with in the target language. The resultant research aims to test three hypotheses regarding preferred avatar choice for second language users based solely on perceptions

Diagnostics of the structure of AGN's broad line regions with reverberation mapping data: confirmation of the two-component broad line region model

We re-examine the ten Reverberation Mapping (RM) sources with public data based on the two-component model of the Broad Line Region (BLR). In fitting their broad H-beta lines, six of them only need one Gaussian component, one of them has a double-peak profile, one has an irregular profile, and only two of them need two components, i.e., a Very Broad Gaussian Component (VBGC) and an Inter-Mediate Gaussian Component (IMGC). The Gaussian components are assumed to come from two distinct regions in the two-component model; they are Very Broad Line Region (VBLR) and Inter-Mediate Line region (IMLR). The two sources with a two-component profile are Mrk 509 and NGC 4051. The time lags of the two components of both sources satisfy $t_{IMLR}/t_{VBLR}=V^2_{VBLR}/V^2_{IMLR}$, where $t_{IMLR}$ and $t_{VBLR}$ are the lags of the two components while $V_{IMLR}$ and $V_{VBLR}$ represent the mean gas velocities of the two regions, supporting the two-component model of the BLR of Active Galactic Nuclei (AGN). The fact that most of these ten sources only have the VBGC confirms the assumption that RM mainly measures the radius of the VBLR; consequently, the radius obtained from the R-L relationship mainly represent the radius of VBLR. Moreover, NGC 4051, with a lag of about 5 days in the one component model, is an outlier on the R-L relationship as shown in Kaspi et al. (2005); however this problem disappears in our two-component model with lags of about 2 and 6 days for the VBGC and IMGC, respectively.Comment: 7 pages, 5 figures. Accepted for publication in the Special Issue of Science in China (G) "Astrophysics of Black holes and Related Compact Objects

Power assist EVA glove development

Structural modeling of the EVA glove indicates that flexibility in the metacarpophalangeal (MCP) joint can be improved by selectively lowering the elasticity of the glove fabric. Two strategies are used to accomplish this. One method uses coil springs on the back of the glove to carry the tension in the glove skin due to pressurization. These springs carry the loads normally borne by the glove fabric, but are more easily deformed. An active system was also designed for the same purpose and uses gas filled bladders attached to the back of the EVA glove that change the dimensions of the back of the glove and allow the glove to bend at the MCP joint, thus providing greater flexibility at this joint. A threshold control scheme was devised to control the action of the joint actuators. Input to the controller was provided by thin resistive pressure sensors placed between the hand and the pressurized glove. The pressure sensors consist of a layer of polyester film that has a thin layer of ink screened on the surface. The resistivity of the ink is pressure dependent, so an extremely thin pressure sensor can be fabricated by covering the ink patch with another layer of polyester film and measuring the changing resistance of the ink with a bridge circuit. In order to sense the force between the hand and the glove at the MCP joint, a sensor was placed on the palmar face of the middle finger. The resultant signal was used by the controller to decide whether to fill or exhaust the bladder actuators on the back of the glove. The information from the sensor can also be used to evaluate the effectiveness of a given control scheme or glove design since the magnitude of the measured pressures gives some idea of the torque required to bend a glove finger at the MCP joint. Tests of this actuator, sensor, and control system were conducted in an 57.2 kPa glove box by performing a series of 90 degree finger bends with a glove without an MCP joint assembly, a glove with the coil spring assembly, and with the four fingered actuated glove. The tests of these three glove designs confirm the validity of the model

A preliminary structural analysis of space-based inflatable tubular frame structures

The use of inflatable structures has often been proposed for aerospace and planetary applications. The advantages of such structures include low launch weight and easy assembly. The use of inflatables for applications requiring very large frame structures intended for aerospace use are proposed. In order to consider using an inflated truss, the structural behavior of the inflated frame must be examined. The statics of inflated tubes as beams was discussed in the literature, but the dynamics of these elements has not received much attention. In an effort to evaluate the vibration characteristics of the inflated beam a series of free vibration tests of an inflated fabric cantilevers were performed. Results of the tests are presented and models for system behavior posed

Implementable Quantum Bit-String Commitment Protocol

Quantum bit-string commitment[A.Kent, Phys.Rev.Lett., 90, 237901 (2003)] or QBSC is a variant of bit commitment (BC). In this paper, we propose a new QBSC protocol that can be implemented using currently available technology, and prove its security under the same security criteria as discussed by Kent. QBSC is a generalization of BC, but has slightly weaker requirements, and our proposed protocol is not intended to break the no-go theorem of quantum BC.Comment: To appear in Phys. Rev. A., 9 pages, 2 figure