10,238 research outputs found
Quantum-dot thermometry
We present a method for the measurement of a temperature differential across
a single quantum dot that has transmission resonances that are separated in
energy by much more than the thermal energy. We determine numerically that the
method is accurate to within a few percent across a wide range of parameters.
The proposed method measures the temperature of the electrons that enter the
quantum dot and will be useful in experiments that aim to test theory which
predicts quantum dots are highly-efficient thermoelectrics.Comment: 3 pages, 4 Figure
Evidence for the absence of regularization corrections to the partial-wave renormalization procedure in one-loop self energy calculations in external fields
The equivalence of the covariant renormalization and the partial-wave
renormaliz ation (PWR) approach is proven explicitly for the one-loop
self-energy correction (SE) of a bound electron state in the presence of
external perturbation potentials. No spurious correctio n terms to the
noncovariant PWR scheme are generated for Coulomb-type screening potentia ls
and for external magnetic fields. It is shown that in numerical calculations of
the SE with Coulombic perturbation potential spurious terms result from an
improper treatment of the unphysical high-energy contribution. A method for
performing the PWR utilizing the relativistic B-spline approach for the
construction of the Dirac spectrum in external magnetic fields is proposed.
This method is applied for calculating QED corrections to the bound-electron
-factor in H-like ions. Within the level of accuracy of about 0.1% no
spurious terms are generated in numerical calculations of the SE in magnetic
fields.Comment: 22 pages, LaTeX, 1 figur
Velocity weakening and possibility of aftershocks in nanofriction experiments
We study the frictional behavior of small contacts as those realized in the
atomic force microscope and other experimental setups, in the framework of
generalized Prandtl-Tomlinson models. Particular attention is paid to
mechanisms that generate velocity weakening, namely a decreasing average
friction force with the relative sliding velocity.The mechanisms studied model
the possibility of viscous relaxation, or aging effects in the contact. It is
found that, in addition to producing velocity weakening, these mechanisms can
also produce aftershocks at sufficiently low sliding velocities. This provides
a remarkable analogy at the microscale, of friction properties at the
macroscale, where aftershocks and velocity weakening are two fundamental
features of seismic phenomena.Comment: 8 pages, 7 figure
Enhancement of noncontact friction between closely spaced bodies by two-dimensional systems
. We consider the effect of an external bias voltage and the spatial
variation of the surface potential, on the damping of cantilever vibrations.
The electrostatic friction is due to energy losses in the sample created by the
electromagnetic field from the oscillating charges induced on the surface of
the tip by the bias voltage and spatial variation of the surface potential. A
similar effect arises when the tip is oscillating in the electrostatic field
created by charged defects in a dielectric substrate. The electrostatic
friction is compared with the van der Waals friction originating from the
fluctuating electromagnetic field due to quantum and thermal fluctuation of the
current density inside the bodies. We show that the electrostatic and van der
Waals friction can be greatly enhanced if on the surfaces of the sample and the
tip there are two-dimension (2D) systems, e.g. a 2D-electron system or
incommensurate layers of adsorbed ions exhibiting acoustic vibrations. We show
that the damping of the cantilever vibrations due to the electrostatic friction
may be of similar magnitude as the damping observed in recent experiments of
Stipe \textit{et al} [B.C.Stipe, H.J.Mamin, T.D.Stowe, T.W.Kenny, and D.Rugar,
Phys.Rev. Lett.% \textbf{87}, 0982001]. We also show that at short separation
the van der Waals friction may be large enough to be measured experimentally.Comment: 11 pages, 2 figure
Recommended from our members
From Waste-Heat Recovery to Refrigeration: Compositional Tuning of Magnetocaloric Mn 1+ x Sb
Fluid flow at the interface between elastic solids with randomly rough surfaces
I study fluid flow at the interface between elastic solids with randomly
rough surfaces. I use the contact mechanics model of Persson to take into
account the elastic interaction between the solid walls and the Bruggeman
effective medium theory to account for the influence of the disorder on the
fluid flow. I calculate the flow tensor which determines the pressure flow
factor and, e.g., the leak-rate of static seals. I show how the perturbation
treatment of Tripp can be extended to arbitrary order in the ratio between the
root-mean-square roughness amplitude and the average interfacial surface
separation. I introduce a matrix D(Zeta), determined by the surface roughness
power spectrum, which can be used to describe the anisotropy of the surface at
any magnification Zeta. I present results for the asymmetry factor Gamma(Zeta)
(generalized Peklenik number) for grinded steel and sandblasted PMMA surfaces.Comment: 16 pages, 14 figure
Element specific characterization of heterogeneous magnetism in (Ga,Fe)N films
We employ x-ray spectroscopy to characterize the distribution and magnetism
of particular alloy constituents in (Ga,Fe)N films grown by metal organic vapor
phase epitaxy. Furthermore, photoelectron microscopy gives direct evidence for
the aggregation of Fe ions, leading to the formation of Fe-rich nanoregions
adjacent to the samples surface. A sizable x-ray magnetic circular dichroism
(XMCD) signal at the Fe L-edges in remanence and at moderate magnetic fields at
300 K links the high temperature ferromagnetism with the Fe(3d) states. The
XMCD response at the N K-edge highlights that the N(2p) states carry
considerable spin polarization. We conclude that FeN{\delta} nanocrystals, with
\delta > 0.25, stabilize the ferromagnetic response of the films.Comment: 4 pages, 3 figures, 1 tabl
Vibrational inelastic scattering effects in molecular electronics
We describe how to treat the interaction of travelling electrons with
localised vibrational modes in nanojunctions. We present a multichannel
scattering technique which can be applied to calculate the transport properties
for realistic systems, and show how it is related to other methods that are
useful in particular cases. We apply our technique to describe recent
experiments on the conductance through molecular junctions.Comment: LaTeX, 12 pages, 3 figure
Loop-after-loop contribution to the second-order Lamb shift in hydrogenlike low-Z atoms
We present a numerical evaluation of the loop-after-loop contribution to the
second-order self-energy for the ground state of hydrogenlike atoms with low
nuclear charge numbers Z. The calculation is carried out in the Fried-Yennie
gauge and without an expansion in Z \alpha. Our calculation confirms the
results of Mallampalli and Sapirstein and disagrees with the calculation by
Goidenko and coworkers. A discrepancy between different calculations is
investigated. An accurate fitting of the numerical results provides a detailed
comparison with analytic calculations based on an expansion in the parameter Z
\alpha. We confirm the analytic results of order \alpha^2 (Z\alpha)^5 but
disagree with Karshenboim's calculation of the \alpha^2 (Z \alpha)^6 \ln^3(Z
\alpha)^{-2} contribution.Comment: RevTex, 19 pages, 4 figure
- …