3,644 research outputs found
Recommended from our members
An Inverse Geometry Problem for the Localization of Skin Tumours by Thermal Analysis
In this paper, the Dual Reciprocity Method (DRM) is coupled to a Genetic Algorithm (GA) in an inverse procedure through which the size and location of a skin tumour may be obtained from temperature measurements at the skin surface. The GA is an evolutionary process which does not require the calculation of sensitivities, search directions or the definition of initial guesses. The DRM in this case requires no internal nodes. It is also shown that the DRM approximation function used is not an important factor for the problem considered here. Results are presented for tumours of different sizes and positions in relation to the skin surface
Recommended from our members
A coupled dual reciprocity BEM/Genetic algorithm for identification of blood perfusion parameters
The paper presents an inverse analysis procedure based on a coupled numerical formulation through which the coefficients describing non-linear thermal properties of blood perfusion may be identified. The numerical technique involves a combination of the Dual Reciprocity Boundary Element Method and a Genetic Algorithm for the solution of the Pennes bioheat equation. Both linear and quadratic temperature-dependent variations are considered for the blood perfusion
A solution to the slow stabilisation of surface pressure sensors based on the Wilhelmy method
Dynamic measurement of surface pressure is of particular interest in the field of Langmuir
monolayers, where the change in surface pressure throughout an experiment can provide information
on the properties of the monolayer forming material, or on the reaction kinetics of
the monolayer’s interaction with other materials. One of the most common methods for the
measurement of dynamic surface pressure is the Wilhelmy plate method. This method measures
changes in the forces acting upon a thin plate of material at the air-water interface; this
measurement is then converted to surface pressure. One version of this method, which uses filter
paper plates at the air-water interface, is particularly popular due to their relatively low cost.
However, it has been seen that the use of filter paper plates attached to a Wilhelmy balance requires
an initial stabilisation period lasting several hours, during which the readings drift from
the original baseline. Here the cause of this drift is explored, considering how changes in the
weight of the plate over time influence the assumptions on which the surface pressure is derived
from the measurements made by the Wilhelmy balance. A simple method for preventing
this drift through pre-soaking of the filter paper plates is presented
Dissolved oxygen sensing using an optical fibre long period grating coated with hemoglobin
A long period grating fiber optic sensor coated
with hemoglobin is used to detect dissolved oxygen.
The sensitivity of this sensor to the ratio of dissolved carbon
dioxide to dissolved oxygen is demonstrated via the conversion of
carboxyhemoglobin to oxyhemoglobin on the sensor surface. The
sensor shows good repeatability with a %CV of less than 1% for
carboxyhemoglobin and oxyhemoglobin states with no
measurable drift or hysteresis
Overwrite fabrication and tuning of long period gratings
The central wavelengths of the resonance bands are critical aspect of the performance of long period gratings (LPGs) as sensors, particularly for devices designed to operate near the phase matching turning point (PMTP), where the sensitivity to measurements can vary rapidly. Generally, LPGs are characterized by their period, but the amplitude of the amplitude of the index modulation is also an important factor in determining the wavelengths of the resonance bands. Variations in fabrication between LPG sensors can increase or decrease the sensitivity of the LPG to strain, temperature or surrounding refractive index. Here, the technique of overwritten UV laser fabrication is demonstrated. It is shown that, on repeated overwriting, the resonance bands of an LPG exhibit significant wavelength shift, which can be monitored and which can be used to tune the resonance bands to the desired wavelengths. This technique is applied to periods in the range 100 to 200 µm, showing the cycle-to-cycle evolution of the resonance bands near the PMTPs of a number of cladding modes. The use of online monitoring is shown to reduce the resonance band sensor-to-sensor central wavelength variation from 10 nm to 3 nm
Fabrication and optimisation of a fused filament 3D-printed microfluidic platform
A 3D-printed microfluidic device was designed and manufactured using a low cost
($2000)
consumer grade fusion deposition modelling (FDM) 3D printer. FDM printers are not typically
used, or are capable, of producing the fine detailed structures required for microfluidic
fabrication. However, in this work, the optical transparency of the device was improved
through manufacture optimisation to such a point that optical colorimetric assays can be
performed in a 50 µl device. A colorimetric enzymatic cascade assay was optimised using
glucose oxidase and horseradish peroxidase for the oxidative coupling of aminoantipyrine
and chromotropic acid to produce a blue quinoneimine dye with a broad absorbance peaking
at 590 nm for the quantification of glucose in solution. For comparison the assay was run in
standard 96 well plates with a commercial plate reader. The results show the accurate and
reproducible quantification of
0–10 mM glucose solution using a 3D-printed microfluidic
optical device with performance comparable to that of a plate reader assay
On the electron affinity of the oxygen atom
The electron affinity (EA) of oxygen is computed to be 1.287 eV, using 2p electron full configuration-interaction (CI) wave functions expanded in a 6s5p3d2f Slater-type orbital basis. The best complete active space self-consistent field - multireference CI (CASSCF-MRCI) result including only 2p correlation is 1.263 eV. However, inclusion of 2s intrashell and 2s2p intershell correlation increases the computed EA to 1.290 at the CASSCF-MRCI level. At the full CI basis set limit, the 2s contribution to the electron affinity is estimated to be as large as 0.1 eV. This study clearly establishes the synergistic effect between the higher excitations and basis set completeness on the electron affinity when the 2s electrons are correlated
RMS Radio Source Contributions to the Microwave Sky
Cross-correlations of the WMAP full sky K, Ka, Q, V, and W band maps with the
1.4 GHz NVSS source count map and the HEAO I A2 2-10 keV full sky X-ray flux
map are used to constrain rms fluctuations due to unresolved microwave sources
in the WMAP frequency range. In the Q band (40.7 GHz), a lower limit, taking
account of only those fluctuations correlated with the 1.4 GHz radio source
counts and X-ray flux, corresponds to an rms Rayleigh-Jeans temperature of ~ 2
microKelvin for a solid angle of one square degree. The correlated fluctuations
at the other bands are consistent with a beta = -2.1 +- 0.4 frequency spectrum.
Using the rms fluctuations of the X-ray flux and radio source counts, and the
cross-correlation of these two quantities as a guide, the above lower limit
leads to a plausible estimate of ~ 5 microKelvin for Q-band rms fluctuations in
one square degree. This value is similar to that implied by the excess, small
angular scale fluctuations observed in the Q band by WMAP, and is consistent
with estimates made by extrapolating low-frquency source counts.Comment: 17 pages, 8 figures, submitted to Ap
Modifying monolayer behaviour by incorporating subphase additives and improving Langmuir–Blodgett thin film deposition on optical fibres
Experiments showing the possibility of modifying the behaviour of calix[4]resorcinarene monolayers at the air–water interface and optimising the deposition of multilayer coatings onto optical fibres are presented. The nature of the subphase is fundamental to the behaviour of monolayers and their utility in coating and sensing applications. Here we show initial studies exploring the modification of the calix[4]resorcinarene monolayer–water interaction through the introduction of dipole altering alcohol additives to the aqueous subphase. We explored the effect of this modification for three small alcohols. The resulting isotherms of the materials showed a reduction in the surface pressure and area per molecule required in order for the monolayer to reach its point of collapse. Incorporation of alcohols shifted the point of collapse, leading to the application of ethanol being successful in improving the transfer of material via Langmuir–Blodgett coating onto optical fibres at lower pressures. This method may prove useful in allowing greater control over future sensor surface coatings
Accurate ab initio calculations which demonstrate a 3 Pi u ground state for Al2
The spectroscopic parameters and separations between the three low-lying X 3 Pi u, A 3 Sigma g -, and a 1 Sigma g + states of Al2 are studied as a function of both the one-particle and n-particle basis set. Approximate correlation treatments are calibrated against full Cl calculations correlating the six valence electrons in a double-zeta plus two d-function basis set. Since the CASSCF/MRCI 3 Pi u to 3 Sigma g - separation is in excellent agreement wtih the FCI value, the MRCI calculations were carried out in an extended (20s13p6d4f)/(6s5p3d2f) gaussian basis. Including a small correction for relativistic effects, the best estimate is that 3 Sigma g - state lies 174/cm above the 3 Pi u ground state. The 1 Sigma g + state lies at least 2000/cm higher in energy. At the CPF level, inclusion of 2s and 2p correlation has little effect on D sub e, reduces T sub e by only 26/cm, and shortens the bond lengths by about 0.02 a sub o. Further strong support for a 3 Pi u ground state comes from the experimental absorption spectra, since both observed transitions can be convincingly assigned as 3 Pi u yields 3 Pi g. The (2) 3 Pi g state is observed to be sensitive to the level of correlation treatment, and to have its minimum shifted to shorter rho values, such that the strongest experimental absorption peak probably corresponds to the 0 yields 2 transition
- …