Crop–livestock-integrated farming system: a strategy to achieve synergy between agricultural production, nutritional security, and environmental sustainability

IntroductionClimate change, nutritional security, land shrinkage, and an increasing human population are the most concerning factors in agriculture, which are further complicated by deteriorating soil health. Among several ways to address these issues, the most prominent and cost-effective means is to adopt an integrated farming system (IFS). Integrating farming systems with livestock enables a way to increase economic yield per unit area per unit of time for farmers in small and marginal categories. This system effectively utilizes the waste materials by recycling them via linking appropriate components, thereby minimizing the pollution caused to the environment. Further integrating livestock components with crops and the production of eggs, meat, and milk leads to nutritional security and stable farmer's income generation. So, there is a dire need to develop an eco-friendly, ecologically safe, and economically profitable IFS model.MethodsAn experiment was conducted to develop a crop–livestock-based integrated farming system model for the benefit of irrigated upland farmers in the semi-arid tropics for increasing productivity, farm income, employment generation, and food and nutritional security through efficient utilization of resources in the farming system.Results and discussionThe IFS model has components, viz., crop (0.85 ha) + horticulture (0.10 ha) + 2 cattles along with 2 calves in dairy (50 m2) + 12 female goats and 1 male goat (50 m2) + 150 numbers of poultry birds (50 m2) + vermicompost (50 m2) + kitchen garden (0.02 ha) + boundary planting + supporting activities (0.01 ha) in a one-hectare area. The model recorded a higher total MEY (162.31 t), gross return (689,773), net return (317,765), and employment generation (475 mandays). Further negative emissions of −15,118 CO2-e (kg) greenhouse gases were recorded under this model. The study conclusively reveals that integration of crop, horticulture, dairy, goat, poultry, vermicompost production, kitchen garden, and boundary planting models increases the net returns, B:C ratio, employment generation, nutritional security, and livelihoods of small and marginal farmers

Biosurfactants produced by Bacillus subtilis A1 and Pseudomonas stutzeri NA3 reduce longevity and fecundity of Anopheles stephensi and show high toxicity against young instars

Anopheles stephensi acts as vector of Plasmodium parasites, which are responsible for malaria in tropical and subtropical areas worldwide. Currently, malaria management is a big challenge due to the presence of insecticide-resistant strains as well as to the development of Plasmodium species highly resistant to major antimalarial drugs. Therefore, the present study focused on biosurfactant produced by two bacteria Bacillus subtilis A1 and Pseudomonas stutzeri NA3, evaluating them for insecticidal applications against malaria mosquitoes. The produced biosurfactants were characterized using FT-IR spectroscopy and gas chromatography-mass spectrometry (GC-MS), which confirmed that biosurfactants had a lipopeptidic nature. Both biosurfactants were tested against larvae and pupae of A. stephensi. LC50 values were 3.58 (larva I), 4.92 (II), 5.73 (III), 7.10 (IV), and 7.99 (pupae) and 2.61 (I), 3.68 (II), 4.48 (III), 5.55 (IV), and 6.99 (pupa) for biosurfactants produced by B. subtilis A1 and P. stutzeri NA3, respectively. Treatments with bacterial surfactants led to various physiological changes including longer pupal duration, shorter adult oviposition period, and reduced longevity and fecundity. To the best of our knowledge, there are really limited reports on the mosquitocidal and physiological effects due to biosurfactant produced by bacterial strains. Overall, the toxic activity of these biosurfactant on all young instars of A. stephensi, as well as their major impact on adult longevity and fecundity, allows their further consideration for the development of insecticides in the fight against malaria mosquitoes

Using creative co-design to develop a decision support tool for people with malignant pleural effusion

Abstract: Background: Malignant pleural effusion (MPE) is a common, serious problem predominantly seen in metastatic lung and breast cancer and malignant pleural mesothelioma. Recurrence of malignant pleural effusion is common, and symptoms significantly impair people’s daily lives. Numerous treatment options exist, yet choosing the most suitable depends on many factors and making decisions can be challenging in pressured, time-sensitive clinical environments. Clinicians identified a need to develop a decision support tool. This paper reports the process of co-producing an initial prototype tool. Methods: Creative co-design methods were used. Three pleural teams from three disparate clinical sites in the UK were involved. To overcome the geographical distance between sites and the ill-health of service users, novel distributed methods of creative co-design were used. Local workshops were designed and structured, including video clips of activities. These were run on each site with clinicians, patients and carers. A joint national workshop was then conducted with representatives from all stakeholder groups to consider the findings and outputs from local meetings. The design team worked with participants to develop outputs, including patient timelines and personas. These were used as the basis to develop and test prototype ideas. Results: Key messages from the workshops informed prototype development. These messages were as follows. Understanding and managing the pleural effusion was the priority for patients, not their overall cancer journey. Preferred methods for receiving information were varied but visual and graphic approaches were favoured. The main influences on people’s decisions about their MPE treatment were personal aspects of their lives, for example, how active they are, what support they have at home. The findings informed the development of a first prototype/service visualisation (a video representing a web-based support tool) to help people identify personal priorities and to guide shared treatment decisions. Conclusion: The creative design methods and distributed model used in this project overcame many of the barriers to traditional co-production methods such as power, language and time. They allowed specialist pleural teams and service users to work together to create a patient-facing decision support tool owned by those who will use it and ready for implementation and evaluation

Contribution of infection and vaccination to population-level seroprevalence through two COVID waves in Tamil Nadu, India.

This study employs repeated, large panels of serological surveys to document rapid and substantial waning of SARS-CoV-2 antibodies at the population level and to calculate the extent to which infection and vaccination separately contribute to seroprevalence estimates. Four rounds of serological surveys were conducted, spanning two COVID waves (October 2020 and April-May 2021), in Tamil Nadu (population 72 million) state in India. Each round included representative populations in each district of the state, totaling ≥ 20,000 persons per round. State-level seroprevalence was 31.5% in round 1 (October-November 2020), after India's first COVID wave. Seroprevalence fell to 22.9% in round 2 (April 2021), a roughly one-third decline in 6 months, consistent with dramatic waning of SARS-Cov-2 antibodies from natural infection. Seroprevalence rose to 67.1% by round 3 (June-July 2021), with infections from the Delta-variant induced second COVID wave accounting for 74% of the increase. Seroprevalence rose to 93.1% by round 4 (December 2021-January 2022), with vaccinations accounting for 63% of the increase. Antibodies also appear to wane after vaccination. Seroprevalence in urban areas was higher than in rural areas, but the gap shrunk over time (35.7 v. 25.7% in round 1, 89.8% v. 91.4% in round 4) as the epidemic spread even in low-density rural areas

Crystal growth, structural and optical characterization of a semi-organic single crystal for frequency conversion applications

Single crystals of semi-organic L-histidine hydrobromide have been grown by slow evaporation technique from a mixture of L-histidine and hydrobromic acid in aqueous solution at ambient temperature. From high-resolution X-ray diffraction analysis, the crystalline perfection of the grown crystal has been studied. Single crystal X-ray diffraction analyses, Nuclear Magnetic Resonance spectral analysis, Thermo-Gravimetry (TG), Differential Thermal Analysis (DTA) and hardness test have been employed to characterize the as-grown crystals. The UV cutoff wavelength of the grown crystal is below 300 nm and has a wide transparency window, which is suitable for second harmonic generation of laser in the blue region. Nonlinear optical characteristics have been studied using Q switched Nd:YAG laser (lambda=1064 nm). The second harmonic generation conversion efficiency of the grown crystals confirms their suitability for frequency conversion applications

Dynamics of soil penetration resistance, moisture depletion pattern and crop productivity determined by mechanized cultivation and lifesaving irrigation in zero till blackgram

Rice fallow black gram is grown under the residual moisture situation as a relay crop in heavy texture montmorillonite clay soil under zero till condition. Since the crop is raised during post monsoon season, the crop often experiences terminal stress due to limited water availability and no rainfall. Surface irrigation in montmorillonite clay soil is determent to pulse crop as inundation causes wilting. Therefore, zero tilled rice fallow black gram has to be supplemented with micro irrigation at flowering stage (35 days after sowing) to alleviate moisture stress and to increase the productivity as well. Hence micro farm pond in a corner of one ha field was created to harvest the rain water during monsoon season and the same was utilized to supplement the crop with lifesaving irrigation through mobile sprinkler at flowering stage for the crop grown under conservation agriculture. Soil cracking is also the common phenomena of montmorillonite clay soil where evaporations losses would be more through crack surfaces. The present study was therefore conducted to study the changes in the soil physical properties, crop establishment and productivity in conjunction with mechanized sowing and harvest and supplemental mobile sprinkler irrigation. Sowing of black gram by broadcasting 10 days prior to the manual harvest of rice, manual drawn single row seed drill after the machine harvest of rice and sowing by broadcasting at 4 days prior to machine harvest of rice was experimented separately and in combination with lifesaving irrigation. Results indicated that the number of wheel passes and lifesaving irrigation had a very strong impact on soil penetration resistance and soil moisture. Combined harvester followed by no till seed drill increased the soil penetration resistance in all the layers (0–5 cm, 5–10 cm and 10–15 cm). Two passes of wheel increased the mean soil penetration resistance from 407 KPa to 502 KPa. The soil penetration resistance (0–5 cm) at harvest shown that black gram sown by manual broadcasting 10 days prior to manual harvest of paddy supplemented with life irrigation on 30 DAS reduced the soil penetration resistance from 690 Kpa to 500 Kpa, 740 Kpa to 600 Kpa and 760 Kpa to 620 Kpa respectively at 0–5 cm, 5–10 cm and 10–15 cm layer. In general, moisture depletion rate was rapid in the surface layer of 0–5 cm as compared to other layers of 5–10 cm and 10–15 cm up to 30 DAS (Flowering stage). The moisture content and the soil penetration resistance had an inverse relationship. The soil penetration resistance also had an inverse relationship with the root length in which the root length lowers as the soil penetration resistance increases. The soil crack measured at 60 DAS was deeper with no till seed drill (width of 3.94 cm and depth of 13.67 cm) which was mainly due to surface layer compaction. The relative water content, specific leaf weight and chlorophyll content were significantly improved through the supplemental irrigation given on 30 DAS irrespective of crop establishment methods. The results further indicated that compaction of ploughed layer in the moist soil due to combined harvester and no till seed drill had a negative impact on yield (457 kg ha−1), which was improved by 19.03 per cent due to increased soil moisture with supplemental irrigation. The mean yield increase across different treatments due to supplemental lifesaving irrigation through mobile sprinkler was 20.4 per cent

Crystal growth, structural and thermal studies of amino acids admixtured L-arginine phosphate monohydrate single crystals

To study the improved characteristics of l-arginine phosphate monohydrate (LAP) crystals, amino acids mixed LAP crystals have been grown by slow cooling method. Amino acids like glycine, l-alanine, and l-valine have been selected for doping. Optical quality bulk crystals have been harvested after a typical growth period of about twenty days. The effect of amino acids in the crystal lattice and molecular vibrational frequencies of various functional groups in the crystals have been studied using X-ray powder diffraction and Fourier Transform infrared (FTIR) analyses respectively. Thermal behavior of the amino acids mixed LAP crystals have been studied from the TG and DTG analyses. High-resolution X-ray diffraction studies have been carried out to find the crystalline nature. Optical transmission studies have been carried out by UV–vis spectrophotometer. The cut off wavelength is below 240 nm for the grown crystals