Experimental Investigation of a Constant-Velocity Traveling Magnetic Wave Plasma Engine

The previously reported traveling magnetic wave plasma engine has been redesigned to reduce the high heat loss to the tube walls downstream of the last magnetic-field coil. The present configuration uses a 3-inch-diameter pyrex tube flared out to a 6-inch diameter immediately downstream of the last magnetic-field coil. This configuration has been studied to determine the effects of flared-tube geometry, molecular weight of the propellant, engine length, and use of a ferrite core on the engine performance. Argon and xenon gases were used as propellants. Two engine lengths were tested. One engine was nominally 1-magnetic-wavelength long (4 coils) and the other nominally 2 1/2-magnetic wavelengths long (10 coils). The magnetic wave speed for both of these lengths corresponds to a specific impulse of 4750 seconds. The maximum kinetic efficiency of the 4-coil engine was 10 percent at a specific impulse of 3200 seconds using argon gas and 22.5 percent at 4200 seconds using xenon gas as the propellant

A description of the reformatted spring small grains labeling procedure used in test 2, part 2 of the US/Canada wheat and barley exploratory experiment

The reformatted spring small grains labeling procedure is designed to be used for assigning crop identification labels to a predetermined and selected number of dots. The development and description of this procedure is presented

Investigation of the effects of a moving acoustic medium on jet noise measurements

Noise from an unheated sonic jet in the presence of an external flow is measured in a free-jet wind tunnel using microphones located both inside and outside the flow. Comparison of the data is made with results of similar studies. The results are also compared with theoretical predictions of the source strength for jet noise in the presence of flow and of the effects of sound propagation through a shear layer

Analytical Investigations of Coil-System Design Parameters for a Constant-Velocity Traveling Magnetic Wave Plasma Engine

Coil-system design parameters for constant velocity traveling-magnetic-wave plasma engin

Cogeneration Technology Alternatives Study (CTAS). Volume 3: Industrial processes

Cogenerating electric power and process heat in single energy conversion systems rather than separately in utility plants and in process boilers is examined in terms of cost savings. The use of various advanced energy conversion systems are examined and compared with each other and with current technology systems for their savings in fuel energy, costs, and emissions in individual plants and on a national level. About fifty industrial processes from the target energy consuming sectors were used as a basis for matching a similar number of energy conversion systems that are considered as candidate which can be made available by the 1985 to 2000 time period. The sectors considered included food, textiles, lumber, paper, chemicals, petroleum, glass, and primary metals. The energy conversion systems included steam and gas turbines, diesels, thermionics, stirling, closed cycle and steam injected gas turbines, and fuel cells. Fuels considered were coal, both coal and petroleum based residual and distillate liquid fuels, and low Btu gas obtained through the on site gasification of coal. An attempt was made to use consistent assumptions and a consistent set of ground rules specified by NASA for determining performance and cost. Data and narrative descriptions of the industrial processes are given

On the importance of being finished

The publication of an increasing number of draft genome sequences presents problems that will only be resolved by improved search tools and by complete finishing of the sequences - and their deposition in publicly accessible databases