95 research outputs found

    Pre-treatment effects on coral skeletal delta\u3csup\u3e13\u3c/sup\u3eC and delta\u3csup\u3e18\u3c/sup\u3eO

    Get PDF
    Pre-treatments are often used to remove organic β€œcontaminant” material prior to isotopic analyses of coral skeletal samples. Here we conducted three experiments to test the pre-treatment effect of water, 30% hydrogen peroxide (H2O2), and household bleach [5.25% sodium hypochlorite (NaClO3) and 0.15% sodium hydroxide (NaOH)], on the stable isotopic composition of coral skeletal samples. First, using a mass balance approach we calculated the expected change in skeletal delta13C due to the removal of all organic carbon. The model showed that (1) the removal of organic carbon (which has a low delta13C value relative to skeletal delta13C) from the skeletal sample should theoretically result in a higher delta13C value of the remaining organic-carbon-free carbonate, and that (2) only at the highest concentrations of skeletal organic carbon within the tissue layer of corals is the contribution of the organic carbon to the overall delta13C skeletal value potentially large enough to be detectable by mass spectrometry. We then conducted two sets of experiments to test the model where we pre-treated a large number of skeletal samples from five species of corals with water, H2O2, bleach, or no pre-treatment for 24 h. Skeletal delta13C generally decreased significantly with water, bleach, and H2O2 pre-treatments which is contrary to the model-predicted increase in delta13C following such pre-treatments. Thus, organic carbon within the skeleton is not a net source of contamination to delta13C analyses. Skeletal delta18O decreased the most with water and bleach pre-treatments. In addition, the effect of H2O2 or bleach pre-treatments on either delta13C or delta18O was not consistent among species or locations. The direction of change in delta13C and delta18O with pre-treatments was no different for skeletal samples taken within or below the tissue layer. Based on our results, we suggest that pre-treatment is not necessary and recommend that pre-treatment not be performed on coral skeletal samples prior to stable isotope analysis to avoid any pre-treatment-induced variability that could significantly compromise inter-colony and inter-species comparisons

    Objective surface evaluation of fiber reinforced polymer composites

    Full text link
    The mechanical properties of advanced composites are essential for their structural performance, but the surface finish on exterior composite panels is of critical importance for customer satisfaction. This paper describes the application of wavelet texture analysis (WTA) to the task of automatically classifying the surface finish properties of two fiber reinforced polymer (FRP) composite construction types (clear resin and gel-coat) into three quality grades. Samples were imaged and wavelet multi-scale decomposition was used to create a visual texture representation of the sample, capturing image features at different scales and orientations. Principal components analysis was used to reduce the dimensionality of the texture feature vector, permitting successful classification of the samples using only the first principal component. This work extends and further validates the feasibility of this approach as the basis for automated non-contact classification of composite surface finish using image analysis.<br /

    Ocean acidification reduces demersal zooplankton that reside in tropical coral reefs

    Get PDF
    The in situ effects of ocean acidification on zooplankton communities remain largely unexplored. Using natural volcanic CO2 seep sites around tropical coral communities, we show a threefold reduction in the biomass of demersal zooplankton in high-CO2 sites compared with sites with ambient CO2. Differences were consistent across two reefs and three expeditions. Abundances were reduced in most taxonomic groups. There were no regime shifts in zooplankton community composition and no differences in fatty acid composition between CO2 levels, suggesting that ocean acidification affects the food quantity but not the quality for nocturnal plankton feeders. Emergence trap data show that the observed reduction in demersal plankton may be partly attributable to altered habitat. Ocean acidification changes coral community composition from branching to massive bouldering coral species, and our data suggest that bouldering corals represent inferior daytime shelter for demersal zooplankton. Since zooplankton represent a major source of nutrients for corals, fish and other planktivores, this ecological feedback may represent an additional mechanism of how coral reefs will be affected by ocean acidification

    Simulation of dilated heart failure with continuous flow circulatory support

    Get PDF
    Lumped parameter models have been employed for decades to simulate important hemodynamic couplings between a left ventricular assist device (LVAD) and the native circulation. However, these studies seldom consider the pathological descending limb of the Frank-Starling response of the overloaded ventricle. This study introduces a dilated heart failure model featuring a unimodal end systolic pressure-volume relationship (ESPVR) to address this critical shortcoming. The resulting hemodynamic response to mechanical circulatory support are illustrated through numerical simulations of a rotodynamic, continuous flow ventricular assist device (cfVAD) coupled to systemic and pulmonary circulations with baroreflex control. The model further incorporated septal interaction to capture the influence of left ventricular (LV) unloading on right ventricular function. Four heart failure conditions were simulated (LV and bi-ventricular failure with/ without pulmonary hypertension) in addition to normal baseline. Several metrics of LV function, including cardiac output and stroke work, exhibited a unimodal response whereby initial unloading improved function, and further unloading depleted preload reserve thereby reducing ventricular output. The concept of extremal loading was introduced to reflect the loading condition in which the intrinsic LV stroke work is maximized. Simulation of bi-ventricular failure with pulmonary hypertension revealed inadequacy of LV support alone. These simulations motivate the implementation of an extremum tracking feedback controller to potentially optimize ventricular recovery. Β© 2014 Wang et al

    Effects of Light, Food Availability and Temperature Stress on the Function of Photosystem II and Photosystem I of Coral Symbionts

    Get PDF
    Background: Reef corals are heterotrophic coelenterates that achieve high productivity through their photosynthetic dinoflagellate symbionts. Excessive seawater temperature destabilises this symbiosis and causes corals to "bleach," lowering their photosynthetic capacity. Bleaching poses a serious threat to the persistence of coral reefs on a global scale. Despite expanding research on the causes of bleaching, the mechanisms remain a subject of debate.\ud \ud Methodology/Principal Findings: This study determined how light and food availability modulate the effects of temperature stress on photosynthesis in two reef coral species. We quantified the activities of Photosystem II, Photosystem I and whole chain electron transport under combinations of normal and stressful growth temperatures, moderate and high light levels and the presence or absence of feeding of the coral hosts. Our results show that PS1 function is comparatively robust against temperature stress in both species, whereas PS2 and whole chain electron transport are susceptible to temperature stress. In the symbiotic dinoflagellates of Stylophora pistillata the contents of chlorophyll and major photosynthetic complexes were primarily affected by food availability. In Turbinaria reniformis growth temperature was the dominant influence on the contents of the photosynthetic complexes. In both species feeding the host significantly protected photosynthetic function from high temperature stress.\ud \ud Conclusions/Significance: Our findings support the photoinhibition model of coral bleaching and demonstrate that PS1 is not a major site for thermal damage during bleaching events. Feeding mitigates bleaching in two scleractinian corals, so that reef responses to temperature stresses will likely be influenced by the coinciding availabilities of prey for the host

    Multilevel growth mixture models for classifying groups

    No full text
    This article introduces a multilevel growth mixture model (MGMM) for classifying both the individuals and the groups they are nested in. Nine variations of the general model are described that differ in terms of categorical and continuous latent variable specification within and between groups. An application in the context of school effectiveness research is presented. Schools are classified into three Type B effectiveness categories based on their mean student mathematics achievement growth trajectories, controlling for differences in students' backgrounds across schools. The classification outcome is regressed on a set of school practice variables to investigate the association between practices and cognitive development. Various issues related to model specification are discussed, including the use of covariates to identify substantively meaningful classes.</jats:p

    Relation between volumetric changes of unsaturated polyester resin and surface finish quality of fiberglass/unsaturated polyester composite panels

    No full text
    Resin dimensional changes, including cure shrinkage and thermal expansion, highly influence the surface finish quality of composite parts. Low profile additives (LPA) are commonly incorporated in unsaturated polyester (UP) resins to compensate for resin shrinkage and obtain a high quality surface finish. In this study, the dimensional change of an UP resin with different LPA contents was characterized. Both resin cure shrinkage and resin thermal expansion were measured. A simple methodology was then developed to estimate the surface finish quality of panels, manufactured by resin transfer molding (RTM), based on the prediction of part thickness variation during the process. Results show good agreement with the experimental investigations. \ua9 2011 Society of Plastics Engineers.Peer reviewed: YesNRC publication: Ye
    • …
    corecore