25,932 research outputs found
Irradiate-anneal screening of total dose effects in semiconductor devices
An extensive investigation of irradiate-anneal (IRAN) screening against total dose radiation effects was carried out as part of a program to harden the Mariner Jupiter/Saturn 1977 (MJS'77) spacecraft to survive the Jupiter radiation belts. The method consists of irradiating semiconductor devices with Cobalt-60 to a suitable total dose under representative bias conditions and of separating the parts in the undesired tail of the distribution from the bulk of the parts by means of a predetermined acceptance limit. The acceptable devices are then restored close to their preirradiation condition by annealing them at an elevated temperature. IRAN was used when lot screen methods were impracticable due to lack of time, and when members of a lot showed a diversity of radiation response. The feasibility of the technique was determined by testing of a number of types of linear bipolar integrated circuits, analog switches, n-channel JFETS and bipolar transistors. Based on the results of these experiments a number of device types were selected for IRAN of flight parts in the MJS'77 spacecraft systems. The part types, screening doses, acceptance criteria, number of parts tested and rejected as well as the program steps are detailed
Analytical and experimental study of reentrant stream crossed-field amplifiers Final report
Computer simulation and noise measurements of reentrant stream crossed-field amplifier
Voyager electronic parts radiation program, volume 1
The Voyager spacecraft is subject to radiation from external natural space, from radioisotope thermoelectric generators and heater units, and from the internal environment where penetrating electrons generate surface ionization effects in semiconductor devices. Methods for radiation hardening and tests for radiation sensitivity are described. Results of characterization testing and sample screening of over 200 semiconductor devices in a radiation environment are summarized
Voyager electronic parts radiation program. Volume 2: Test requirements and procedures
Documents are presented outlining the conditions and requirements of the test program. The Appendixes are as follows: appendix A -- Electron Simulation Radiation Test Specification for Voyager Electronic Parts and Devices, appendix B -- Electronic Piece-Part Testing Program for Voyager, appendix C -- Test Procedure for Radiation Screening of Voyager Piece Parts, appendix D -- Boeing In Situ Test Fixture, and appendix E -- Irradiate - Anneal (IRAN) Screening Documents
Design considerations and test facilities for accelerated radiation effects testing
Test design parameters for accelerated dose rate radiation effects tests for spacecraft parts and subsystems used in long term mission (years) are detailed. A facility for use in long term accelerated and unaccelerated testing is described
A guideline for heavy ion radiation testing for Single Event Upset (SEU)
A guideline for heavy ion radiation testing for single event upset was prepared to assist new experimenters in preparing and directing tests. How to estimate parts vulnerability and select an irradiation facility is described. A broad brush description of JPL equipment is given, certain necessary pre-test procedures are outlined and the roles and testing guidelines for on-site test personnel are indicated. Detailed descriptions of equipment needed to interface with JPL test crew and equipment are not provided, nor does it meet the more generalized and broader requirements of a MIL-STD document. A detailed equipment description is available upon request, and a MIL-STD document is in the early stages of preparation
Design considerations for a LORAN-C timing receiver in a hostile signal to noise environment
The environment in which a LORAN-C Timing Receiver may function effectively depends to a large extent on the techniques utilized to insure that interfering signals within the pass band of the unit are neutralized. The baseline performance manually operated timing receivers is discussed and the basic design considerations and necessary parameters for an automatic unit utilizing today's technology are established. Actual performance data is presented comparing the results obtained from a present generation timing receiver against a new generation microprocessor controlled automatic acquisition receiver. The achievements possible in a wide range of signal to noise situations are demonstrated
Numerical simulation of liquid sloshing in a partially filled container with inclusion of compressibility effects
A numerical scheme of study is developed to model compressible two-fluid flows simulating liquid sloshing in a partially filled tank. For a two-fluid system separated by an interface as in the case of sloshing, not only a Mach-uniform scheme is required, but also an effective way to eliminate unphysical numerical oscillations near the interface. By introducing a preconditioner, the governing equations expressed in terms of primitive variables are solved for both fluids (i.e. water, air, gas etc.) in a unified manner. In order to keep the interface sharp and to eliminate unphysical numerical oscillations in unsteady fluid flows, the non-conservative implicit Split Coefficient Matrix Method (SCMM) is modified to construct a flux difference splitting scheme in the dual time formulation. The proposed numerical model is evaluated by comparisons between numerical results and measured data for sloshing in an 80% filled rectangular tank excited at resonance frequency. Through similar comparisons, the investigation is further extended by examining sloshing flows excited by forced sway motions in two different rectangular tanks with 20% and 83% filling ratios. These examples demonstrate that the proposed method is suitable to capture induced free surface waves and to evaluate sloshing pressure loads acting on the tank walls and ceiling
The resurrection of group selection as a theory of human cooperation
Two books edited by members of the MacArthur Norms and Preferences Network (an interdisciplinary group, mainly anthropologists and economists) are reviewed here. These books in large part reflect a renewed interest in group selection
that has occurred among these researchers: they promote the theory that human cooperative behavior evolved via selective processes which favored biological and/or cultural group-level adaptations as opposed to individual-level adaptations. In support of this theory, an impressive collection of cross-cultural data are presented which suggest that participants in experimental economic games often do not behave as self-interested income maximizers; this lack of self-interest is regarded as evidence of group selection. In this review, problems with these data and with the theory are discussed. On the data side, it is argued that even if a behavior seems individually-maladaptive in a game context, there is no reason to believe that it would have been that way in ancestral contexts, since the environments of experimental games do not at all resemble those in which ancestral humans would have interacted cooperatively. And on the theory side, it is argued that it is premature to invoke group selection in order to explain human cooperation, because more parsimonious individual-level theories have not yet been exhausted. In summary, these books represent ambitious interdisciplinary contributions on an important topic, and they include unique and useful data; however, they do not make a convincing case that the evolution of human cooperation required group selection
Non-linear resistivity and heat dissipation in monolayer graphene
We have experimentally studied the nonlinear nature of electrical conduction
in monolayer graphene devices on silica substrates. This nonlinearity manifests
itself as a nonmonotonic dependence of the differential resistance on applied
DC voltage bias across the sample. At temperatures below ~70K, the differential
resistance exhibits a peak near zero bias that can be attributed to
self-heating of the charge carriers. We show that the shape of this peak arises
from a combination of different energy dissipation mechanisms of the carriers.
The energy dissipation at higher carrier temperatures depends critically on the
length of the sample. For samples longer than 10um the heat loss is shown to be
determined by optical phonons at the silica-graphene interface.Comment: 4 pages, 4 figure
- …