Physicochemical characterization of escherichia coli. A comparison with gram-positive bacteria

Eight Escherichia coli strains were characterized by determining their adhesion to xylene, surface free energy, zeta potential, relative surface charge, and their chemical composition. The latter was done by applying X-ray photoelectron spectroscopy (XPS) and infrared spectroscopy (IR). No relationship between the adhesion to xylene and the water contact angles of these strains was found. Three strains had significantly lower surface free energies than the other strains. Surface free energies were either obtained from polar and dispersion parts or from Lifshitz-van der Waals and acid/base parts of the surface free energy. A correlation (r=0.97) between the polar parts and the electron-donor contributions to the acid/base part of the surface free energy was found. The zeta potentials of all strains, measured as a function of pH (2–11), were negative. Depending on the zeta potential as a function of pH, three groups were recognized among the strains tested. A relationship (r=0.84) was found between the acid/base component of the surface free energy and the zeta potential measured at pH=7.4. There was no correlation between results of XPS and IR studies. Data from the literature of XPS and IR studies of the gram-positive staphylococci and streptococci were compared with data from the gram-negativeE. coli used in this study. It appeared that in these three groups of bacteria, the polysaccharide content detected by IR corresponded well with the oxygen-to-carbon ratio detected by XPS

Oligo(ethylene glycol) monolayers by silanization of silicon wafers: Real nature and stability

International audienc

Influence of substrate hydrophobicity on the adsorption of an amphiphilic diblock copolymer

The adsorption of poly(tert-butylmethacrylate)-block-poly(2-(dimethylamino-ethyl) methacrylate) (PtBUMA-b-PDMAEMA) was studied by X-ray photoelectron spectroscopy (XPS) and atomic force microscopy (AFM) analysis performed on dried samples. The copolymer was dissolved in toluene at concentrations below (0.01 wt%) and above (0.05 and 1 wt%) the CMC; silicon (SiOH) and CH3-grafted silicon (SiCH3) were used as substrates. Whatever the concentration and the substrate, a layer of individual copolymer molecules, 1.5-3 nm thick, formed rapidly. The adsorbed amount was slightly higher and the resistance to AFM tip scraping was stronger on SiOH than oil SiCH3. This is attributed to hydrogen bonding between the PDMAEMA block and the OH groups of the silicon surface, leading to polarization of the adsorbed layer. Above the CMC, on SiOH, randomly scattered dot-like features (about 5 nm high) observed by AFM were attributed to individual micelles, which were not displaced by drying. On SiCH3, the particles found on the top of the adsorbed layer were micelle aggregates, about 50 nm thick, the lateral size of which was strongly influenced by the rate of drying. This further difference between SiCH3 and SiOH is tentatively attributed to the exposure of PDMAEMA by the adsorbed layer formed on SiCH3, while only PtBUMA would be exposed by the layer adsorbed on SiOH. The red blood cell shape and the size of the micelles observed in single layers indicate that the PtBUMA corona was not made compact as a result of drying, (C) 2003 Elsevier Inc. All rights reserved