GTP and Ca2+ Modulate the Inositol 1,4,5-Trisphosphate-Dependent Ca2+ Release in Streptolysin O-Permeabilized Bovine Adrenal Chromaffin Cells

The inositol 1,4,5-trisphosphate (IP3)-induced Ca2+ release was studied using streptolysin O-permeabilized bovine adrenal chromaffin cells. The IP3-induced Ca2+ release was followed by Ca2+ reuptake into intracellular compartments. The IP3-induced Ca2+ release diminished after sequential applications of the same amount of IP3. Addition of 20 μM GTP fully restored the sensitivity to IP3. Guanosine 5'-O-(3-thio)triphosphate (GTPγS) could not replace GTP but prevented the action of GTP. The effects of GTP and GTPγS were reversible. Neither GTP nor GTPγS induced release of Ca2+ in the absence of IP3. The amount of Ca2+ whose release was induced by IP3 depended on the free Ca2+ concentration of the medium. At 0.3 μM free Ca2+, a half-maximal Ca2+ release was elicited with ∼0.1 μM IP3. At 1 μM free Ca2+, no Ca2+ release was observed with 0.1 μM IP3; at this Ca2+ concentration, higher concentrations of IP3 (0.25 μM) were required to evoke Ca2+ release. At 8 μM free Ca2+, even 0.25 μM IP3 failed to induce release of Ca2+ from the store. The IP3-induced Ca2+ release at constant low (0.2 μM) free Ca2+ concentrations correlated directly with the amount of stored Ca2+. Depending on the filling state of the intracellular compartment, 1 mol of IP3 induced release of between 5 and 30 mol of Ca2+

Ultrathin compound semiconductor on insulator layers for high performance nanoscale transistors

Over the past several years, the inherent scaling limitations of electron devices have fueled the exploration of high carrier mobility semiconductors as a Si replacement to further enhance the device performance. In particular, compound semiconductors heterogeneously integrated on Si substrates have been actively studied, combining the high mobility of III-V semiconductors and the well-established, low cost processing of Si technology. This integration, however, presents significant challenges. Conventionally, heteroepitaxial growth of complex multilayers on Si has been explored. Besides complexity, high defect densities and junction leakage currents present limitations in the approach. Motivated by this challenge, here we utilize an epitaxial transfer method for the integration of ultrathin layers of single-crystalline InAs on Si/SiO2 substrates. As a parallel to silicon-on-insulator (SOI) technology14,we use the abbreviation "XOI" to represent our compound semiconductor-on-insulator platform. Through experiments and simulation, the electrical properties of InAs XOI transistors are explored, elucidating the critical role of quantum confinement in the transport properties of ultrathin XOI layers. Importantly, a high quality InAs/dielectric interface is obtained by the use of a novel thermally grown interfacial InAsOx layer (~1 nm thick). The fabricated FETs exhibit an impressive peak transconductance of ~1.6 mS/{\mu}m at VDS=0.5V with ON/OFF current ratio of greater than 10,000 and a subthreshold swing of 107-150 mV/decade for a channel length of ~0.5 {\mu}m

Correlating the nanostructure and electronic properties of InAs nanowires

The electronic properties and nanostructure of InAs nanowires are correlated by creating multiple field effect transistors (FETs) on nanowires grown to have low and high defect density segments. 4.2 K carrier mobilities are ~4X larger in the nominally defect-free segments of the wire. We also find that dark field optical intensity is correlated with the mobility, suggesting a simple route for selecting wires with a low defect density. At low temperatures, FETs fabricated on high defect density segments of InAs nanowires showed transport properties consistent with single electron charging, even on devices with low resistance ohmic contacts. The charging energies obtained suggest quantum dot formation at defects in the wires. These results reinforce the importance of controlling the defect density in order to produce high quality electrical and optical devices using InAs nanowires.Comment: Related papers at http://pettagroup.princeton.ed

Influence of Oxygen Ion Migration from Substrates on Photochemical Degradation of CH3NH3PbI3 Hybrid Perovskite

Measurements of XPS survey, core levels (N 1s, O 1s, Pb 4f, I 3d), and valence band (VB) spectra of CH3NH3PbI3 (MAPbI3) hybrid perovskite prepared on different substrates (glass, indium tin oxide (ITO), and TiO2) aged under different light-soaking conditions at room temperature are presented. The results reveal that the photochemical stability of MAPbI3 depends on the type of substrate and gradually decreases when glass is replaced by ITO and TiO2. Also, the degradation upon exposure to visible light is accompanied by the formation of MAI, PbI2, and Pb0 products as shown by XPS core levels spectra. According to XPS O 1s and VB spectra measurements, this degradation process is superimposed on the partial oxidation of lead atoms in ITO/MAPbI3 and TiO2/MAPbI3, for which Pb–O bonds are formed due to the diffusion of the oxygen ions from the substrates. This unexpected interaction leads to additional photochemical degradation. © 2021 by the author. Licensee MDPI, Basel, Switzerland.Funding: The sample preparation, aging experiments, UV‐vis, XRD, and SEM characterization were supported by Russian Science Foundation (project No. 19‐73‐30020). The XPS measurements were supported by the Ministry of Education and Science of the Russian Federation (project FEUZ‐2020‐0060), Theme ‘Electron’, no. AAAA‐A18‐118020190098‐5 and Russian Foundation for Basic Research (projects No. 21‐52‐52002/21 and 20‐42‐660003). C.‐C.C. acknowledges the financial support from the Ministry of Science and Technology in Taiwan (MOST 110‐2923‐E‐002‐007‐MY3) and the Top University Project from National Taiwan University (110L7836 and 110L7726)

Temperature Dependence of Photochemical Degradation of MAPbBr3 Perovskite

The experimental results of X-ray diffraction (XRD), optical absorbance, scanning electron microscopy (SEM), and X-ray photoelectron spectra (XPS) of the core levels and valence bands of MAPbBr3 (MA-CH3NH3+) perovskite before and after exposure to visible light for 700 h at temperatures of 10 and 60 °C are presented. It reveals that the light soaking at 60 °C induces the decomposition of MAPbBr3 perovskite accompanied with the decay of organic cation and the release of a PbBr2 phase as a degradation product whereas the photochemical degradation completely disappears while the aging temperature is decreased to 10 °C. © 2022 by the authors.Russian Foundation for Basic Research, РФФИ: 21-52-52002; Ministry of Education and Science of the Russian Federation, Minobrnauka: AAAA-A18–118020190098-5, FEUZ 2020-0060; Ministry of Science and Technology, Taiwan, MOST: 110-2923-E-002-007-MY3; Russian Science Foundation, RSF: 19-73-30020I.S.Z. and A.I.K. thank the Ministry of Science and Higher Education of the Russian Federation (Ural Federal University Program of Development within the Priority-2030 Program) for support.This work was supported by the Russian Science Foundation (Project 19-73-30020) at IPCP RAS. The XPS measurements were supported by the Ministry of Science and Higher Education of the Russian Federation under the theme “Electron” No. AAAA-A18–118020190098-5 and Project FEUZ 2020-0060 as well as the Russian Foundation for Basic Research (Project No. 21-52-52002). The research fundings from the Ministry of Science and Technology in Taiwan (MOST 110-2923-E-002-007-MY3) are gratefully acknowledged

The muscarinic receptor antagonist propiverine exhibits α1-adrenoceptor antagonism in human prostate and porcine trigonum

Combination therapy of male lower urinary tract symptoms with α(1)-adrenoceptor and muscarinic receptor antagonists attracts increasing interest. Propiverine is a muscarinic receptor antagonist possessing additional properties, i.e., block of L-type Ca(2+) channels. Here, we have investigated whether propiverine and its metabolites can additionally antagonize α(1)-adrenoceptors. Human prostate and porcine trigone muscle strips were used to explore inhibition of α(1)-adrenoceptor-mediated contractile responses. Chinese hamster ovary (CHO) cells expressing cloned human α(1)-adrenoceptors were used to determine direct interactions with the receptor in radioligand binding and intracellular Ca(2+) elevation assays. Propiverine concentration-dependently reversed contraction of human prostate pre-contracted with 10 μM phenylephrine (-log IC(50) [M] 4.43 ± 0.08). Similar inhibition was observed in porcine trigone (-log IC(50) 5.01 ± 0.05), and in additional experiments consisted mainly of reduced maximum phenylephrine responses. At concentrations ≥1 μM, the propiverine metabolite M-14 also relaxed phenylephrine pre-contracted trigone strips, whereas metabolites M-5 and M-6 were ineffective. In radioligand binding experiments, propiverine and M-14 exhibited similar affinity for the three α(1)-adrenoceptor subtypes with -log K (i) [M] values ranging from 4.72 to 4.94, whereas the M-5 and M-6 did not affect [(3)H]-prazosin binding. In CHO cells, propiverine inhibited α(1)-adrenoceptor-mediated Ca(2+) elevations with similar potency as radioligand binding, again mainly by reducing maximum responses. In contrast to other muscarinic receptor antagonists, propiverine exerts additional L-type Ca(2+)-channel blocking and α(1)-adrenoceptor antagonist effects. It remains to be determined clinically, how these additional properties contribute to the clinical effects of propiverine, particularly in male voiding dysfunctio

Observation of degenerate one-dimensional sub-bands in cylindrical InAs nanowires

One-dimensional (1D) sub-bands in cylindrical InAs nanowires (NWs) are electrically mapped as a function of NW diameter in the range of 15-35 nm. At low temperatures, stepwise current increases with the gate voltage are clearly observed and attributed to the electron transport through individual 1D sub-bands. The two-fold degeneracy in certain sub-band energies predicted by simulation due to structural symmetry is experimentally observed for the first time. The experimentally obtained sub-band energies match the simulated results, shedding light on both the energies of the sub-bands as well as the number of sub-bands populated per given gate voltage and diameter. This work serves to provide better insight into the electrical transport behavior of 1D semiconductors.Comment: 20 pages, 5 figures, supporting information include

Uncoupling of Satellite DNA and Centromeric Function in the Genus Equus

In a previous study, we showed that centromere repositioning, that is the shift along the chromosome of the centromeric function without DNA sequence rearrangement, has occurred frequently during the evolution of the genus Equus. In this work, the analysis of the chromosomal distribution of satellite tandem repeats in Equus caballus, E. asinus, E. grevyi, and E. burchelli highlighted two atypical features: 1) several centromeres, including the previously described evolutionary new centromeres (ENCs), seem to be devoid of satellite DNA, and 2) satellite repeats are often present at non-centromeric termini, probably corresponding to relics of ancestral now inactive centromeres. Immuno-FISH experiments using satellite DNA and antibodies against the kinetochore protein CENP-A demonstrated that satellite-less primary constrictions are actually endowed with centromeric function. The phylogenetic reconstruction of centromere repositioning events demonstrates that the acquisition of satellite DNA occurs after the formation of the centromere during evolution and that centromeres can function over millions of years and many generations without detectable satellite DNA. The rapidly evolving Equus species gave us the opportunity to identify different intermediate steps along the full maturation of ENCs

Influence of surface atomic structure demonstrated on oxygen incorporation mechanism at a model perovskite oxide

Perovskite oxide surfaces catalyze oxygen exchange reactions that are crucial for fuel cells, electrolyzers, and thermochemical fuel synthesis. Here, by bridging the gap between surface analysis with atomic resolution and oxygen exchange kinetics measurements, we demonstrate how the exact surface atomic structure can determine the reactivity for oxygen exchange reactions on a model perovskite oxide. Two precisely controlled surface reconstructions with (4 × 1) and (2 × 5) symmetry on 0.5 wt.% Nb-doped SrTiO3(110) were subjected to isotopically labeled oxygen exchange at 450 °C. The oxygen incorporation rate is three times higher on the (4 × 1) surface phase compared to the (2 × 5). Common models of surface reactivity based on the availability of oxygen vacancies or on the ease of electron transfer cannot account for this difference. We propose a structure-driven oxygen exchange mechanism, relying on the flexibility of the surface coordination polyhedra that transform upon dissociation of oxygen molecules.Austrian Science Fund (SFB “ Functional Oxide Surfaces and Interfaces ” - FOXSI, Project F 45)European Research Council Advanced Grant (“OxideSurfaces” (Project ERC-2011-ADG_20110209))National Science Foundation (U.S.). Division of Materials Research (CAREER Award Grant No. 1055583