424 research outputs found
Piloted Simulation Assessment of the Impact of Flexible Structures on Handling Qualities of Generic Supersonic Aircraft
The NASA Langley Research Center Cockpit Motion Facility (CMF) was used to conduct a piloted simulation assessment of the impact of flexible structures on flying qualities. The CMF was used because of its relatively high bandwidth, six degree-of-freedom motion capability. Previous studies assessed and attempted to mitigate the effects of multiple dynamic aeroservoelastic modes (DASE). Those results indicated problems existed, but the specific cause and effect was difficult to ascertain. The goal of this study was to identify specific DASE frequencies, damping ratios, and gains that cause degradation in handling qualities. A generic aircraft simulation was developed and designed to have Cooper-Harper Level 1 handling qualities when flown without DASE models. A test matrix of thirty-six DASE modes was implemented. The modes had frequencies ranging from 1 to 3.5 Hz and were applied to each axis independently. Each mode consisted of a single axis, frequency, damping, and gain, and was evaluated individually by six subject pilots with test pilot backgrounds. Analysis completed to date suggests that a number of the DASE models evaluated degrade the handling qualities of this class of aircraft to an uncontrollable condition
Measuring vertebrate telomeres: applications and limitations
Telomeres are short tandem repeated sequences of DNA found at the ends of eukaryotic
chromosomes that function in stabilizing chromosomal end integrity.
In vivo
studies of
somatic tissue of mammals and birds have shown a correlation between telomere length and
organismal age within species, and correlations between telomere shortening rate and
lifespan among species. This result presents the tantalizing possibility that telomere length
could be used to provide much needed information on age, ageing and survival in natural
populations where longitudinal studies are lacking. Here we review methods available for
measuring telomere length and discuss the potential uses and limitations of telomeres as
age and ageing estimators in the fields of vertebrate ecology, evolution and conservation
Flight validation of ground-based assessment for control power requirements at high angles of attack
A review is presented in viewgraph format of an ongoing NASA/U.S. Navy study to determine control power requirements at high angles of attack for the next generation high-performance aircraft. This paper focuses on recent flight test activities using the NASA High Alpha Research Vehicle (HARV), which are intended to validate results of previous ground-based simulation studies. The purpose of this study is discussed, and the overall program structure, approach, and objectives are described. Results from two areas of investigation are presented: (1) nose-down control power requirements and (2) lateral-directional control power requirements. Selected results which illustrate issues and challenges that are being addressed in the study are discussed including test methodology, comparisons between simulation and flight, and general lessons learned
BICEP3: a 95 GHz refracting telescope for degree-scale CMB polarization
BICEP3 is a 550 mm-aperture refracting telescope for polarimetry of radiation
in the cosmic microwave background at 95 GHz. It adopts the methodology of
BICEP1, BICEP2 and the Keck Array experiments - it possesses sufficient
resolution to search for signatures of the inflation-induced cosmic
gravitational-wave background while utilizing a compact design for ease of
construction and to facilitate the characterization and mitigation of
systematics. However, BICEP3 represents a significant breakthrough in
per-receiver sensitivity, with a focal plane area 5 larger than a
BICEP2/Keck Array receiver and faster optics ( vs. ).
Large-aperture infrared-reflective metal-mesh filters and infrared-absorptive
cold alumina filters and lenses were developed and implemented for its optics.
The camera consists of 1280 dual-polarization pixels; each is a pair of
orthogonal antenna arrays coupled to transition-edge sensor bolometers and read
out by multiplexed SQUIDs. Upon deployment at the South Pole during the 2014-15
season, BICEP3 will have survey speed comparable to Keck Array 150 GHz (2013),
and will significantly enhance spectral separation of primordial B-mode power
from that of possible galactic dust contamination in the BICEP2 observation
patch.Comment: 12 pages, 5 figures. Presented at SPIE Astronomical Telescopes and
Instrumentation 2014: Millimeter, Submillimeter, and Far-Infrared Detectors
and Instrumentation for Astronomy VII. To be published in Proceedings of SPIE
Volume 915
Analysis of the low-energy electron-recoil spectrum of the CDMS experiment
We report on the analysis of the low-energy electron-recoil spectrum from the
CDMS II experiment using data with an exposure of 443.2 kg-days. The analysis
provides details on the observed counting rate and possible background sources
in the energy range of 2 - 8.5 keV. We find no significant excess in the
counting rate above background, and compare this observation to the recent DAMA
results. In the framework of a conversion of a dark matter particle into
electromagnetic energy, our 90% confidence level upper limit of 0.246
events/kg/day at 3.15 keV is lower than the total rate above background
observed by DAMA by 8.9. In absence of any specific particle physics
model to provide the scaling in cross section between NaI and Ge, we assume a
Z^2 scaling. With this assumption the observed rate in DAMA differs from the
upper limit in CDMS by 6.8. Under the conservative assumption that the
modulation amplitude is 6% of the total rate we obtain upper limits on the
modulation amplitude a factor of ~2 less than observed by DAMA, constraining
some possible interpretations of this modulation.Comment: 4 pages, 3 figure
Characterization of SuperCDMS 1-inch Ge Detectors
The newly commissioned SuperCDMS Soudan experiment aims to search for WIMP dark matter with a sensitivity to cross sections of 5Ć10^(ā45)cm^2 and larger (90% CL upper limit). This goal is facilitated by a new set of germanium detectors, 2.5 times more massive than the ones used in the CDMS-II experiment, and with a different athermal phonon sensor layout that eliminates radial degeneracy in position reconstruction of high radius events. We present characterization data on these detectors, as well as improved techniques for correcting position-dependent variations in pulse shape across the detector. These improvements provide surface-event discrimination sufficient for a reach of 5Ć10^(ā45)cm^2
Results from a Low-Energy Analysis of the CDMS II Germanium Data
We report results from a reanalysis of data from the Cryogenic Dark Matter
Search (CDMS II) experiment at the Soudan Underground Laboratory. Data taken
between October 2006 and September 2008 using eight germanium detectors are
reanalyzed with a lowered, 2 keV recoil-energy threshold, to give increased
sensitivity to interactions from Weakly Interacting Massive Particles (WIMPs)
with masses below ~10 GeV/c^2. This analysis provides stronger constraints than
previous CDMS II results for WIMP masses below 9 GeV/c^2 and excludes parameter
space associated with possible low-mass WIMP signals from the DAMA/LIBRA and
CoGeNT experiments.Comment: 9 pages, 8 figures. Supplemental material included as ancillary
files. v3) Added appendix with additional details regarding energy scale and
background
Search for inelastic dark matter with the CDMS II experiment
Results are presented from a reanalysis of the entire five-tower data set
acquired with the Cryogenic Dark Matter Search (CDMS II) experiment at the
Soudan Underground Laboratory, with an exposure of 969 kg-days. The analysis
window was extended to a recoil energy of 150 keV, and an improved
surface-event background-rejection cut was defined to increase the sensitivity
of the experiment to the inelastic dark matter (iDM) model. Three dark matter
candidates were found between 25 keV and 150 keV. The probability to observe
three or more background events in this energy range is 11%. Because of the
occurrence of these events the constraints on the iDM parameter space are
slightly less stringent than those from our previous analysis, which used an
energy window of 10-100 keV.Comment: 10 pages, 10 figures, minor changes to match published version,
conclusion unchange
Using systematic data categorisation to quantify the types of data collected in clinical trials: the DataCat project.
BACKGROUND: Data collection consumes a large proportion of clinical trial resources. Each data item requires time and effort for collection, processing and quality control procedures. In general, more data equals a heavier burden for trial staff and participants. It is also likely to increase costs. Knowing the types of data being collected, and in what proportion, will be helpful to ensure that limited trial resources and participant goodwill are used wisely. AIM: The aim of this study is to categorise the types of data collected across a broad range of trials and assess what proportion of collected data each category represents. METHODS: We developed a standard operating procedure to categorise data into primary outcome, secondary outcome and 15 other categories. We categorised all variables collected on trial data collection forms from 18, mainly publicly funded, randomised superiority trials, including trials of an investigational medicinal product and complex interventions. Categorisation was done independently in pairs: one person having in-depth knowledge of the trial, the other independent of the trial. Disagreement was resolved through reference to the trial protocol and discussion, with the project team being consulted if necessary. KEY RESULTS: Primary outcome data accounted for 5.0% (median)/11.2% (mean) of all data items collected. Secondary outcomes accounted for 39.9% (median)/42.5% (mean) of all data items. Non-outcome data such as participant identifiers and demographic data represented 32.4% (median)/36.5% (mean) of all data items collected. CONCLUSION: A small proportion of the data collected in our sample of 18 trials was related to the primary outcome. Secondary outcomes accounted for eight times the volume of data as the primary outcome. A substantial amount of data collection is not related to trial outcomes. Trialists should work to make sure that the data they collect are only those essential to support the health and treatment decisions of those whom the trial is designed to inform
- ā¦