1,199 research outputs found
A numerical technique for calculation of the noise of high-speed propellers with advanced blade geometry
A numerical technique and computer program were developed for the prediction of the noise of propellers with advanced geometry. The blade upper and lower surfaces are described by a curvilinear coordinate system, which was also used to divide the blade surfaces into panels. Two different acoustic formulations in the time domain were used to improve the speed and efficiency of the noise calculations: an acoustic formualtion with the Doppler factor singularity for panels moving at subsonic speeds and the collapsing sphere formulation for panels moving at transonic or supersonic speeds. This second formulation involves a sphere which is centered at the observer position and whose radius decreases at the speed of sound. The acoustic equation consisted of integrals over the curve of intersection for both the sphere and the panels on the blade. Algorithms used in some parts of the computer program are discussed. Comparisons with measured acoustic data for two model high speed propellers with advanced geometry are also presented
Bounds on thickness and loading noise of rotating blades and the favorable effect of blade sweep on noise reduction
The maxima of amplitudes of thickness and loading noise harmonics are established when the radial distribution of blade chord, thickness ratio, and lift coefficient is specified. It is first shown that only airfoils with thickness distribution and chordwise loading distributions which are symmetric with respect to midchord need be considered for finding the absolute maxima of thickness and loading noise. The resulting chordwise thickness and load distributions for these maximum noise conditions require infinite slope at some points along the chord but otherwise are uniform. It is shown that sweeping the blades reduces the thickness and loading noise, but there is no optimum sweep which generates the lowest noise
An evaluation of linear acoustic theory for a hovering rotor
Linear acoustic calculations are compared with previously reported data for a small-scale hovering rotor operated at high tip Mach numbers. A detailed calculated description of the distributions of blade surface pressure and shear stress due to skin friction is presented. The noise due to skin friction and loading, in the rotor disk plane, is small compared to thickness noise. The basic conclusions of Boxwell et al about the importance of nonlinear effects are upheld. Some approximations involved in the current theories for the inclusion of nonlinear effects are discussed. Using a model nonlinear problem, it is shown that to use the acoustic analogy, good knowledge of the flowfield is required
Hyperfine-structure study in the P sequence of 23 Na using quantum-beam spectroscopy
Describes use of the quantum-beat method to study hyperfine structure in the 5 2 P 3/2 and 6 2 P 3/2 states of 23 Na. A pulsed dye laser, frequency-doubled into the UV region, was used to excite sodium atoms abruptly in a beam. The fluorescent light was recorded with a fast transient digitiser, interfaced to a micro-computer. Theoretical calculations using many-body perturbation theory were performed for the entire P sequence measured so far, taking polarisation and correlation effects into account separately. Very good agreement between experimental and theoretical values was obtained
Sustained hemodynamic benefit during long-term positive inotropic infusion in patients with advanced heart failure
In Vitro Evaluation of Non-Protein Adsorbing Breast Cancer Theranostics Based on 19F-Polymer Containing Nanoparticles
Eight fluorinated nanoparticles (NPs) are synthesized, loaded with doxorubicin (DOX), and evaluated as theranostic delivery platforms to breast cancer cells. The multifunctional NPs are formed by self-assembly of either linear or star-shaped amphiphilic block copolymers, with fluorinated segments incorporated in the hydrophilic corona of the carrier. The sizes of the NPs confirm that small circular NPs are formed. The release kinetics data of the particles reveals clear hydrophobic core dependence, with longer sustained release from particles with larger hydrophobic cores, suggesting that the DOX release from these carriers can be tailored. Viability assays and flow cytometry evaluation of the ratios of apoptosis/necrosis indicate that the materials are non-toxic to breast cancer cells before DOX loading; however, they are very efficient, similar to free DOX, at killing cancer cells after drug encapsulation. Both flow cytometry and confocal microscopy confirm the cellular uptake of NPs and DOX-NPs into breast cancer cells, and in vitro 19F-MRI measurement shows that the fluorinated NPs have strong imaging signals, qualifying them as a potential in vivo contrast agent for 19F-MRI
Platelet Factor XIIIa Release During Platelet Aggregation and Plasma Clot Strength Measured by Thrombelastography in Patients with Coronary Artery Disease Treated with Clopidogrel.
It has been estimated that up to half of circulating Factor XIIIa (FXIIIa) is stored in platelets. The release of FXIIIa from platelets upon stimulation with ADP in patients with coronary artery disease treated with dual antiplatelet therapy has not been previously examined. Samples from 96 patients with established coronary artery disease treated with aspirin and clopidogrel were examined. Platelet aggregation was performed by light transmittance aggregometry (LTA) in platelet rich plasma (PRP) with platelet poor plasma (PPP) as reference and ADP 5μM as agonist. Kaolin activated TEG was performed in citrate PPP. PRP after aggregation was centrifuged and plasma supernatant (PSN) collected. FXIIIa was measured in PPP and PSN.Platelet aggregation after stimulation with ADP 5μM resulted in 24% additional FXIIIa release in PSN as compared to PPP (99.3 ± 27 vs. 80.3 ± 24 %, p<0.0001). FXIIIa concentration in PSN correlated with maximal plasma clot strength (TEG-G) (r=0.48, p<0.0001), but not in PPP (r=0.15, p=0.14). Increasing quartiles of platelet derived FXIIIa were associated with incrementally higher TEG-G (p=0.012). FXIIIa release was similar between clopidogrel responders and non-responders (p=0.18). In summary, platelets treated with aspirin and clopidogrel release a significant amount of FXIIIa upon aggregation by ADP. Platelet derived FXIIIa may contribute to differences in plasma TEG-G, and thus in part provide a mechanistic explanation for high clot strength observed as a consequence of platelet activation. Variability in clopidogrel response does not significantly influence FXIIIa release from platelets
Factor XIII Val34Leu polymorphism and recurrent myocardial infarction in patients with coronary artery disease
Factor XIII (FXIII) is necessary for cross linking of fibrin strands and generation of stable fibrin clot. FXIII Val34Leu is a common genetic single nucleotide polymorphism that has been associated with accelerated fibrin stabilization and reduced rate of fibrinolysis. The contribution of Val34Leu to long term risk of recurrent myocardial infarction (MI) in patients with coronary stenting has not been conclusively established. The objective of the study was to examine the effects of Val34Leu on fibrin generation, platelet aggregation, and long term clinical outcomes in patients with coronary artery disease treated with dual antiplatelet therapy. Patients with angiographically documented coronary artery disease who were treated with aspirin and clopidogrel were enrolled (n = 211). Light transmittance aggregometry and plasma fibrin clot formation using thrombelastography (TEG) were determined. Genotyping of Val34Leu was performed using Taqman assay. Clinical events during follow up were recorded. Homozygous carriers of 34Leu variant had significantly shorter fibrin clot formation time as compared to wild type individuals (TEG K: 1.27 ± 0.3 vs. 1.68 ± 1.1 min, p = 0.011). The Val34Leu variant was associated with gene dose dependent increased risk of MI (log rank, p = 0.002) or occurrence of composite of MI and CV death (log rank, p = 0.005) with highest event rates observed in homozygous carriers of 34Leu. In summary, FXIII Val34Leu polymorphism was associated with increased rate of fibrin stabilization in homozygous carriers of the variant and may increase risk of recurrent MI and death in patients with angiographically established coronary artery disease treated with dual antiplatelet therapy
Low-lying level structure of Cu and its implications on the rp process
The low-lying energy levels of proton-rich Cu have been extracted
using in-beam -ray spectroscopy with the state-of-the-art -ray
tracking array GRETINA in conjunction with the S800 spectrograph at the
National Superconducting Cyclotron Laboratory at Michigan State University.
Excited states in Cu serve as resonances in the
Ni(p,)Cu reaction, which is a part of the rp-process in
type I x-ray bursts. To resolve existing ambiguities in the reaction Q-value, a
more localized IMME mass fit is used resulting in ~keV. We derive
the first experimentally-constrained thermonuclear reaction rate for
Ni(p,)Cu. We find that, with this new rate, the
rp-process may bypass the Ni waiting point via the Ni(p,)
reaction for typical x-ray burst conditions with a branching of up to
40. We also identify additional nuclear physics uncertainties that
need to be addressed before drawing final conclusions about the rp-process
reaction flow in the Ni region.Comment: 8 pages, accepted for Phys. Rev.
Thermodynamic theory of epitaxial ferroelectric thin films with dense domain structures
A Landau-Ginsburg-Devonshire-type nonlinear phenomenological theory is
presented, which enables the thermodynamic description of dense laminar
polydomain states in epitaxial ferroelectric thin films. The theory explicitly
takes into account the mechanical substrate effect on the polarizations and
lattice strains in dissimilar elastic domains (twins). Numerical calculations
are performed for PbTiO3 and BaTiO3 films grown on (001)-oriented cubic
substrates. The "misfit strain-temperature" phase diagrams are developed for
these films, showing stability ranges of various possible polydomain and
single-domain states. Three types of polarization instabilities are revealed
for polydomain epitaxial ferroelectric films, which may lead to the formation
of new polydomain states forbidden in bulk crystals. The total dielectric and
piezoelectric small-signal responses of polydomain films are calculated,
resulting from both the volume and domain-wall contributions. For BaTiO3 films,
strong dielectric anomalies are predicted at room temperature near special
values of the misfit strain.Comment: 19 pages, 8 figure
- …