777 research outputs found
Experimental Results on Crack Inversion
The work reported here is part of a program on flaw detection in turbine rotor components. The goal is to image or map non-surface breaking fatigue cracks near the bore hole surface of an aircraft engine disk with the aid of ultrasonic inversion techniques. Presented are results of inversion of both pitchcatch and pulse-echo data with the inversion technique discussed in detail in the companion pape
Numerical Calculation of Diffraction Coefficients in Anisotropic Media
Ultrasonic inspection is used to detect and size crack-like defects in pressure vessels and pipework used in the nuclear industry. Reliable inspection can only be achieved if the inspection technique is understood, is optimised and subsequently applied correctly. Austenitic steels are used because of their corrosion resistance and toughness. Welds and centrifugally cast materials tend to crystallise with grains larger than the ultrasonic wavelength required to achieve the desired resolution in the inspection and thus appear anisotropic. Since the grains in a weld grow along the, varying, directions of maximum heat flux during cooling, the welds are inhomogeneous as well as anisotropic. We wish to understand the ultrasonic signals scattered by cracks in such inhomogeneous anisotropic materials. To calculate large numbers of cases we would like to use a relatively efficient tool: (ray tracing) and wish to incorporate the diffraction and reflection which occurs at the defect through the use of diffraction or scattering coefficients.</p
Elastic Wave Diffraction at Cracks in Anisotropic Materials
Ultrasonic inspection is used to confirm that there are no defects of concern in various regions of a nuclear reactor primary circuit. All materials are naturally anisotropic, but if the grains are small relative to the ultrasonic wavelength and are also randomly oriented, then the material will appear as homogeneous and isotropic as in ferritic steel. The ultrasonic wavelength is chosen as a compromise between resolution of defect size and acoustic noise from grain boundaries. In austenitic steel, the wavelength chosen will typically be smaller than the grain size, at least in one direction. The grains are not randomly oriented but exhibit macroscopic patterns which depend on the welding process, and the material is neither homogeneous nor isotropic
Making waves round a structured cloak: lattices, negative refraction and fringes
Using the framework of transformation optics, this paper presents a detailed analysis of a non-singular square cloak for acoustic, out-of-plane shear elastic and electromagnetic waves. Analysis of wave propagation through the cloak is presented and accompanied by numerical illustrations. The efficacy of the regularized cloak is demonstrated and an objective numerical measure of the quality of the cloaking effect is provided. It is demonstrated that the cloaking effect persists over a wide range of frequencies. As a demonstration of the effectiveness of the regularized cloak, a Young’s double slit experiment is presented. The stability of the interference pattern is examined when a cloaked and uncloaked obstacle are successively placed in front of one of the apertures. This novel link with a well-known quantum mechanical experiment provides an additional method through which the quality of cloaks may be examined. In the second half of the paper, it is shown that an approximate cloak may be constructed using a discrete lattice structure. The efficiency of the approximate lattice cloak is analysed and a series of illustrative simulations presented. It is demonstrated that effective cloaking may be obtained by using a relatively simple lattice structure, particularly, in the low-frequency regime
The Case for the Dual Halo of the Milky Way
Carollo et al. have recently resolved the stellar population of the Milky Way
halo into at least two distinct components, an inner halo and an outer halo.
This result has been criticized by Schoenrich et al., who claim that the
retrograde signature associated with the outer halo is due to the adoption of
faulty distances. We refute this claim, and demonstrate that the Schoenrich et
al. photometric distances are themselves flawed because they adopted an
incorrect main-sequence absolute magnitude relationship from the work of
Ivezi\'c et al. When compared to the recommended relation from Ivezi\'c et al.,
which is tied to a Milky Way globular cluster distance scale and accounts for
age and metallicity effects, the relation adopted by Schoenrich et al. yields
up to 18% shorter distances for stars near the main-sequence turnoff (TO). Use
of the correct relationship yields agreement between the distances assigned by
Carollo et al. and Ivezi\'{c} et al. for low-metallicity dwarfs to within
6-10%. Schoenrich et al. also point out that intermediate-gravity stars (3.5 <=
log g <= 4.0) with colors redder than the TO region are likely misclassified,
with which we concur. We implement a new procedure to reassign luminosity
classifications for the TO stars that require it. New derivations of the
rotational behavior demonstrate that the retrograde signature and high velocity
dispersion of the outer-halo population remains. We summarize additional lines
of evidence for a dual halo, including a test of the retrograde signature based
on proper motions alone, and conclude that the preponderance of evidence
strongly rejects the single-halo interpretation.Comment: 46 pages, 2 tables, 15 figures, Accepted for publication in the
Astrophysical Journa
Ontologies relevant to behaviour change interventions: a method for their development [version 2; peer review: 1 not approved]
Background: Behaviour and behaviour change are integral to many aspects of wellbeing and sustainability. However, reporting behaviour change interventions accurately and synthesising evidence about effective interventions is hindered by lacking a shared, scientific terminology to describe intervention characteristics. Ontologies are knowledge structures that provide controlled vocabularies to help unify and connect scientific fields. To date, there is no published guidance on the specific methods required to develop ontologies relevant to behaviour change. We report the creation and refinement of a method for developing ontologies that make up the Behaviour Change Intervention Ontology (BCIO). /
Aims: (1) To describe the development method of the BCIO and explain its rationale; (2) To provide guidance on implementing the activities within the development method. /
Method and results: The method for developing ontologies relevant to behaviour change interventions was constructed by considering principles of good practice in ontology development and identifying key activities required to follow those principles. The method’s details were refined through application to developing two ontologies. The resulting ontology development method involved: (1) defining the ontology’s scope; (2) identifying key entities; (3) refining the ontology through an iterative process of literature annotation, discussion and revision; (4) expert stakeholder review; (5) testing inter-rater reliability; (6) specifying relationships between entities, and; (7) disseminating and maintaining the ontology. Guidance is provided for conducting relevant activities for each step. /
Conclusions: We have developed a detailed method for creating ontologies relevant to behaviour change interventions, together with practical guidance for each step, reflecting principles of good practice in ontology development. The most novel aspects of the method are the use of formal mechanisms for literature annotation and expert stakeholder review to develop and improve the ontology content. We suggest the mnemonic SELAR3, representing the method’s first six steps as Scope, Entities, Literature Annotation, Review, Reliability, Relationships
The stellar content of the Hamburg/ESO survey VI. The metallicity distribution of main-sequence turnoff stars in the Galactic halo
We determine the metallicity distribution function (MDF) of the Galactic halo
based on metal-poor main-sequence turnoff-stars (MSTO) which were selected from
the Hamburg/ESO objective-prism survey (HES) database. Corresponding follow-up
moderateresolution observations (R ~ 2000) of some 682 stars (among which 617
were accepted program stars) were carried out with the 2.3m telescope at the
Siding Spring Observatory (SSO). Corrections for the survey volume covered by
the sample stars were quantitatively estimated and applied to the observed MDF.
The corrections are quite small, when compared with those for a previously
studied sample of metal-poor giants. The corrected observational MDF of the
turnoff sample was then compared with that of the giants, as well as with a
number of theoretical predictions of Galactic chemical evolution, including the
mass-loss modified Simple Model. Although the survey-volume corrected MDFs of
the metal-poor turnoff and the halo giants notably differ in the region of
[Fe/H] > -2.0, below [Fe/H] ~ -2.0, (the region we scientifically focus on
most) both MDFs show a sharp drop at [Fe/H] ~ -3.6 and present rather similar
distributions in the low-metallicity tail. Theoretical models can fit some
parts of the observed MDF, but none is found to simultaneously reproduce the
peak as well as the features in the metal-poor region with [Fe/H] between -2.0
to -3.6. Among the tested models only the GAMETE model, when normalized to the
tail of the observed MDF below [Fe/H] ~ -3.0, and with Z_{cr} =
10^{-3.4}Z_{\odot}, is able to predict the sharp drop at [Fe/H] ~ -3.6.Comment: 10 pages, 11 figures, accepted for publication in A&
Representation of behaviour change interventions and their evaluation: Development of the Upper Level of the Behaviour Change Intervention Ontology [version 2; peer review: 1 approved, 1 approved with reservations]
Background: Behaviour change interventions (BCI), their contexts and evaluation methods are heterogeneous, making it difficult to synthesise evidence and make recommendations for real-world policy and practice. Ontologies provide a means for addressing this. They represent knowledge formally as entities and relationships using a common language able to cross disciplinary boundaries and topic domains. This paper reports the development of the upper level of the Behaviour Change Intervention Ontology (BCIO), which provides a systematic way to characterise BCIs, their contexts and their evaluations.
Methods: Development took place in four steps. (1) Entities and relationships were identified by behavioural and social science experts, based on their knowledge of evidence and theory, and their practical experience of behaviour change interventions and evaluations. (2) The outputs of the first step were critically examined by a wider group of experts, including the study ontology expert and those experienced in annotating relevant literature using the initial ontology entities. The outputs of the second step were tested by (3) feedback from three external international experts in ontologies and (4) application of the prototype upper-level BCIO to annotating published reports; this informed the final development of the upper-level BCIO.
Results: The final upper-level BCIO specifies 42 entities, including the BCI scenario, elaborated across 21 entities and 7 relationship types, and the BCI evaluation study comprising 10 entities and 9 relationship types. BCI scenario entities include the behaviour change intervention (content and delivery), outcome behaviour, mechanism of action, and its context, which includes population and setting. These entities have corresponding entities relating to the planning and reporting of interventions and their evaluations.
Conclusions: The upper level of the BCIO provides a comprehensive and systematic framework for representing BCIs, their contexts and their evaluations.
Keyword
Delivering Behaviour Change Interventions: Development of a Mode of Delivery Ontology [version 1; peer review: 1 approved, 1 approved with reservations]
Background: Investigating and improving the effects of behaviour change interventions requires detailed and consistent specification of all aspects of interventions. An important feature of interventions is the way in which these are delivered, i.e. their mode of delivery. This paper describes an ontology for specifying the mode of delivery of interventions, which forms part of the Behaviour Change Intervention Ontology, currently being developed in the Wellcome Trust funded Human Behaviour-Change Project. /
Methods: The Mode of Delivery Ontology was developed in an iterative process of annotating behaviour change interventions evaluation reports, and consulting with expert stakeholders. It consisted of seven steps: 1) annotation of 110 intervention reports to develop a preliminary classification of modes of delivery; 2) open review from international experts (n=25); 3) second round of annotations with 55 reports to test inter-rater reliability and identify limitations; 4) second round of expert review feedback (n=16); 5) final round of testing of the refined ontology by two annotators familiar and two annotators unfamiliar with the ontology; 6) specification of ontological relationships between entities; and 7) transformation into a machine-readable format using the Web Ontology Language (OWL) language and publishing online. /
Results: The resulting ontology is a four-level hierarchical structure comprising 65 unique modes of delivery, organised by 15 upper-level classes: Informational, Environmental change, Somatic, Somatic alteration, Individual-based/ Pair-based /Group-based, Uni-directional/Interactional, Synchronous/ Asynchronous, Push/ Pull, Gamification, Arts feature. Relationships between entities consist of is_a. Inter-rater reliability of the Mode of Delivery Ontology for annotating intervention evaluation reports was a=0.80 (very good) for those familiar with the ontology and a= 0.58 (acceptable) for those unfamiliar with it. /
Conclusion: The ontology can be used for both annotating and writing behaviour change intervention evaluation reports in a consistent and coherent manner, thereby improving evidence comparison, synthesis, replication, and implementation of effective interventions
Delivering Behaviour Change Interventions: Development of a Mode of Delivery Ontology [version 2; peer review: 2 approved]
Background: Investigating and improving the effects of behaviour change interventions requires detailed and consistent specification of all aspects of interventions. An important feature of interventions is the way in which these are delivered, i.e. their mode of delivery. This paper describes an ontology for specifying the mode of delivery of interventions, which forms part of the Behaviour Change Intervention Ontology, currently being developed in the Wellcome Trust funded Human Behaviour-Change Project.
Methods: The Mode of Delivery Ontology was developed in an iterative process of annotating behaviour change interventions evaluation reports, and consulting with expert stakeholders. It consisted of seven steps: 1) annotation of 110 intervention reports to develop a preliminary classification of modes of delivery; 2) open review from international experts (n=25); 3) second round of annotations with 55 reports to test inter-rater reliability and identify limitations; 4) second round of expert review feedback (n=16); 5) final round of testing of the refined ontology by two annotators familiar and two annotators unfamiliar with the ontology; 6) specification of ontological relationships between entities; and 7) transformation into a machine-readable format using the Web Ontology Language (OWL) and publishing online.
Results: The resulting ontology is a four-level hierarchical structure comprising 65 unique modes of delivery, organised by 15 upper-level classes: Informational, Environmental change, Somatic, Somatic alteration, Individual-based/ Pair-based /Group-based, Uni-directional/Interactional, Synchronous/ Asynchronous, Push/ Pull, Gamification, Arts feature. Relationships between entities consist of is_a. Inter-rater reliability of the Mode of Delivery Ontology for annotating intervention evaluation reports was a=0.80 (very good) for those familiar with the ontology and a= 0.58 (acceptable) for those unfamiliar with it.
Conclusion: The ontology can be used for both annotating and writing behaviour change intervention evaluation reports in a consistent and coherent manner, thereby improving evidence comparison, synthesis, replication, and implementation of effective interventions
- …