97 research outputs found
Processing of AC-coupled n-in-p pixel detectors on MCz silicon using atomic layer deposited aluminium oxide
We report on the fabrication of capacitively (AC) coupled n(+)-in-p pixel detectors on magnetic Czochralski silicon substrates. In our devices, we employ a layer of aluminium oxide (Al2O3) grown by atomic layer deposition (ALD) as dielectric and field insulator, instead of the commonly used silicon dioxide (SiO2). As shown in earlier research, Al2O3 thin films exhibit high negative oxide charge, and can thus serve as a substitute for p-stop/p-spray insulation implants between pixels. In addition, they provide far higher capacitance densities than SiO2 due to their high dielectric constant, permitting more efficient capacitive coupling of pixels. Furthermore, metallic titanium nitride (TiN) bias resistors are presented as an alternative to punch-through or poly-Si resistors. Devices obtained by the above mentioned process are characterized by capacitance-voltage and current-voltage measurements, and by 2 MeV proton microprobe. Results show the expected high negative charge of the Al2O3 dielectric, uniform charge collection efficiency over large areas of pixels, and acceptable leakage current densities.Peer reviewe
Characterization of magnetic Czochralski silicon devices with aluminium oxide field insulator : effect of oxygen precursor on electrical properties and radiation hardness
Aluminium oxide (Al2O3) has been proposed as an alternative to thermal silicon dioxide (SiO2) as field insulator and surface passivation for silicon detectors, where it could substitute p-stop/p-spray insulation implants between pixels due to its negative oxide charge, and enable capacitive coupling of segments by means of its higher dielectric constant. Al2O3 is commonly grown by atomic layer deposition (ALD), which allows the deposition of thin layers with excellent precision. In this work, we report the electrical characterization of single pad detectors (diodes) and MOS capacitors fabricated on magnetic Czochralski silicon substrates and using Al2O3 as field insulator. Devices are studied by capacitance-voltage, current-voltage, and transient current technique measurements. We evaluate the influence of the oxygen precursors in the ALD process, as well as the effect of gamma irradiation, on the properties of these devices. We observe that leakage currents in diodes before the onset of breakdown are low for all studied ALD processes. Charge collection as measured by transient current technique (TCT) is also independent of the choice of oxygen precursor. The Al2O3 films deposited with O-3 possess a higher negative oxide charge than films deposited by H2O, However, in diodes a higher oxide charge is linked to earlier breakdown, as has been predicted by simulation studies. A combination of H2O and O-3 precursors results in a good compromise between the beneficial properties provided by the respective individual precursors.Peer reviewe
First measurement of elastic, inelastic and total cross-section at √s = 13TeV by TOTEM and overview of cross-section data at LHC energies : TOTEM Collaboration
The TOTEM collaboration has measured the proton- proton total cross section at v s = 13 TeV with a luminosity- independent method. Using dedicated ss * = 90m beam optics, the Roman Pots were inserted very close to the beam. The inelastic scattering rate has been measured by the T1 and T2 telescopes during the same LHC fill. After applying the optical theorem the total proton- proton cross section is stot = (110.6 +/- 3.4) mb, well in agreement with the extrapolation from lower energies. This method also allows one to derive the luminosity- independent elastic and inelastic cross sections: sel = (31.0 +/- 1.7) mband sinel = (79.5 +/- 1.8) mb.Peer reviewe
Odderon Exchange from Elastic Scattering Differences between pp and p(p)over-bar Data at 1.96 TeV and from pp Forward Scattering Measurements
We describe an analysis comparing the p (p) over bar elastic cross section as measured by the D0 Collaboration at a center-of-mass energy of 1.96 TeV to that in pp collisions as measured by the TOTEM Collaboration at 2.76, 7, 8, and 13 TeVusing a model-independent approach. The TOTEM cross sections, extrapolated to a center-of-mass energy of root s = 1.96 TeV, are compared with the D0 measurement in the region of the diffractive minimum and the second maximum of the pp cross section. The two data sets disagree at the 3.4s level and thus provide evidence for the t-channel exchange of a colorless, C-odd gluonic compound, also known as the odderon. We combine these results with a TOTEM analysis of the same C-odd exchange based on the total cross section and the ratio of the real to imaginary parts of the forward elastic strong interaction scattering amplitude in pp scattering for which the significance is between 3.4s and 4.6s. The combined significance is larger than 5 sigma and is interpreted as the first observation of the exchange of a colorless, C-odd gluonic compound.Peer reviewe
Diamond Detectors for the TOTEM Timing Upgrade
This paper describes the design and the performance of the timing detector
developed by the TOTEM Collaboration for the Roman Pots (RPs) to measure the
Time-Of-Flight (TOF) of the protons produced in central diffractive
interactions at the LHC. The measurement of the TOF of the protons allows the
determination of the longitudinal position of the proton interaction vertex and
its association with one of the vertices reconstructed by the CMS detectors.
The TOF detector is based on single crystal Chemical Vapor Deposition (scCVD)
diamond plates and is designed to measure the protons TOF with about 50 ps time
precision. This upgrade to the TOTEM apparatus will be used in the LHC run 2
and will tag the central diffractive events up to an interaction pileup of
about 1. A dedicated fast and low noise electronics for the signal
amplification has been developed. The digitization of the diamond signal is
performed by sampling the waveform. After introducing the physics studies that
will most profit from the addition of these new detectors, we discuss in detail
the optimization and the performance of the first TOF detector installed in the
LHC in November 2015.Comment: 26 pages, 18 figures, 2 tables, submitted for publication to JINS
Evidence for non-exponential elastic proton-proton differential cross-section at low |t| and sqrt(s) = 8 TeV by TOTEM
The TOTEM experiment has made a precise measurement of the elastic
proton-proton differential cross-section at the centre-of-mass energy sqrt(s) =
8 TeV based on a high-statistics data sample obtained with the beta* = 90
optics. Both the statistical and systematic uncertainties remain below 1%,
except for the t-independent contribution from the overall normalisation. This
unprecedented precision allows to exclude a purely exponential differential
cross-section in the range of four-momentum transfer squared 0.027 < |t| < 0.2
GeV^2 with a significance greater than 7 sigma. Two extended parametrisations,
with quadratic and cubic polynomials in the exponent, are shown to be well
compatible with the data. Using them for the differential cross-section
extrapolation to t = 0, and further applying the optical theorem, yields total
cross-section estimates of (101.5 +- 2.1) mb and (101.9 +- 2.1) mb,
respectively, in agreement with previous TOTEM measurements.Comment: Final version published in Nuclear Physics
Diamond detectors for the TOTEM timing upgrade
This paper describes the design and the performance of the timing detector developed by the TOTEM Collaboration for the Roman Pots (RPs) to measure the Time-Of-Flight (TOF) of the protons produced in central diffractive interactions at the LHC. The measurement of the TOF of the protons allows the determination of the longitudinal position of the proton interaction vertex and its association with one of the vertices reconstructed by the CMS detectors. The TOF detector is based on single crystal Chemical Vapor Deposition (scCVD) diamond plates and is designed to measure the protons TOF with about 50 ps time precision. This upgrade to the TOTEM apparatus will be used in the LHC run 2 and will tag the central diffractive events up to an interaction pileup of about 1. A dedicated fast and low noise electronics for the signal amplification has been developed. The digitization of the diamond signal is performed by sampling the waveform. After introducing the physics studies that will most profit from the addition of these new detectors, we discuss in detail the optimization and the performance of the first TOF detector installed in the LHC in November 2015.Peer reviewe
Measurement of elastic pp scattering at √ s = 8 TeV in the Coulomb-nuclear interference region : determination of the rho-parameter and the total cross-section
The TOTEM experiment at the CERN LHC has measured elastic proton-proton scattering at the centre-of-mass energy root s = 8 TeV and four-momentum transfers squared, vertical bar t vertical bar, from 6 x 10(-4) to 0.2GeV(2). Near the lower end of the t-interval the differential cross-section is sensitive to the interference between the hadronic and the electromagnetic scattering amplitudes. This article presents the elastic cross-section measurement and the constraints it imposes on the functional forms of the modulus and phase of the hadronic elastic amplitude. The data exclude the traditional Simplified West and Yennie interference formula that requires a constant phase and a purely exponential modulus of the hadronic amplitude. For parametrisations of the hadronic modulus with second-or third-order polynomials in the exponent, the data are compatible with hadronic phase functions giving either central or peripheral behaviour in the impact parameter picture of elastic scattering. In both cases, the.-parameter is found to be 0.12 +/- 0.03. The results for the total hadronic cross-section are sigma(tot) = (102.9 +/- 2.3) mb and (103.0 +/- 2.3) mb for central and peripheral phase formulations, respectively. Both are consistent with previous TOTEM measurements.Peer reviewe
First Search for Exclusive Diphoton Production at High Mass with Tagged Protons in Proton-Proton Collisions at root s=13 TeV
A search for exclusive two-photon production via photon exchange in proton-proton collisions, pp -> p gamma gamma p with intact protons, is presented. The data correspond to an integrated luminosity of 9.4 fb(-1) collected in 2016 using the CMS and TOTEM detectors at a center-of-mass energy of 13 TeVat the LHC. Events are selected with a diphoton invariant mass above 350 GeVand with both protons intact in the final state, to reduce backgrounds from strong interactions. The events of interest are those where the invariant mass and rapidity calculated from the momentum losses of the forward-moving protons match the mass and rapidity of the central, two-photon system. No events are found that satisfy this condition. Interpreting this result in an effective dimension-8 extension of the standard model, the first limits are set on the two anomalous four-photon coupling parameters. If the other parameter is constrained to its standard model value, the limits at 95% confidence level are vertical bar zeta(1)vertical bar < 2.9 x 10(-1)3 GeV-4 and vertical bar zeta(2)vertical bar < 6.0 x 10(-13) GeV-4.Peer reviewe
- …