Deformasi Gunung Kelud Pascapembentukan Kubah Lava November 2007

DOI: 10.17014/ijog.v5i1.90The eruption of Kelud Volcano in 2007 was started with an increase in the seismic activity on September 2007. It was ended with a lava dome formation inside the crater lake on 3 November 2007. This phenomenon showed the change of eruption behavior compared to the last eruption on February 1990 that was an explosive one. Result from the GPS observation method during three periods, which are: April, August, and October 2008 showed that the vector displacement on each measured point was affected dominantly by structural geology forces as a crustal stabilisation after the last phase of November 2007 eruption. There was also a minor displacement as the result of magma migration around the points that were close to the lava dome. The magma migration occurred in a relatively shallow depth and was associated with an aseismic zone. The deformation that occurred as a result of magma migration toward the surface was calculated to determine the magma supply and magma injected. The result then was compared to illustrate a mechanism of deformation during April – October 2008. The comparison of magma supply and magma injected within these periods showed that the inflation still occurred, but it was not supported by a surface manifestation. This inflation could be false because of data discontinuity, or it is actually a part of deflation trend

Simulation of sub-drains performance using visual MODFLOW for slope water seepage Problem

Numerical simulation technique was used for investigating water seepage problem at the Botanic Park Kuala Lumpur. A proposed sub-drains installation in problematic site location was simulated using Modular Three-Dimensional Finite Difference Groundwater Flow (MODFLOW) software. The results of simulation heads during transient condition showed that heads in between 43 m (water seepage occurred at level 2) until 45 m (water seepage occurred at level 4) which heads measurement are referred to mean sea level. However, elevations measurements for level 2 showed the values between 41 to 42 m from mean sea level and elevations for level 4 between 42 to 45 m from mean sea level. These results indicated an increase in heads for level 2 and level 4 between 1 to 2 m when compared to elevations slope at the level 2 and level 4. The head increases surpass the elevation level of the slope area that causing water seepage at level 2 and level 4. In order to overcome this problems, the heads level need to be decrease to 1 until 2 m by using two options of sub-drain dimension size. Sub-drain with the dimension of 0.0750 m (diameter), 0.10 m (length) and using 4.90 m spacing was the best method to use as it was able to decrease the heads to the required levels of 1 to 2 m

Loss Estimation of Protected Forest Damage and Its Impact on Fishery Sector in Goa Cina Beach, South Area of Malang Regency

Goa Cina is one of magnificent beach destinations in the South Area of Malang Regency which attracts local and foreign tourists. Generally, there are two kinds of tourism management namely ecoturism based and masstourism based. However, Goa Cina implements masstourism based management. Thus it needs an area to build tourism facilities and infrastructures. The ideal functions of protected forest had conversed into buildings such as parking lots, stalls, religious buildings, restrooms, etc. The damage of protected forest caused by its missing functions contributes to some losses. The aims of this research were to: 1) count the loss as the impact of protected forest conversion in Goa Cina which turned into tourism facilities and infrastructures; 2) analyze its impact on fishery production. The data were collected by conducting in-depth interview with the key informant and finding secondary data. The result indicated that the conversion of protected forest into tourism facilities and infrastructures caused ecological and economic loss and it needed massive ecological recovery. The fishery production also decreased due to sedimentation of saltwater. It is suggested that ecotourism should be considered for tourism development instead of masstourisnm

Simulation of sub-drains performance using visual MODFLOW for slope water seepage Problem

Numerical simulation technique was used for investigating water seepage problem at the Botanic Park Kuala Lumpur. A proposed sub-drains installation in problematic site location was simulated using Modular Three-Dimensional Finite Difference Groundwater Flow (MODFLOW) software. The results of simulation heads during transient condition showed that heads in between 43 m (water seepage occurred at level 2) until 45 m (water seepage occurred at level 4) which heads measurement are referred to mean sea level. However, elevations measurements for level 2 showed the values between 41 to 42 m from mean sea level and elevations for level 4 between 42 to 45 m from mean sea level. These results indicated an increase in heads for level 2 and level 4 between 1 to 2 m when compared to elevations slope at the level 2 and level 4. The head increases surpass the elevation level of the slope area that causing water seepage at level 2 and level 4. In order to overcome this problems, the heads level need to be decrease to 1 until 2 m by using two options of sub-drain dimension size. Sub-drain with the dimension of 0.0750 m (diameter), 0.10 m (length) and using 4.90 m spacing was the best method to use as it was able to decrease the heads to the required levels of 1 to 2 m

Síntesis de ésteres de acetato hexilo, mediante transesterificación química a partir de palma como base sintética de fluidos para sondeos

In the present study the synthesis of a palm based ethylhexyl ester was examined through a transesterification reaction of palm oil methyl ester (POME) with 2-ethylhexanol (EH). A sodium methoxide in methanol solution was used as a catalyst. The reaction was carried out at a fixed pressure of 1.5 mbar by varying the temperature (80–140 °C), POME/2EH molar ratio (1:1.5–1:2.2), reaction time (0.5–4 h) and catalyst concentration (1–2% w/w). The reaction with 2-ethylhexanol involved a single step reversible reaction, thus, the reaction was completed in a very short time. The optimum conditions were obtained in less than 30 minutes with 1.5 mbar pressure, 70 °C, and 1:2 molar ratio of POME to 2EH. The analysis of the final product (ethylhexyl ester) was performed using gas chromatography which exhibited 98% of ethyl hexyl ester yield. The gas chromatography analysis of ethyl hexyl ester revealed two major esters peaks i.e. ethyl hexyl palmitate and ethylhexyl oleate.En el presente estudio se analizó la síntesis de ésteres de acetato de hexilo de palma mediante reacción de transesterificación de los ésteres metílicos de aceite de palma (PME) con 2-etilhexanol (EH). Como catalizador se utiliza una solución de metóxido de sodio en metanol. La reacción se lleva a cabo a presión fija de 1,5 mbar mediante la variación de temperatura (80–140 °C), relación molar POME/2EH (1:1.5–1:2.2), tiempo de reacción (0,5–4 h) y concentración de catalizador (1–2% w / w). La reacción con 2-etilhexanol implica un solo paso de una reacción reversible, por lo tanto, ésta se completa en un tiempo muy corto. Las condiciones óptimas se obtuvieron en menos de 30 min a 1,5 mbar, 70 °C y una relación molar de 1:2 de POME al 2EH. El análisis del producto final se realizó usando cromatografía de gases que mostró un rendimiento del 98% del etilhexil éster. El análisis de la cromatografía de gases del etilhexil éster muestra dos grandes picos correspondientes a los ésteres palmitato y oleato de etilhexilo

Protection of the Rights of Women and Children in The Divorce Process through Psychologists Role in the Religious Court in Indonesia.

Women and children are part of a social community that guarantees their human security when dealing with the law, especially as victims of divorce. Several policies that the Supreme Court has issued as a form of human security for the rights of women and children in the religious court include Supreme Court Regulation (Perma) Number 3 of 2017 concerning Guidelines for Prosecuting Womens Cases Dealing with the Law and Perma Number 5 of 2019 concerning Guidelines for Adjudicating Marriage Dispensations. The problem of this study is how these two policies can provide security for psychologically fulfilling legal rights for women and children. Therefore, implementing these two policies must be supported by the psychologists role especially in religious courts. The aim to be achieved is to provide psychological support for women and children dealing with the law in the religious court. Thus, the method used to obtain data is a literature study with normative approach. The data were analyzed descriptively, and the results showed that the role of psychologists was indispensable in the religious court. The reason is that the psychological condition of women and children in legal proceedings is vulnerable to experiencing fear, insecurity, and slumping

Traceability in Digital Forensic Investigation Process

Digital forensic is part of forensic science that implicitly covers crime that is related to computer technology. In a cyber crime, digital evidence investigation requires a special procedures and techniques in order to be used and be accepted in court of law. Generally, the goals of these special processes are to identify the origin of the incident reported as well as maintaining the chain of custody so that the legal process can take its option. Subsequently, the traceability process has become a key or an important element of the digital investigation process, as it is capable to map the events of an incident from difference sources in obtaining evidence of an incident to be used for other auxiliary investigation aspects. Hence, this paper introduces a trace map model to illustrate the relationship in the digital forensic investigation process by adapting and integrating the traceability features. The objective of this integration is to provide the capability of trace and map the evidence to the sources and shows the link between the evidence, the entities and the sources involved in the process, particularly in the collection phase of digital forensic investigation framework. Additionally, the proposed model is expected to help the forensic investigator in obtaining accurate and complete evidence that can be further used in a court of law

Mapping on slope seepage problem using Electrical Resistivity Imaging (ERI)

The stability of slope may influenced by several factors such as its geomaterial properties, geometry and environmental factors. Problematic slope due to seepage phenomenon will influenced the slope strength thus promoting to its failure. In the past, slope seepage mapping suffer from several limitation due to cost, time and data coverage. Conventional engineering tools to detect or mapped the seepage on slope experienced those problems involving large and high elevation of slope design. As a result, this study introduced geophysical tools for slope seepage mapping based on electrical resistivity method. Two spread lines of electrical resistivity imaging were performed on the slope crest using ABEM SAS 4000 equipment. Data acquisition configuration was based on long and short arrangement, schlumberger array and 2.5 m of equal electrode spacing interval. Raw data obtained from data acquisition was analyzed using RES2DINV software. Both of the resistivity results show that the slope studied consists of three different anomalies representing top soil (200 – 1000 Ωm), perched water (10 – 100 Ωm) and hard/dry layer (> 200 Ωm). It was found that seepage problem on slope studied was derived from perched water zones with electrical resistivity value of 10 – 100 Ωm. Perched water zone has been detected at 6 m depth from the ground level with varying thickness at 5 m and over. Resistivity results have shown some good similarity output with reference to borehole data, geological map and site observation thus verified the resistivity results interpretation. Hence, this study has shown that the electrical resistivity imaging was applicable in slope seepage mapping which consider efficient in term of cost, time, data coverage and sustainability

Study of factors influencing construction delays at rural area in Malaysia

Construction is one of an important industry which contributes to the economic growth in Malaysia. However, it has been revealed that 79.5 percent and 66.7 percent of the public and private projects were not completed within the time specified in the contracts out of 359 projects in Malaysia. Therefore, the purpose of this study is to investigate the delay factor caused project delay at rural area. A 5-points Likert scale questionnaire survey were answered by 111 respondents which having experience with rural construction project. The questionnaire data were analysed by using Relative Importance Index (RII). Five top factors were determined from this study based on their RII values which are improper construction method implemented by contractor, weather condition, difficulties in providing delivery to site, breakdown of site equipment, and poor qualification of contractor’s technical staffs