Carbon emissions pinch analysis (CEPA) for emissions reduction in the New Zealand electricity sector

Carbon Emissions Pinch Analysis (CEPA) is a recent extension of traditional thermal and mass pinch analysis to the area of emissions targeting and planning on a macroscale (i.e. economy wide). This paper presents a carbon pinch analysis of the New Zealand electricity industry and illustrates some of the issues with realising meaningful emissions reductions. The current large proportion of renewable generation sources (~67% in 2007) complicates wholesale emissions reductions. The biggest growth in renewable generation is expected to come from geothermal energy followed by wind and hydro. A four fold increase in geothermal generation capacity is needed in addition to large amounts of new wind generation to reduce emissions to around 1990 levels and also meet projected demand. The expected expansion of geothermal generation in New Zealand raises issues of GHG emissions from the geothermal fields. The emissions factors between fields can vary by almost two orders of magnitude making predictions of total emissions highly site specific

Non-continuous and variable rate processes: Optimisation for energy use

The need to develop new and improved ways of reducing energy use and increasing energy intensity in industrial processes is currently a major issue in New Zealand. Little attention has been given to optimisation of non-continuous processes in the past, due to their complexity, yet they remain an essential and often energy intensive component of many industrial sites. Novel models based on pinch analysis that aid in minimising utility usage have been constructed here through the adaptation of proven continuous techniques. The knowledge has been integrated into a user friendly software package, and allows the optimisation of processes under variable operating rates and batch conditions. An example problem demonstrates the improvements in energy use that can be gained when using these techniques to analyse non-continuous data. A comparison with results achieved using a pseudo-continuous method show that the method described can provide simultaneous reductions in capital and operating costs

Vacuum production of OTFTs by vapour jet deposition of dinaphtho[2,3-b:2′,3′-f]thieno[3,2-b]thiophene (DNTT) on a lauryl acrylate functionalised dielectric surface

Roll-to-roll (R2R) production of organic transistors and circuits require patterned deposition of organic layers at high deposition rate. Here we demonstrate a vapour-jet process for the rapid deposition of the organic semiconductor dinaphtho[2,3-b:2',3'-f]thieno[3,2-b]thiophene (DNTT). The deposition rate achieved, equivalent to ~200 nm/s onto a stationary substrate, was several orders of magnitude faster than ordinary thermal evaporation. Nevertheless, transistor yield was 100% with an average mobility of 0.4 cm2/Vs in a single pass deposition onto a substrate moving at 0.15 m/min. We also demonstrate a vacuum, high rate R2R-compatible process for surfacefunctionalising a gate dielectric layer with lauryl acrylate which enabled an all-vacuum route to the fabrication of a five-stage ring oscillator

Stable organic static random access memory from a roll-to-roll compatible vacuum evaporation process

An organic Static Random Access Memory (SRAM) based on p-type, six-transistor cells is demonstrated. The bottom-gate top-contact thin film transistors composing the memory were fabricated on flexible polyethylene naphthalate substrates. All metallization layers and the p-type semiconductor dinaphtho[2,3-b:2',3'-f] thieno[3,2-b]thiophene were deposited by thermal evaporation. The gate dielectric was deposited in a vacuum roll-to-roll environment at a web speed of 25 m/min by flash-evaporation and subsequent plasma polymerisation of tripropyleneglycol diacrylate (TPGDA). Buffering the TPGDA with a polystyrene layer yields hysteresis-free transistor characteristics with turn-on voltage close to zero. The static transfer characteristic of diode-connected load inverters were also hysteresis-free with maximum gain >2 and noise margin ∼2.5 V. When incorporated into SRAM cells the time-constant for writing data into individual SRAM cells was less than 0.4 ms. Little change occurred in the magnitude of the stored voltages, when the SRAM was powered continuously from a −40 V rail for over 27 h testifying to the electrical stability of the threshold voltage of the individual transistors. Unencapsulated SRAM cells measured two months after fabrication showed no significant degradation after storage in a clear plastic container in normal laboratory ambient

Organic Digital Logic and Analog Circuits Fabricated in a Roll-to-Roll Compatible Vacuum-Evaporation Process

We report the fabrication of a range of organic circuits produced by a high-yielding, vacuum-based process compatible with roll-to-roll production. The circuits include inverters, NAND and NOR logic gates, a simple memory element (set-reset latch), and a modified Wilson current mirror circuit. The measured circuit responses are presented together with simulated responses based on a previously reported transistor model of organic transistors produced using our fabrication process. Circuit simulations replicated all the key features of the experimentally observed circuit performance. The logic gates were capable of operating at frequencies in excess of 1 kHz while the current mirror circuit produced currents up to 18 μA

A high-yield vacuum-evaporation-based R2R-compatible fabrication route for organic electronic circuits

Advances are described in a vacuum-evaporation-based approach for the roll-to-roll (R2R) production of organic thin film transistors (TFTs) and circuits. Results from 90-transistor arrays formed directly onto a plasma-polymerised diacrylate gate dielectric are compared with those formed on polystyrene-buffered diacrylate. The latter approach resulted in stable, reproducible transistors with yields in excess of 90%. The resulting TFTs had low turn-on voltage, on-off ratios ∼106 and mobility ∼1 cm2/V s in the linear regime, as expected for dinaphtho[2,3-b: 2′,3′-f] thieno[3,2-b]thiophene the air stable small molecule used as the active semiconductor. We show that when device design is constrained by the generally poor registration ability of R2R processes, parasitic source-drain currents can lead to a >50% increase in the mobility extracted from the resulting TFTs, the increases being especially marked in low channel width devices. Batches of 27 saturated-load inverters were fabricated with 100% yield and their behaviour successfully reproduced using TFT parameters extracted with Silvaco's UOTFT Model. 5- and 7-stage ring oscillator (RO) outputs ranged from ∼120 Hz to >2 kHz with rail voltages, VDD, increasing from -15 V to -90 V. From simulations an order of magnitude increase in frequency could be expected by reducing parasitic gate capacitances. During 8 h of continuous operation at VDD = -60 V, the frequency of a 7-stage RO remained almost constant at ∼1.4 kHz albeit that the output signal amplitude decreased from ∼22 V to ∼10 V. Over the next 30 days of intermittent operation further degradation in performance occurred although an unused RO showed no deterioration over the same period. © 2014 The Authors. Published by Elsevier B.V

Subfactors of index less than 5, part 1: the principal graph odometer

In this series of papers we show that there are exactly ten subfactors, other than $A_\infty$ subfactors, of index between 4 and 5. Previously this classification was known up to index $3+\sqrt{3}$. In the first paper we give an analogue of Haagerup's initial classification of subfactors of index less than $3+\sqrt{3}$, showing that any subfactor of index less than 5 must appear in one of a large list of families. These families will be considered separately in the three subsequent papers in this series.Comment: 36 pages (updated to reflect that the classification is now complete

Association of Early Norepinephrine Administration With 24-Hour Mortality Among Patients With Blunt Trauma and Hemorrhagic Shock.

Hemorrhagic shock is a common cause of preventable death after injury. Vasopressor administration for patients with blunt trauma and hemorrhagic shock is often discouraged. To evaluate the association of early norepinephrine administration with 24-hour mortality among patients with blunt trauma and hemorrhagic shock. This retrospective, multicenter, observational cohort study used data from 3 registries in the US and France on all consecutive patients with blunt trauma from January 1, 2013, to December 31, 2018. Patients were alive on admission with hemorrhagic shock, defined by prehospital or admission systolic blood pressure less than 100 mm Hg and evidence of hemorrhage (ie, prehospital or resuscitation room transfusion of packed red blood cells, receipt of emergency treatment for hemorrhage control, transfusion of >10 units of packed red blood cells in the first 24 hours, or death from hemorrhage). Blunt trauma was defined as any exposure to nonpenetrating kinetic energy, collision, or deceleration. Statistical analysis was performed from January 15, 2021, to February 22, 2022. Continuous administration of norepinephrine in the prehospital environment or resuscitation room prior to hemorrhage control, according to European guidelines. The primary outcome was 24-hour mortality, and the secondary outcome was in-hospital mortality. The average treatment effect (ATE) of early norepinephrine administration on 24-hour mortality was estimated according to the Rubin causal model. Inverse propensity score weighting and the doubly robust approach with 5 distinct analytical strategies were used to determine the ATE. A total of 52 568 patients were screened for inclusion, and 2164 patients (1508 men [70%]; mean [SD] age, 46 [19] years; median Injury Severity Score, 29 [IQR, 17-36]) presented with acute hemorrhage and were included. A total of 1497 patients (69.1%) required emergency hemorrhage control, 128 (5.9%) received a prehospital transfusion of packed red blood cells, and 543 (25.0%) received a massive transfusion. Norepinephrine was administered to 1498 patients (69.2%). The 24-hour mortality rate was 17.8% (385 of 2164), and the in-hospital mortality rate was 35.6% (770 of 2164). None of the 5 analytical strategies suggested any statistically significant association between norepinephrine administration and 24-hour mortality, with ATEs ranging from -4.6 (95% CI, -11.9 to 2.7) to 2.1 (95% CI, -2.1 to 6.3), or between norepinephrine administration and in-hospital mortality, with ATEs ranging from -1.3 (95% CI, -9.5 to 6.9) to 5.3 (95% CI, -2.1 to 12.8). The findings of this study suggest that early norepinephrine infusion was not associated with 24-hour or in-hospital mortality among patients with blunt trauma and hemorrhagic shock. Randomized clinical trials that study the effect of early norepinephrine administration among patients with trauma and hypotension are warranted to further assess whether norepinephrine is safe for patients with hemorrhagic shock

Isospin-Violating Meson-Nucleon Vertices as an Alternate Mechanism of Charge-Symmetry Breaking

We compute isospin-violating meson-nucleon coupling constants and their consequent charge-symmetry-breaking nucleon-nucleon potentials. The couplings result from evaluating matrix elements of quark currents between nucleon states in a nonrelativistic constituent quark model; the isospin violations arise from the difference in the up and down constituent quark masses. We find, in particular, that isospin violation in the omega-meson--nucleon vertex dominates the class IV CSB potential obtained from these considerations. We evaluate the resulting spin-singlet--triplet mixing angles, the quantities germane to the difference of neutron and proton analyzing powers measured in elastic $\vec{n}-\vec{p}$ scattering, and find them commensurate to those computed originally using the on-shell value of the $\rho$-$\omega$ mixing amplitude. The use of the on-shell $\rho$-$\omega$ mixing amplitude at $q^2=0$ has been called into question; rather, the amplitude is zero in a wide class of models. Our model possesses no contribution from $\rho$-$\omega$ mixing at $q^2=0$, and we find that omega-meson exchange suffices to explain the measured $n-p$ analyzing power difference~at~183 MeV.Comment: 20 pages, revtex, 3 uuencoded PostScript figure