19,527 research outputs found
Computer method for identification of boiler transfer functions
Iterative computer aided procedure was developed which provides for identification of boiler transfer functions using frequency response data. Method uses frequency response data to obtain satisfactory transfer function for both high and low vapor exit quality data
Verification of an acoustic transmission matrix analysis of sound propagation in a variable area duct without flow
A predicted standing wave pressure and phase angle profile for a hard wall rectangular duct with a region of converging-diverging area variation is compared to published experimental measurements in a study of sound propagation without flow. The factor of 1/2 area variation used is sufficient magnitude to produce large reflections. The prediction is based on a transmission matrix approach developed for the analysis of sound propagation in a variable area duct with and without flow. The agreement between the measured and predicted results is shown to be excellent
Spatially growing disturbances in a high velocity ratio two-stream, coplanar jet
The influence of cold and heated secondary flow on the instability of a two-stream, coplanar jet having a 0.7 Mach number heated primary jet for a nominal fan to primary velocity ratio of 0.68 was investigated by means of inviscid linearized stability theory. The instability properties of spatially growing axisymmetric and first order azimuthal disturbances were studied. The instability characteristics of the two-stream jet with a velocity ratio of 0.68 are very different from those of a single stream jet, and a two-stream, coplanar jet having a 0.9 Mach number heated primary jet and a cold secondary jet for a fan to primary velocity ratio of 0.30. For X/D = 1 and in comparison to the case where the velocity ratio was 0.3, the presence of the fan stream with a velocity ratio of 0.68 enhanced the instability of the jet and increased the unstable frequency range. However, the axisymmetric mode (m = 0) and the first order azimuthal mode (m = 1) have similar spatial growth rates where the velocity ratio is 0.68 while for a velocity ratio of 0.3 the growth rate of the first order azimuthal mode (m = 1) is greater. Comparing the cold and hot secondary flow results showed that for a velocity ratio of 0.68 the growth rate is greater for cold
Spatially growing disturbances in a two-stream, coplanar jet
The influence of the outer stream on the instability of a two-stream, coplanar jet with only the primary (central) stream heated for a nominal outer-to-primary velocity ratio of 0.3 was investigated by means of inviscid linearized stability theory. The instability properties of spatially growing axisymmetric and first order azimuthal disturbances were studied. It was found that the instability characteristics of the two stream jet are very different from those of a single stream jet. The presence of the outer stream enhanced the instability of the jet and increased the unstable frequency range for the first order azimuthal mode
Pressure transfer function of a JT15D nozzle due to acoustic and convected entropy fluctuations
An acoustic transmission matrix analysis of sound propagation in a variable area duct with and without flow is extended to include convected entropy fluctuations. The boundary conditions used in the analysis are a transfer function relating entropy and pressure at the nozzle inlet and the nozzle exit impedance. The nozzle pressure transfer function calculated is compared with JT15D turbofan engine nozzle data. The one dimensional theory for sound propagation in a variable area nozzle with flow but without convected entropy is good at the low engine speeds where the nozzle exit Mach number is low (M=0.2) and the duct exit impedance model is good. The effect of convected entropy appears to be so negligible that it is obscured by the inaccuracy of the nozzle exit impedance model, the lack of information on the magnitude of the convected entropy and its phase relationship with the pressure, and the scatter in the data. An improved duct exit impedance model is required at the higher engine speeds where the nozzle exit Mach number is high (M=0.56) and at low frequencies (below 120 Hz)
Analysis of ground reflection of jet noise obtained with various microphone arrays over an asphalt surface
Ground reflection effects on the propagation of jet noise over an asphalt surface are discussed for data obtained using a 33.02-cm diameter nozzle with microphones at several heights and distances from the nozzle axis. Ground reflection effects are analyzed using the concept of a reflected signal transfer function which represents the influence of both the reflecting surface and the atmosphere on the propagation of the reflected signal in a mathematical model. The mathematical model used as a basis for the computer program was successful in significantly reducing the ground reflection effects. The range of values of the single complex number used to define the reflected signal transfer function was larger than expected when determined only by the asphalt surface. This may indicate that the atmosphere is affecting the propagation of the reflected signal more than the asphalt surface. The selective placement of the reinforcements and cancellations in the design of an experiment to minimize ground reflection effects is also discussed
Acoustic transmission matrix of a variable area duct or nozzle carrying a compressible subsonic flow
The differential equations governing the propagation of sound in a variable area duct or nozzle carrying a one dimensional subsonic compressible fluid flow are derived and put in state variable form using acoustic pressure and particle velocity as the state variables. The duct or nozzle is divided into a number of regions. The region size is selected so that in each region the Mach number can be assumed constant and the area variation can be approximated by an exponential area variation. Consequently, the state variable equation in each region has constant coefficients. The transmission matrix for each region is obtained by solving the constant coefficient acoustic state variable differential equation. The transmission matrix for the duct or nozzle is the product of the individual transmission matrices of each region. Solutions are presented for several geometries with and without mean flow
Structural perfection in poorly lattice matched heterostructures
Continuum elastic theory is applied to the formation of misfit dislocations and point defects in strained layer structures. Explicit calculations of the energies of misfit dislocations in the double‐ and single‐kink geometries yield line tensions below which strained films are stable with respect to defect formation. Our results yield a mismatch‐dependent stability limit which, in the double kink case, differs from the Matthews–Blakeslee model by a geometrical factor and by the addition of a stress term associated with climb of the misfit dislocation. While our calculations yield equilibrium stability limits which may not correspond to observed critical thicknesses, the calculated stresses may be applied to descriptions of the kinetics of strain relief in films grown beyond these limits. Last, calculations of strain‐related contributions to the free energy of formation of point defects suggest a contribution │ΔG_(strain)│ ≃0.25 eV for a 5% lattice mismatch. This suggests a means of suppressing or enhancing the formation of vacancies or interstitials in semiconductors favoring these defects
- …