51,339 research outputs found
Development of an analytical technique for the optimization of jet engine and duct acoustic liners
A special integral representation of the external solutions of the Helmholtz equation is described. The analytical technique developed for the generation of the optimum acoustic admittance for an arbitrary axisymmetric body is also presented along with some numerical procedures and some preliminary results for a straight duct
Development of an analytical technique for the optimization of jet engine and duct acoustic liners
A new method was developed for the calculation of optimum constant admittance solutions for the minimization of the sound radiated from an arbitrary axisymmetric body. This method utilizes both the integral equation technique used in the calculation of the optimum non-constant admittance liners and the independent solution generated as a by product of these calculations. The results generated by both these methods are presented for three duct geometries: (1) a straight duct; (2) the QCSEE inlet; and (3) the QCSEE inlet less its centerbody
Two-temperature coronal flow above a thin disk
We extended the disk corona model (Meyer & Meyer-Hofmeister 1994; Meyer, Liu,
& Meyer-Hofmeister 2000a) to the inner region of galactic nuclei by including
different temperatures in ions and electrons as well as Compton cooling. We
found that the mass evaporation rate and hence the fraction of accretion energy
released in the corona depend strongly on the rate of incoming mass flow from
outer edge of the disk, a larger rate leading to more Compton cooling, less
efficient evaporation and a weaker corona. We also found a strong dependence on
the viscosity, higher viscosity leading to an enhanced mass flow in the corona
and therefore more evaporation of gas from the disk below. If we take accretion
rates in units of the Eddington rate our results become independent on the mass
of the central black hole. The model predicts weaker contributions to the hard
X-rays for objects with higher accretion rate like narrow-line Seyfert 1
galaxies (NLS1s), in agreement with observations. For luminous active galactic
nuclei (AGN) strong Compton cooling in the innermost corona is so efficient
that a large amount of additional heating is required to maintain the corona
above the thin disk.Comment: 17 pages, 6 figures. ApJ accepte
Influence of Different Material Models on the Result of Numerical High Speed Cutting Simulations
Extreme conditions for the workpiece and the tool can occur in high speed cutting processes. Temperatures above 1000 °C at very high strains over 3 and strain rates near 105 1/s are not unusual. In the first part of this paper an overview about the well known and new developed testing methods for these extreme conditions is given. For numerical simulations it is necessary to formulate closed material models which include strain, strain rate, and the temperature. In the second part some well known material models are presented and compared. Furthermore, advantages and disadvantages are named. The flow stress behaviour of two types of steel (1.1191, 1.2311) as a function of strain rate and temperature is presented. A Johnson-Cook and a Zerilli-Armstrong model is used for the comparative numerical simulations of an orthogonal cutting process. To indicate the process of chip segmentation, a damage model is often used. The influence of various damage models with different damage parameters and failure modes is shown. The calculated cutting forces and the shape of the chips are compared with results determined at a quickstop cutting device with integrated force measurement. Additionally, the calculated chip formation is compared with the measured shape by means of highspeed photography. The temperatures, forces, and chip shape for both used models are presented and the influence of different material models are evaluated and named
Physical Purification of Quantum States
We introduce the concept of a physical process that purifies a mixed quantum
state, taken from a set of states, and investigate the conditions under which
such a purification map exists. Here, a purification of a mixed quantum state
is a pure state in a higher-dimensional Hilbert space, the reduced density
matrix of which is identical to the original state. We characterize all sets of
mixed quantum states, for which perfect purification is possible. Surprisingly,
some sets of two non-commuting states are among them. Furthermore, we
investigate the possibility of performing an imperfect purification.Comment: 5 pages, 1 figure; published versio
Spin correlations in pion production near threshold
A first measurement of longitudinal as well as transverse spin correlation
coefficients for the reaction was made using a
polarized proton target and a polarized proton beam. We report kinematically
complete measurements for this reaction at 325, 350, 375 and 400 MeV beam
energy. The spin correlation coefficients and the analyzing power as well as angular
distributions for and the polarization observables
were extracted. Partial wave cross sections for dominant
transition channels were obtained from a partial wave analysis that included
the transitions with final state angular momenta of . The measurements
of the polarization observables are compared
with the predictions from the J\"ulich meson exchange model. The agreement is
very good at 325 MeV, but it deteriorates increasingly for the higher energies.
At all energies agreement with the model is better than for the reaction
.Comment: Preprint, 21 pp, submitted to Phys. Rev. C. Keywords: Mesons,
Polarization, Spin Correlations, Few body system
Radioactive Probes of the Supernova-Contaminated Solar Nebula: Evidence that the Sun was Born in a Cluster
We construct a simple model for radioisotopic enrichment of the protosolar
nebula by injection from a nearby supernova, based on the inverse square law
for ejecta dispersion. We find that the presolar radioisotopes abundances
(i.e., in solar masses) demand a nearby supernova: its distance can be no
larger than 66 times the size of the protosolar nebula, at a 90% confidence
level, assuming 1 solar mass of protosolar material. The relevant size of the
nebula depends on its state of evolution at the time of radioactivity
injection. In one scenario, a collection of low-mass stars, including our sun,
formed in a group or cluster with an intermediate- to high-mass star that ended
its life as a supernova while our sun was still a protostar, a starless core,
or perhaps a diffuse cloud. Using recent observations of protostars to estimate
the size of the protosolar nebula constrains the distance of the supernova at
0.02 to 1.6 pc. The supernova distance limit is consistent with the scales of
low-mass stars formation around one or more massive stars, but it is closer
than expected were the sun formed in an isolated, solitary state. Consequently,
if any presolar radioactivities originated via supernova injection, we must
conclude that our sun was a member of such a group or cluster that has since
dispersed, and thus that solar system formation should be understood in this
context. In addition, we show that the timescale from explosion to the creation
of small bodies was on the order of 1.8 Myr (formal 90% confidence range of 0
to 2.2 Myr), and thus the temporal choreography from supernova ejecta to
meteorites is important. Finally, we can not distinguish between progenitor
masses from 15 to 25 solar masses in the nucleosynthesis models; however, the
20 solar mass model is somewhat preferred.Comment: ApJ accepted, 19 pages, 3 figure
Brief Studies
Professor Gordon Rupp: The Optimism of Grace
Toward Lutheran Unit
Measurement of Partial-Wave Contributions in pp --> pp pi^0
We report a measurement of the spin-dependent total cross section ratios
delta_sigma_T/sigma_tot and delta_sigma_L/sigma_tot of the pp --> pp pi^0
reaction between 325 MeV and 400 MeV. The experiment was carried out with a
polarized internal target in a storage ring. Non-vertical beam polarization was
obtained by the use of solenoidal spin rotators. Near threshold, the knowledge
of both spin-dependent total cross sections is sufficient to deduce the
strength of certain participating partial waves, free of any model.Comment: 6 pages, 4 figure
- âŠ